- no spark need help 2004 ninja 250
- fp jet kit installed BUT!!
- Bike did not start this morning...
- Slow acceleration sleep after 40mph
- Rear Axle Size
- fork oil dump bolt
- I put diesel in my engine.
- So, if your starter does not work would you consider this?
- Fork Oil Weight
- stock fork height over triple tree
- Lost power while riding on twisty hills today.
- Pirelli tires........grrrreat
- Could someone please tell me which are the starter circuit coil terminals?
- Adjustable footpegs
- new gen shock on pre gen
- Strange Noise when Accelerating w/Video
- Petcock Filter Anyone?
- Looking at Shorty Levers for ZZR-250 / EX250H
- mirrors
- Oil Leak?
- Almost tank slapper
- Installing a California tank on a 49 state bike
- High handle bar vibration, hard to get into high RPM, is this normal?
- cold blooded
- Rear Spools
- sticker removal
- engine stalls when up temperature
- Petcock gaskets?
- Pilot Jet screwdriver size
- Normal operating temp
- Pinholes in gas tank--Solder/braze/weld?? Attention welders!
- Camshaft chain removal
- carb problems with video
- replacement bolts
- Float bowl leak (I think)
- Fuel consumption (ave. mpg)
- crank case bolt size(generator cover)
- Fairing question
- tires for 07 ninja 250
- 02' Ninja 250 EX250H / ZZR250 Leaking Gas
- Oil leak from drain plug
- Changed coolant - drip from left exhaust
- adjusting idle 07 ninja 250
- Question about Oil Filler Cap and Fairing Bolt
- Is This Engine Noise Normal for 250?
- heat gun glue
- Odd Anomaly
- Emulators
- bike won't start. tried everything
- Strange Electrical
- steelbraided break lines
- need help with my bike.
- sputter at highmid/high rpm?
- Multiple Issues: Starting & Running
- Wiring diagram
- oil change
- pricing help please
- *Girlfriends pregen streetfighter build*
- Coast enrichening circuit
- What if I'm missing the header gaskets/rings?
- Speed Wobbles
- NEWGEN Gas Tank on PREGEN
- Red-Line Changes
- To drill or not to drill, that is the question
- 2007 won't idle. Vacuum leak or something else?
- Downloadable Gaskets For The Pregen
- Bike won't start
- Tail light? Fuse or bulb?
- Clutch cable keeps snapping!!!
- Changing Plugs - No SP tool in kit
- Front suspension upgrade
- Help - Having engine issues with new-to-me bike
- wiring for flush mount front turn signals for 07 ninja 250
- Key comes out when ON
- swapping brake calipers
- I'm Missing A Part, Aren't I?
- how screwed up is this?
- 96 Pre Gen Racebike Build
- jet kit
- Zero and the Magical Disappearing Oil Trick
- Odometer problem...needs to be fix asap
- fiberglass on panels to transform the look? anybody know how?
- steel braided brake lines
- where to buy steel braided lines
- slow rpm fall and bike doesnt want to go.
- HELP 03 ex250 left cylinder not firing
- removing flame decals
- Something loose in the front end
- Danmoto digital gauge?
- Tach does not exceed 4k
- tire help
- Swapping parts
- EX 250 Ninja gauges speedometer cluster
- Weight reduction performance improvement ex250
- rear brake spring and sensor? HELP
- Pregen 250 feel shaky at 11k rpm
- Need parts interchange info
- 2004 ex250 won't start
- Loose chain remedy
- Cafe'd 250
- Front Brake Help
- Ninja 250 Compressed Natural Gas Conversion
- My craiglist motorcycle
- want different signals.
- WTF: Kerker 2-in-1 exhaust, bolts from engine too short?
- Small question regarding oil check
- Issue with K&N pods
- Camshaft questions 86,87 vs 88+
- Sprocket comparability pre gen to new gen
- Tire/wheel questions
- What kind of fork oil?
- VIN/Engine Numbers
- Removing and cleaning carbs and K&L Repair Kits
- Speedometer gear and seal issue
- What's a good set of tires that won't break the bank?
- Ninja 250 problems
- Fitting a new gen front wheel on a pre gen?
- Engine Seized
- Spring
- Weird play in the shifter peg?
- Anyone familiar with battery tender?(charger)
- Brand New Battery? what to do?
- Clutch cable too taut to house?
- May have lost my only key.
- A few technical nic nacks.
- Idle speed
- So, first time out my wife layed it over!
- Ninjette seemed fine, but now won't start.
- Fairings and screws/bolts
- improving low end power
- Turn signal behavior:diagnosis?
- Engine Swap: 2008 in a 2006 body
- Puny little battery
- Unlowering 2007 250
- zzr question?
- Weight
- Starter issues- With cafe racer teaser pics...
- Mirror mounting holes
- 2004 track bike build, r6 front (pic heavy)
- Why are OEM rotors so expensive?
- Going to weld on spool mounts,
- how f is the engine
- Quick ? regarding carb diaphragm
- Back to fixing the broken beast.
- Vacuum hose cross caused leak
- CDI Ignitor compatibility between years
- Probably a significant improvement over stock...
- Leaks
- Bike stalling at lights on morning commute.
- Honest mechanics in orange county, CA
- Leaky carb bowl?
- Accessory holes in control lever perch.
- ninja 250 battery & tender question
- Starting and riding on cold engine
- Intake boot
- Ganna store it.
- help with acewell 2853 gauge install
- front end shakes
- Rebuild Part 2
- max pregen tire size for dual sport
- Bike is f'd up again!
- Brake calipers
- coolant tube
- rear axle torque
- can't get this 250 to start
- Reflective rims and tank pad
- My rear brake lights wont light up
- 2007 ninja won't run? what to do.
- Clutch Basket
- Mounting New tires
- Ugh, that gas.
- I'm thinking twice and doing my own adjustments.
- sonic fork springs
- 15 tooth sprocket...
- debaffled exhaust..
- is this normal?
- 2007 Ninja 250 paint match?
- And here's another problem....
- GPX250 resurrection
- Chain bouncing and hitting swing arm
- Bike bogs down everytime it rains
- Engine idles to a stop after running a few minutes.
- Rich's Cafe Build thread
- 2004 Ninja 250R Streetfighter which parts?
- What does your ninja 250 sound like when warmed up?
- Full rebuild of the ninja
- Is it possible to start it without the stock gas tank?
- Recommended Chain Slack
- Brake pad recommendations
- Ok where's the drain tubes for the spark plug recesses?
- Great way to test your thermostat without taking it off the bike.
- Bike running lean out of the blue.
- Front brakes
- Fork drain bolt washer
- Things to watch for when buying
- Anyone tried EX500 fork springs? are they stiffer?
- 300 rear shock upgrade and front suspension
- Fiberglass Fairings
- -Vent
- Air Box Installation on 2007 Ninja
- 96 250R Sprocket cover & rubber feet
- LOUD popping and 1/2 power
- I cannot make my 07 run right :(
- I'm overseas. Can someone measure tail for me?
- What headlight bulb are you using?
- rear suspension
- What am i doing wrong?
- Is this normal?
- ninja running funny
- Bearing Life?
- Pre-gen Fork Clunk
- footpegs..
- Can't figure it out..
- Track Day - Budget Build
- Hard starting in cold weather
- Overflowing carbs are doing my head in
- Right front turn signal not working
- Changing my front light... Hard?
- Low power in all gears
- Some questions for EX250 mods
- Where to buy brake piston rebuild kit?
- front shock absorbers
- Radials for the pregen
- Recommend me a Carb Rebuild Kit
- Need measuring help: im in Thailand
- oil change intervals.
- yes..another tyres thread..
- diodes..
- Help :confused:
- Anyone interested in me doing a heart transplant video?
- My streetfighter conversion
- Best rear shock for the pregen
- Fuel tap question and bike surging
- time to build?
- Vacuum leak maybe?
- 2008 wheels on 1986 ninja 250
- 2007 Ninja 250 wont start...any suggestions?
- so i shimmed..
- dog bones...
- Carb problem?
- Best stock carb tune
- How do you get pregen seat off without a key?
- 06 Ninja250 to 00 EX250 exhaust compatibility?
- How many of you (centerstand)
- Tire size question
- 15t front sprocket loose
- Show me rim pics :)
- To do my own tires or not...?
- headlight dimming
- 1988 fork weight