Right, sorry about the delay, had to make an unscheduled trip to the Hospital.
I have uploaded the main pics I took for this in my photo album here:
http://www.ninjette.org/forums/album.php?albumid=29
As I have said, I used the riser that the stock bulbs come with as seen here:
I pulled it off the bulb, you will need to be careful as the metal lip on the bulb is sharp
The metal prongs just come out if met with a hammer
I had to use a file to cut the riser down as I didn't have anything better suited, this allows the part of the HID bulb that is heatshrunk to get through, the cut in the wall it to allow the wires to get through.
This is what it looks like on the HID bulbs:
Then just clamp it in using the spring as normal:
I often ride in the rain, and thought with cutting the rubber seals to allow the rubber seals that came with the HIDs to fit in, this will possibly allow water in, so I got some silicon sealant, with the thoughts that it will bond the two rubbers together, provide a water tight seal and be easier than glue to come off if need be.
It is as simple as that.
(these are only the parts that I have done differently to Sam, otherwise I used his DIY to install them
)