[ecotrons]

Hi, Guys,
Look at below the new part from Ecotrons for this EFI kit: tank valve.
It shall replace the stock Petcock simply.
(we will add a piece of tube on the inside of the valve, for the return line, so it's a littel higher than the feed line)

NO MORE HOLE-DRILLING on the fuel tank!

As somebody mentioned, this was a pretty much a "tank project". Now it's not anymore. It is now a pretty much an O2 sensor bung-welding project. Meaning, the major installation work is now to drill 2 holes on the exhaust and weld bungs. The rest of the kit is pretty much PNP.

We, ecotrons, have gain a lot of help and suggestions from this forum, thank you all for the efforts to make this kit PNP.

Matt from Ecotrons