- '08+ parts that fit Pre-Gen
- 2007 250 Ninja Not Starting
- Haynes Manual Hard Cover
- Fork rash problem
- Compression gauge
- My New Battery - Ballistic Performance
- Having Idle issues, only running on choke..???
- 30A main fuse blows
- valve adjustment
- Pregen Brake lights
- Old Ninja help please!!!
- Just did a front a rear brake job... Problems with front.
- Front Axle Castle Nut
- Franken-Ninjette Build
- Check your nuts
- how does this bracket go?
- what is this hose?
- carb leak!! help
- 30 minute modification
- carb overflow hose size???HELP
- Where I last left off...long post, tons of pics
- Please Help - Bike not running well
- Fouled Plugs - But why
- New Tires
- Rough ride....possible suspension problem?
- Do the brakes suck on this bike...or is it just me?
- How To (kinda): Flush Mount Signals
- Is this normal?
- Cotter Pin
- Clutch slipping isssues
- clutch release problems
- Tachometer fluctuation at stop and idle issues
- 17" wheels on older Ninjettes
- Ninja Project Write-Up
- killed battery now won't start - shorted something.
- Please help - Carb Reinstallation
- power loss - mid to high rpms/bike newb
- There is no possible way this can be good.
- Need Help--Issues Starting Bike
- Passenger Foot Peg Alignment
- Countershaft Question
- 2003 EX250-F has engine problems in the rain
- left hand controls 95 bike 05 controls
- Lost float springs
- Basic HID install
- Valve Adjustment Engine Won't Turn Over.
- Direct me: front blinker
- Technique for lubing cables
- Cali bike / 49 state replacement tank / hose routing help
- bike won't stay running
- Signal indicator and tail light problems!
- Questions about front brakes
- 130-90-16 touch chain guard?
- repainted ninjettes
- CDI wiring question
- How to replace those silly rubber pucks to which the gas tank mounts!
- Oil Leak Help
- Brake dragging issue
- 06 Ninja 250- Starting Issues. Need help
- Valve adjustment interval
- Strange Shifting
- EX500 Ignition Advancer works on 88-07 250's?
- Can't get valves to seat, need advice
- bike won't run after several miles
- Desperately need to replace front rotor...
- Bike won't start after crash???
- chunks of old sealer and rust in tank?
- Rubbers from the carb to the airbox
- Replacing Fairings
- Problems with engine/transmission
- Electrical
- DIY Brakelines
- Ninja 250 Build
- Messed up dash speedo
- Bent shift fork?
- Handlebar adapters for regular bars
- Piston ring order
- '03 ex250 front end works on 04 ex500?
- Help with my Ninja powered Kart?
- Straighten Fork Tube?
- Pre-Gen Ninjas Rule, 104 MPG
- Headgasket thickness?
- Not starting with ether?
- Help me pick my next rear tire.
- Missing Filter Spring!!!
- Speedometer question
- Who knows how to replace speedometer bulbs?!?
- Valve adjustment Issue
- Help! Getting to carbs and removal.
- Help! Need opinions on pistons...
- Engine Problems?
- New Headlight
- Slip-on Exhaust
- two brothers ex
- All dark, no juice
- Jetting question
- 06 ninja 250 won't start
- Jetted or not?
- Avon AM26
- UniFilters
- What in Hades am I missing??
- Clutch Replacement
- Looking for part
- Koso or newgen gauge on a pregen?
- $20 solution to fan switch problem
- Quick Question!
- 2003 Ninja 250 Clutch Basket Replacement!!
- Return to stock exhaust?
- 86' engine swap
- I need Help :s
- Pregen rear spring shock alternatives
- Saw in classifieds: What is likely wrong with this motor?
- If I buy a used full rear wheel assembly for an 04 model off ebay...
- Can fork springs be changed without removing the fork tubes?
- Turn signal mounting plate replacing...HELP
- Will 95-07 left switchgear work on a 94 EX250?
- Just bought a 2007 ninja 250
- starting problems
- Mirror bolt size
- Carb Slide
- Float
- For those who installed K&N aftermarket air filter
- What front Head Stand is everyone using?
- spark plug tool
- Fork Viagra
- Help please!
- Airbox installation
- 1992 250 Build/Restore
- I need you guys to fix my bike! PLEASE! :)
- Cleaned Carbs, Replaced Gas, Still having engine problems.
- Oil Filter Leak
- Can't start my bike
- Jetting Question
- modifying stock exhaust
- Won't idle or stay running
- Is a wider rear wheel possible?
- Two Bros vs. Yoshi
- another question on replacing shocks
- Taking a long time to warm up
- What is the stock exh header made of? Stainless?
- '87 - Need a new front tire (affordable) SUGGESTIONS? please
- I have a decision to make.....
- Crankcase Breather POD
- I have no idea what I'm doing
- Does anybody know...
- ninja 250 undertail exhaust mod
- Anyone hear of "Chrome" batteries?
- My valves had no clearance--have I damaged my bike?
- gas leak. need help
- Engine died yesterday.
- two brothers slip on
- Slip on came today
- Carb tuning
- 1998 Ninja 250 - Rebuilding Carb?
- Idle/Chain not quite up to par
- 96 ninja keeps dying?
- 93 Ninja Problems
- 87 Ninja LED signal conversion HELP PLEASE
- Weird noise after ride, 07 ninja
- Headlight not working :(
- Is this Normal?
- having an intermittent starting problem!
- Cant hear engine above 50mph.Bafflectomy?
- fuel inlet tube on carb cracked or loose? Leaks gas!
- My 2006 2fiddy Rebuild
- what exhaust do i have??
- Mounting front radials on the rear
- 2007 Ninja 250 question
- Intermittent Horn Problems
- Dies at higher speeds/slowing down from higher speeds
- 2004 Starting Problem
- Extra Brake Lights in pods = all other lights dimming
- How to use Seafoam?
- Runs better on reserve???
- Switching Needles
- Just had a Sport Demon installed...
- weird starting problem
- Building a Toolkit!
- Trouble refitting the rear wheel!
- Having a problem
- Overheat Issue
- Carb Sync Screw Replacement?
- Buzzing Noise on Ignition
- Problems getting bike running
- Is this symptomatic of dirty carbs?
- Carb Hose Routing
- Extreme Mod Pack
- GUNK in my head!
- Gas Tank Lock stuck? Maintenance for gas cap with pics!
- 08+ exhaust header on pre gen?
- Duro tire review
- Too rich or too lean
- Test-riding a 250 tomorrow....specifics to look for..??
- Gas tank overflow problem
- Thinking of changing front sprocket - any tips?
- Please help!?!?
- Sloppy fork bushings after disassembly?
- Timing? Simple wiring?
- Help me find this and I will paypal you a dollar
- My odometer Reads 1600 miles
- Jet starting point
- What is this hole..??
- New to riding, got some questions.
- Bent Forks?
- Do new gen clip ons fit pregen bikes??
- Carb idle problems
- factory pro needle worth it?
- Ruh Roh (electrical)
- Changing rear brake video??
- 99 with 09 exhaust help
- Noob here..Probably dumb questions.
- Need help quick, oil issue
- Stupid electronics!
- 1987 rear suspension
- Random hose?
- do i have carb prob
- Hi, is there any way to speed up the pre-gen 250s
- Rust in the gas tank...
- Leaking Carb- Out of ideas....
- Bike not running, too much oil?
- Bike would not start, then..
- Evolution of my 2005 Ninjette.
- Ecotrons Gen2 FI Kit Install
- Turn signal terminal
- fiberglass repair
- Possible Valve or Carb Issue?
- New to this ninja thingy
- Charging Problem
- Top Speeds?
- 2007 Ninja 250 question part 2
- Gas Gauge
- Idle problem
- So what is the petcock exactly for....
- Aftermarket turn signal replacement fast blinking problem
- Loose Hardware...
- bad mileage and sputter
- seafoam..
- Cam Chain Replacement Advice
- Homemade Fender elim kit
- Racer X engine rebuild.
- RPMs come back down slowly when revving... Followed by smoke
- Trouble with starting speed
- Where does this go?
- Kick Stand Question
- Best sounding exhaust?
- Bike won't start using starter switch
- Oil Light?! Yikes!
- decelleration after fire/ rumble?
- '07 just lost power
- grease for lever replacement