- Starter turns but no compression.
- Lightening her up, part II
- Quieter exhaust
- 2001 250r voltage
- Cleaning carbon deposits
- need valve adjustment help in the Bay Area
- triple clamp stem bolt Same as EX-500?
- Multi-Gage for the Ninjette?
- Gas Pouring out of Overflow Tube - Bowls or Petcock?
- I need some float bowl gaskets ...
- Tire upgrade!??
- Anyone know what's inside the fork lock shroud?
- Gen 2 tank swap to pregen
- Breaking Up at High RPM
- Breaking up at 5500rpm ?
- Shimming / Needle Questions &Weirdness
- First bike, first post, first problem
- 03 250 choke stuck??
- Anyone know why my speedo cable won't screw in?
- starting problems
- Bought first bike and 1 day later it won't start: do I have a junk bike?
- Sticky clutch?
- Pregen Adventure bike....
- will a new gen starter fit on a pregen?
- Help with exhaust?
- Bike leaning to the left and random handle bar shake.
- Wheel weights factory??
- Front brake not engaging
- Clutch cable snapped.
- Several small problems I am having trouble with
- How much should I charge for fairings?
- Pricing on an '05 + issue to be wary of?
- Finding carnage and replacing cam chain.
- My Experience with the EcoTrons EFI kit
- Trimmed my front fender
- Can't start - stuck in gear
- Strange Carb's
- How hot do the clutch and stator covers get? What temperature?
- Running rich?
- Unusual oil leak from crankcase seal
- Well There It Went...
- carb rebuild help
- No spark.. stumped
- Seized engine
- Bottom motor mount bolt.
- Why is my Clutch not fully engaging?
- Is my gear shifter bent?
- back firing
- My poor little ninjette
- 2010 fairing on a 1992?
- Please help!!
- Issues with Possible Purchase
- Vacuum nipple came off petcock - fix or replace petcock?
- Setting up ex250 track bike
- valve emulators
- Picked up my first ninja, some parts questions:
- Another carbie post
- dead bike
- Kerosene spray bottle
- In the tank
- 2004 runs bad smokes no power
- pre-new gen motor
- Rebuilding Questions
- weird squeal
- Exhaust smoking/leaking gas
- Oil sight glass
- petrol in transmission?
- Tech question
- 1993 ninja 250 key
- 1993 ninja 250 front end dive when breaking
- Engine Rebuild Question
- Oil in coolant--or "How much trouble am I in?"
- crank & rod bearings sizing
- 2005 rebuild help thread
- sounds clunky starting up?
- Even lighter - more detabbing
- Rebuild Bike is officially a project bike
- issue tightening chain
- New vs pre gen carb spacing.
- Did your pregen lag at ~5k on roll on?
- Tachometer wiring help
- Changing brakes
- Coolant leak
- Seafoam for carb cleaning?
- Ran Out of Gas :(
- bar ends
- Replaced Tranny, now it won't shift?
- Valve adjusting and Oil filter change
- Video- Ninja won't hold charge
- Cooling System Issues
- just cleaned carb now it bogs down and dies
- Problem with 2001 EX250
- Put on UNI pod filters now bike won't turn over
- project 06 250r
- 90 build up
- Oil/Filter help?
- carb issue.
- Airtech Streamlining upper fairing: Not really AIO; Lower cowling doesn't match.
- New Shinko s230 Rear Tire 130/90/16
- ZZR250 diaphragm troubles!
- Shifting lever completely limp
- bike wants to start just won't turn over
- Idle Adjust location?????
- Newgen rear swing arm/tire and front forks.
- Ninja Autopsy
- Air fuel mix thumb screw
- Tail light is out!
- How to pod?
- stumbling bike
- 2007 Front Master Cylinder re-build kit question
- Ever had a frame straightened before?
- I'm Back w/Hole In Tank
- Overheating problems
- ninja 250 Governor?
- Engine won't turn over.
- Headlight bracket
- Changed clutch, still slipping/skipping?
- 650r or 500r engine
- Exhaust question
- SOK brakes from ebay
- side cover bolts
- Low Beam Good, High Beam dead
- Valve Clearance Problem
- Exhaust/Intake Upgrade Ideas
- My baby is sick! =(
- Soak or clean & scrub
- 1998 Ninja 250r Issues
- noobie help
- 08+ header question
- '07 250 running one cylinder
- Scored Rear rotor
- Tires
- Two quick engine rebuild questions
- 86 250 flooding engine
- Who has done a custom exhaust??
- Is this normal..?
- Have I wired this correctly?
- Rear fender ABS plastic?
- Rear Suspension measurements
- anyone know where to find this bolt?
- Newb Brake Question
- Bike Service
- Probably a bad idea, but...
- Radiator cooling fan wiring
- Loss of power and mpg
- Significantly more power with full choke?
- Craigslist Bike needs some work.
- HELP - brake pads
- Emulator install.
- Battery Issues
- Zzr 250 turbo- advice
- Any Ideas on a Repair Method?
- Weather=fuel leak?
- Bike surges on clutch less shift
- New tire
- Oil change issues
- Anyone ever used a paint stripping wheel?
- Muzzy Exhaust with a hole and Road Rash
- Supporting Bike for Swingarm Service
- LED Brake Lights
- Bike won't start need some advice!
- 1999 Ninja 250R "Vesper" - Project Log
- problem with carburetor maybe?
- Idle goes higher when on kickstand
- 2007 wheel fit on a 2006 ninja 250?
- Overheated and now my temp gauge is broken. Tell me about cooling systems.
- coil question
- Easiest way to remove carbs?
- Creating more space under the seat. Would this work?
- DIY - More Under Seat Storage
- A bit of learning to do
- Removing stripped rotor bolts
- I know the manual advises against using them, but has anyone ever done it?
- Antifreeze in oil
- first post/need some help
- brake caliper dust seals
- Stalling after moderate throttle
- Tire pressure + Handling
- Best looking 250R Streetfighter?
- Rotella t6 temps/ interval? oil change
- Seafoam is worth trying
- Working on a 05, starts and runs, just no throttle
- Paint recommendations?
- Kickstand switch removal
- Turn Signals not working correctly
- Recommended brand of chain?
- carburetors overfilling
- Valve rocker arm replacement
- Oil drain issues/Cracks
- Valve adjustment
- 250r transmission gears
- Anyone wanna get high?
- what's this hole for?
- Trip meter not working
- 05 Ninjette chattering noise
- ninja 500 engine in a 250 frame
- Time for a new rear suspension..?
- 06 250 Won't Start, Please Help!
- Replacement for Muzzy can?
- Indicators of water pump seal failure?
- Cranks - No Spark
- Engine turning over but not starting
- K&N air filter=Bad idea
- Shifting Issues.
- my clutch is making me nuts!!
- 2001 Ninja 250 - Won't start
- Hayabusa Lowering Links?
- Transmission output shaft replacement
- Clutch release kills the motor "Seems to be kickstand switch"
- 30a main only pops when rectifier/regulator is connected
- Custom length brake line?
- Newgen exhaust on pregen?
- 05 Ninja-cam chain slack!??
- Coolant leaking into oil and oil leaking out of somewhere.
- Issue with oil thinning out...
- Odd
- Bike Started after 4 months of not riding. Then it stopped.
- 2002 Ninja 250 - issues (spark pugs, dirty carbs, won't idle, etc?)
- More Carnage!!
- Fork drain bolt is stuck
- Clutch Cable Issue
- Center stand for 2004 Ninja
- Crank but no start
- Oil Color
- need help with something..
- Is this normal?
- Leaky Tank Fix
- Petcock (Pet Chicken Lol) Problem 1989 ex250
- Front fork oil seal change...
- Manual Petcock
- Front end wobbles
- Couple of questions
- Just picked up a couple motors for the ninja
- Strange fuel leak from carbs
- If it's not one thing.......
- Is it true...? have any of you done it before?
- Engine Issue... Sounds "Throaty"
- 1986 ninja 250 build
- 04 stuttering
- scooter tyre??
- Stripped Allen Screw/Front fork change
- Constant flooding
- Performance mods on pre gen
- Engine Frozen? Won't start, just clicks/whirs and runs up the rpms
- Ground wire corroded
- took stator cover off, cranks slow wont start
- Carb tubes
- 2006 Ninja been sitting for a while
- Different thermostat?
- Idle/Start issues with 2005 Ninja 250