[DarkNinja52]

Pictures of Diode Installation, it's pretty straight forward once you get under the dash, which is also very simple. I HIGHLY suggest anyone that wants to do this, to order the diode provided in the link in the OP.

You need splicing equipment/soldering tools.

From left to right and then dowards..
1.Location where ground wire will be grounded.

2. Diode and wires from link in OP.

3.Wire used for grounding (black wire).

4. Crimp a ring connector to one end of the black wire (ground wire).

5. Take the turn signal bulb out from it's hole in the dash, it has a green and gray wire. (top middle hole in picture)

6. Cut the green and gray wires with enough slack to solder.

7. Solder the black (ground wire) to the gray wire on the back of the bulb. Solder the blue wire to green wire on the back of bulb.

8. Solder one red wire to the green wire that you disconnected from the bulb. Solder the other red wire to the gray wire that you disconnected from the bulb.

9. Plug the bulb back into the back of the dash with the blue and black wires now soldered on.

10. Unscrew the screw in the first picture and then screw back together with the black wire with the ring connector, IN ADDITION to the black and yellow wire that was just unscrewed.

11. Check your red wires are correct.

12. Check your black and blue wires are correct.