- Strange choke issue?
- Gas cap screw profile/specifications
- stupid fricken too big airbox help
- Will Newgen crankshaft fit in my pregen?
- Help with bike ID
- Finally hit the highway, need help
- Clunking while accelerating
- Where will I post now?
- 99' ninja wont crank
- 2006 Ninja EX250-F won't start need help!
- Question for Replacement
- Loss of Power, Won't go past 7k RPM
- What do you guys clean your pod filters with?
- Ninja 250 engine won't start.
- No Crank
- Clutch handle went limp!
- Has anyone ever...
- Muzzy Exhaust Bites the Dust!
- Broke spark plug boot somehow.
- turn signal tail light mod help plz
- Engine Oil
- Stock air box won't go back on...
- Anyone know what size bolt goes on here?
- stock ex250 wiring harness ghetto rigged?
- Broke Down
- Stock exhaust temp
- Idle a little jumpy.
- 2005 carb leaking
- Rough Idle
- Rear pads wearing very unevenly
- I think I've had enough of this bike. (tech/G.I.)
- Fork oil weight/spring rate
- Purchase help
- Beginning Of A Project
- "Reduced Head" Flange Bolts?
- Pirelli, Shinko or Kenda
- New Guy, New Bike- Drivetrain issue
- Tips for removing glued-on grips
- Bike doesn't need choke on start up
- Looking For Advice On Potential Purchase
- Gasoline defying gravity
- Bike will die after idling and doesn't want to start again
- Bike is running lean
- Clip ons and suspension geometry
- 2005 ninja 250 vacuum leak/clog?
- ecotrons tech questions.
- 2004 will not rev over 4-5k, bogs down, not rideable
- Jetting help
- Faired vs Unfaired Performance
- 1986 ninja 250 clutch cable
- Speedometer / Cable issue?
- Abrupt halt to engine cranking (impact)
- 3rd gen (88-07) front wheel fender on 2nd gen ninja (86-87)
- Removing airbox question
- Couple of Concerns
- clutch cable replacement
- Not running Ninja 250
- Ex250e / gpx250r ii. ????
- Choke cable doesn't hold on older pregen Ninja? Solution with pictures
- Kawi Click or something else?
- What grade are the clutch spring bolts?
- adjusting jets on carb
- oil in air box
- HELP!! Carb Issues!!
- Clutch Problems
- Do I need a new clutch cover?
- Pirelli Diablo Scooter Rubber ordered!
- 2007 Float Bowl Adjustment
- Installing OEM Tail Light Lens
- ZZR250 gear and rear brake levers
- Gday new here, bike idles down very slow!
- High-beam out, replace bulb? Model?
- Bought New Tires!
- No Turnover Even with Jump
- Any improved rear wheel adjusters?
- High Idle problems with my first bike
- Bay area shop recommendations?
- Yoshimura Exhaust on 07 Ninja?
- Picked Up an '03 250. What Does this do?
- Why does this Ninjette turn so weirdly?
- Deep Clean YOUR Calipers!!
- Offset gas cap?
- Pregen Harness to track Harness... miss the track
- How do these muffler gaskets work?
- Pre-gen Track Prep Questions
- Odd rotor wear
- Recent buy really bad gas mileage
- Only runs on reserve
- Several Issues with 2007 Ninja
- Very Strange Leak
- I need to fit a 160 rear on....
- Help crank but no spark
- 04 ninja 250r bogs down and loses power
- Overcooling/ defective temp gauge?
- Rejetting for Altitude
- High idle issue
- PreGen Fork Spring Rate Chart
- IS IT WORTH IT?! project bike
- 06 Ninja damaged pilot jet seats?
- Safety Switches
- (Not so) Good Vibrations.. gearing change?
- Damage from loose cam chain?
- Woken from a coma. Dies with ANY throttle.
- tank drain hose replacement size?
- Turn Signals Crazy After Fender Delete
- California Emissions Hose Routing?
- Do new gen foot pegs fit on pregen?
- Valve clearance adjustment problem
- self cancelling turn signals
- ZZR250 vs 08-12 Ninja 250?
- '07 250R not running right
- Signal minder sm-3
- Trouble starting
- Ninja 250 throttle issue
- 2003 250EX lowering
- Lost carb part, need to find replacement
- Installing camshafts and timing chain guides
- 2006 EX250 barn find restoration thread
- More carb questions?
- Brake and Clutch Lever Compatibility
- 2003 ZZR EX250-H Brakes
- Newgen motor in a Pregen Frame - Thoughts?
- Leaky petcock question
- Sleeper
- Hmm, damper anybody?
- Wondering if something is normal with the shifter.
- Gas Cap Vent Issue?!
- Interesting Coolant use/oil weeping
- Measurements for tabs on side panels
- What lube should a use for the choke slide?
- Is this a bad starter relay, or worse?
- FrankenBike Idea
- bike died on the road home
- mystery part hanging from my engine
- Rear Suspension Lock Up??
- Buying '99 250, tips/help for parts/maintenance
- Muffler mounting
- Throttle bogging
- Bought '99 ninja 250 Needs some TLC (Video & Pics). Help wanted :P
- Front master cylinder questions
- Misfiring at low revs
- Adjusting the headlight?
- Starting Issues
- Just bought a Ninjette!
- are pre gen linkage bolts 12mm?
- Low Oil Causing Loss of Power
- Help me not concede defeat...please!
- 06 Ninjette with shifting issues?
- Gas tank leaking from underneath
- Runs lean?
- Minimalist wiring
- Still got this oil leak!!
- Fork Springs
- Adjusting chain.
- Head Gasket or Coolant Pipe Leak
- Oil Change
- Exhaust
- Anyone know what (if anything) connects to this?
- Changing clutch plates
- vacuum valve location?
- Another Jetting/Carb Question
- EX500 wheels?
- Engine advice
- Hey everybody I'm back, just rebuilt another engine won't stay running
- Do Pods actually make more power?
- Starter turns but engine doesn't catch (also new & old horn not working?)
- where to source side panel grommets
- Exhaust leak first few minutes of a rainstorm
- Rear shock bush on zzr250
- Clutch slipping partially due to oil change??
- Help diagnosing metallic sound
- 2005 Ninja 250 won't do anything but idle
- Tire Fitment Questions
- Any experience with the "Seal Mate" tool???
- Old rider looking at Ninjettes
- Issue with 2005 ninja 250r not starting
- Bike stalls, rattles, and won't idle properly
- 2002 Ninja 250 won't start after being dropped. Please help.
- 06 Ninja - Carb vacuum leak...
- Help me get riding! Idle/Rev issue...
- Snorkle mod idle question
- Unknown O-ring origins
- Time for a new rotor? New brake pads? Both?
- Would like some thoughts on a tick
- 1000 RPM idle too low ?
- 06 250r stalls and wont accelerate
- DIY oil pressure light
- Sounds like a blender with some small pebbles while decellerating
- Front vs Rear Turn Signals
- New 250 owner. Idle hangs at 4,000 rpms. Carb issue?
- Kawasaki ZX Ignition Coil Pack/ coil over plugs (CoPs) modification.
- something is leaking... help
- Not starting after jet kit installed
- possessed, devilspawn ninja
- pregen ninja 250 integrated tail lights
- DRL mod failure
- Help 05 ninja 250 several problems.
- Newish engine, now with more smoke and no idles!
- New rider and 250 owner - won't start!
- Changing fork oil - Video.
- Gas vent hose for carburetor
- bike wont start with clutch pulled in
- Worn Clutch?
- Continuation of old guy/new pregen saga
- Idiot connects positive to negative, and vice versa
- Any one here MN? Need help
- Airbox meets bandsaw...
- 04 Ninja 250 oil leak onto lower cowl.
- Adjustable Levers
- Flame Decals
- Help me diagnose this clunking...video inside.
- [Solved] Starter issues Ninja 250 (2007)
- Rubbing Brake Pads = Clean Brakes?
- Are Shortys Possible??
- When did you adjust your valves? was it necessary?
- Ninja 250 no neutral light, goes into gear, won't move
- Over torqued valve cover bolts, snapped in half
- Checking my understanding...
- Crank no start
- Starter Clutches, Wet or Dry?
- Another Troubled Engine thread.
- Ninja 250 idles fine idle increases drastically as it warms up
- ID This Pin!
- Tail light issues
- Ninja 250r not getting any power
- Help with my EX250?
- A Stripped Oil Pan.
- Ride height/ Rear Shock question
- Question regarding compatible parts...
- Choke Cable Relocation/shortening?
- Strange problem with bike starting
- Rough idle and a couple of misfires
- Winter Options
- Short handlebar risers/spacer
- Gasket Thickness Valve Clearance
- Timing Adjustability
- Oil in the coolant, Brown Sludge, The curse continues!
- Boring out the engine
- Improv* Gaskets (Results)
- What spring rate should I get if I am 160lbs
- Shorty exhaust/Exhaust options?
- Engine mount loosened
- Dropped Ninja 250 at low speed and now idles extremely high
- Should the rear tire spin freely?
- Gotta Love Ambiguity (Bolt Torque 250r 2007)
- coast enrichener, among other things
- Parts help! (86-87)
- How expensive will this be to fix?
- '06 EX250 slow accel, hits a wall at 65mph
- vent hose transmission 250