- fork spring change
- Where can I find OEM 2005 Ninja EX250R Indicator + Mounting Plate
- 2001 ninja wont start after winter
- Wiring questions, Aftermarket cluster help.
- Idle problem improvement
- Factory Pro Jet Kit
- 2006 Gpx 1990 ninja project
- carb and petcock refurb
- Keeping centerstand w/aftermarket exhaust
- 04 250 sometimes starts, sometimes doesnt
- '06 ex250 no spark
- 2over pistons, will not run!
- Repair/Prep f/ IBA ride
- 2006 Valve clearance
- Headlight fuse immediately is blown on startup
- ZZR250 carbs on a GPX250
- Clutch issues
- Props to Ducatiman for carb rehab service
- Another ticking sound thread
- Carbs cleaned - Diaphragm ripped - Options?
- Carbs cleaned - Diaphragm ripped - Options?
- 250 Sputters and lags on acceleration at speed?
- TrailTech Vapor wiring
- '06 Ninja 250R - starting/stalling issues
- 06 ninja 250: FUEL PROBLEM- starts with starting fluid then dies
- 250 gpx starts but then stalls
- Ticking Noise
- Need advice on a part I want to buy (Replacing my Muzzy Exhaust)
- This upper head light plastic worth $250?
- Changing shifter and linkage....
- Cold Engine Stalling
- 2004 ninja 250 overheating
- Thermostat operating temp
- Overfilled 2004 Ninja 250r tank, now no acceleration past 1/4 throttle
- I Think My Pilot Jets Are Plugged
- HELP! 06 250r no spark i need advice
- 2006 ninja 250 wont rev!?
- Weird stalling issue
- Weird problem with rocker arms
- 07 sprocket problem
- New here - Looking to muffle the Muzzys
- Low idle then dies - mixture too rich?
- Like to perform a few changes to my 05 Ninja 250
- Will a Suzuki GSXR Shock/Suspension 2011-2016 fit a 05 250?
- Swap 250-650
- 06 ninja lost power and died Check it out.
- SUGGESTION use your fuel rail filter
- No spark
- newgen front plastics on pregen?
- Low beam not working?
- 1993 250 acts like full throttle
- Installing a single pod air filter
- Roached fuel tank help
- Need Help! 06 250 pouring gas out front of carbs
- Mussarri exhaust. Any good?
- Anyone run a 250 with airbox removed
- NEW tires available in sizes for our 16" wheels?
- Paint System I use
- 16 tooth front sprocket -- Anyone with personal experience?
- What wiring line should I use for accessory LED lights?
- 1995 250 Generator
- Got the ninjette back. Time to fix up
- Air screw tip broke in carb
- which fork & wheels for upgrading '86 1st-gen???
- Front Wheel Wobble
- Lookit what I got !!!
- Clutch basket removal
- '04 Idle Air Mixture Screw O-Rings
- Ignition switch lock life.
- what could a torn carb diaphragm cause?
- Removing head cover
- Pressed starter button no lights
- 07 ex250 starter problems.
- Carb hose routing on ca model 07 ninja 250
- Any advice would be appreciated!
- Chain adjustment without a center stand
- Idle air mixture initial settings?
- 04 Ninja 250 Carb rebuild kit
- Valve adjustment so far out?
- Fixing an aftermarket ignition for ex250f
- Cam/Chain/Rocker ?
- 2008 - 2010 engine in 1990 GPX
- Blown Head Gasket: Worth Fixing?
- 1990 GPX with Musarri Exhausts
- Runs cooler without fairing
- Valve lapping?
- Moving grips outwards
- HELP!!! NINJA 250 won’t start
- 04 250R problem starting
- Oil Pressure Sensor Leak
- Fun Pre-Gen Winter Project Finished
- hypothetical cam timing question
- HELP! Identify this Bolt and Nut?? Ninja 2006 Ex250
- Antigravity Battery
- Cam chain replacement dodge?
- 2006 Ninja 250r Rubber Chain Guard question. . . ?
- Help! Broken Spark Plug...
- 1995 EX250 Thermostat question
- Starter removal help!
- Draining fuel on lower Carburetors ? Ninja 250 2006
- Carb Cleaning, need part identification
- Timing Curve
- This has been a fun ride...
- Thinking carbs are dirty, any input before I start tearing the bike apart?
- 99 Ninja 250 revival problems
- Pregen Ninja 250 rearsets
- Is my carb beyond hope? Main jet looking odd...
- Remounting issues.
- 07 ninja ex250. Interference or non interference motor?
- Ninja EX250 2006 Cleaning Cam Chain Tensioner Help???
- rear brake caliper question
- 2012 250 into a 2007 250?
- Ninja 300 clutch on a ninja 250? Swap
- Surplus of used pre-gen 250 parts
- Trouble re-starting
- Water pump
- Speedometer gear
- ...why not.... cheaper than rocker arms....
- How expensive would it be to get a brake caliper piston custom machined?
- Replace some of these hoses
- Bike starts but throttle is messed up doesn’t let me use throttle
- Indicator help
- Ninja 250 dies while riding
- 07 ninja 250 ignition switch question.
- 07 ninja 250 ignition switch Ninja 500 Ignition switch question.
- Fan doesn't run after some maintenance (had to snip some wires). Diagnostic tips?
- Bike keeps dying doesn’t stay charged
- Engine slow to fall the last 2000k rpm before idle.
- HELP!!!!! Plastic plug on the side of Cylinder Head popped out for the second time.
- Ninja 250 Problems Galore
- Extended swingarm on an 05
- Oil coming out side of airbox
- 2007 250ZZR Carb cleaning - any mods should I do while the carb is apart?
- I need a steering damper, any suggestions for mounts?
- Charging system problem?
- Valve won't loosen any more
- How To...Wheels...
- Starter clutch removal
- Found shavings on the oil screen
- Fuel filter
- Cant shift into 1st gear
- Ninja 250 Gas Petcock Use
- Most excellent key copying experience!!!
- Reasonable highway top speed in 6th?
- The infamous gray wire...
- Lubricating front axle ZZR 250
- New member, 1st Ninjette, it's a mess
- Running too rich..
- Fuel leak
- Petcock
- Carb issue
- Return of the Carbs
- any way to get "friction" back into the choke lever
- First of my two issues
- Second small issue
- Transmission problems?
- Removed the trail tech Vapor instruments
- carb boots
- Pregen: Combustion Chamber CC
- Recommendations on Oil Filters?
- Unusual carb question
- Gas issues, Gas tank questions
- 2007 GPX250 - Where to find non-OEM radiator hoses
- Increase performence without removing the air box?
- Leaking Carb
- Found o-ring not sure where it belongs
- engine teardown - need advice.
- 2006 250 Leaking Coolant
- idle @ 7k when choke is on
- How much did I just get ripped off?
- So I’m fixing up my 250 and have some questions...
- "Harumi" Updates and Concerns
- Leaky carbs on an '05
- Custom Fork Spring Install.
- Help please
- 2012 ninja250 exhaust swap
- Can't find a manual Cam Chain Tensioner for 2007
- 2004 Ninja 250 air fuel screw question
- Exhaust modification question
- I need help with idle issue
- Low Compression on 2007
- 2004 headlight bulb upgrade
- Pre-gen front turn signal hack
- Engine clatter
- Used Engine Advice Needed
- 88-07 frame sliders
- 88-07 rear sets
- Another Spark Issue 94 250
- Coolant issue - has anyone had this?
- Wet float height question
- Dyno Jet kit help/questions
- Love this bike
- el250 coolant hose routing
- 2007 Ninja 250 - Possible Carburetor Issue?
- Tachometer sticking to 0 on startup
- Exhaust options?
- Gurr's 1988 250 Rust Rocket
- Pilot Jet Screw Help
- gpx 2002
- Cold start problem
- Upper Fairing won't go into place
- Carb diaphragm came apart?
- Headlight dims when brake lights come on.
- Neutral light not staying on in neutral?
- ODO Reset (not malicious I swear)
- What I did during the mandatory self-quarantine
- 06' Ninja 250 Won't Start Help
- Rod knock
- 88-07 tachometer question
- Starting/idle issue
- Carb vacuum line question
- Advice on cheap, like free Mods-for quicker acceleration~~Yes I searched !!!!
- 1999 Various Questions
- Valve Adjustment Question
- Do 2002 fairings work on the 2003?
- Pilot Jet Questions
- Adjustable Lever Questions!?
- Pregen Two brothers repack and install....
- Huge Fuel Leak after Warm up
- my day
- Versys 300 suspension on pre-gen 250r
- Tail section signals - need lenses?
- Do I need new forks?
- Two Brothers Exhaust ID
- 2002 Ninja ex250-H No spark need help please
- Yet Another Engine Rebuild
- Something leaking in exhaust
- Sprocket change to 15/42....need a new chain?
- Let's talk jet kits
- pulsing idle 06 250 ninja
- non ethanol fuel question
- Camshaft change issue - won't start
- Oil light question
- 2007 Ninja 250 Oil leak and constant stalling
- Spool sliders
- 07 Carburetor Rebuild
- Trying to fix cam timing to run a 94 cdi on a 2005 ninja 250
- Front tire cupping issue
- Coasting Enricher
- Kenda tire question
- Muzzy 2 to 1 question
- Rebuild project need help!
- 2006 ninja 250 fuel problem
- Temperature sensitive idle?
- 2006 ninja 250 bogged down at high speed and sometimes low speeds
- Flywheel puller
- one cylinder richer than the other
- Dan-moto has slip on's for pre gens now
- Let me get some opinions
- Lost the fan switch cable