- where do I start to see if it starts?
- Fairing repair
- I'm new, already installed gsxr shock.
- Neutral count as a gear?
- Cam Chain replacement, possible engine damage
- Wits end. No spark.
- larger front rotor??
- 15 tooth front sprocket
- 200lb rider on an 11 yro pre-gen; suspension upgrades?
- Advice Needed: Engine Bog @ ~6k 1/4 Throttle
- How can I tell if my bike has been lowered?
- Exhaust header stud broke
- Oil leak!!!with a little smoke!!!
- Canadian guys and parts... (Drive chain/sprockets)
- Chain question before I order online
- main jet size listing.
- New Tires?? What do I do??
- STUCK! on the way to the dragon
- Wheels not weighted for balance from factory?
- Are these the most reliable of the ninjettes?
- Update: Re-loving 2000 EX250
- Start button problems
- High idle when turning to lock
- Non-starting 1996 gpx250
- Bar end question
- New gen dog bones on pregen
- Help me decide on a rear shock
- front end wobble no hands on bars
- Round front hole on airbox?
- "Spongy" lever on front brake....?
- What oil should I use?
- Is this the stock ex250 airbox?
- ticking. awful, awful ticking...
- 2004 250 ninja help -- won't start
- Clutch cable too tight?
- 2006 gsxr shock
- Oil Filter...
- when releasing the clutch
- cigarette lighter installation
- Spare engine--high compression build?
- Draining fuel tank - gpx250
- Swapped New gen forks onto pregen, kept old gen ignition switch.
- 2007 ninja 250 HELP ME GET IT RUNNING
- 2007 zzr. Not a peep when trying to start :(
- Sprocket size change
- All of a sudden the revs were all over the place....
- Cafe Fighter Ninja 250
- Brake caliper rebuild help
- Efi... How many installed it
- How can I tell the condition of my chain?
- Rear lift dog bones
- Recommend a good torque wrench
- need some electrical help
- 2007 zzr 250 brake and clutch levers
- Clutch issues. Won't disengage, searched, tried, help
- Improving low end torque: questions for the motor gurus
- Keep your rockers square
- Replacement Chain and Sprockets
- NOT what you want in your carb
- Front brake feels soft sometimes.
- only 63mpg? How can i increase it
- Air/fuel ratio diagnosis
- Help with jetting and/or exhaust
- Help replacing lower fairing
- Rasping Noise Above 8k RPM
- 1/2 crank rotation then locks up?
- Brake caliper pistons not retracting
- Idle Problems of a Biking Noob
- Ever have spark plug go bad??
- 2004 EX250 Leaking Coolant After Change
- Idle shooting WAAY up on start
- Power and ground color question
- small stutter
- Guess This Noise!!
- Pilot Screw - Plug?
- online stores to buy tires
- Brake pads
- am i running rich?
- Who has made homemade dog bones?
- fixing a holed tank
- Fork brace for a 2003 250R
- Best Service Manual?
- Won't stay running after warming up
- We were running and now were not
- Blown fuse. Then another.
- idle question after freshen up
- Front master cylinder piston dimensions?
- Motion Pro Throttle sleeve for Pre-gen.
- Rear shock option for pre-gen.
- Suspension upgrade
- Christmas Build thread
- Motorcycle Wiring Guru Assistance Needed
- 2003 ex250 Ninja Carb issues
- someone bored and can take measurement ASAP pregen under seat rail width?
- Lists are good IF you follow them... or beware cranial vapor lock
- Bench Testing A Starter
- $40 pre gen adjustable dog bones
- Retrofit: Radial Master Cylinder
- bored? can you measure the naked gauges ?
- Missing idle circuit O rings? see photos...
- Top speed on a naked bike for a 300lbs rider?
- I broke my transmission!
- Wheel, shock installation questions..
- 1996 ZX600C shock or 2010 300 shock
- Downshifting woes
- Tank Lock Removal
- Front suspension question
- rpms hanging badly
- Does this sound like dirty carbs/air filter?
- rear brake master cylinder clip
- Engine Problem
- petcock leaking
- Where's the Factory Pro jetting database for pregens?
- Accessory leads not working, can't figure out why
- bike won't turn over
- Magnetic drain plug for pregen?
- Rich or Lean
- 04 ninja 250 carb issue
- Cafe Delights
- Valve Stem Size.
- Tyga exhaust
- oil level
- Cooling issue...
- 2005 Ninja 250 idles but bogs down after throttle
- no hand tank slapper
- Use of K&N Filter
- Help with new bike - vacuum hoses
- Where does this hose go?
- I think I need to clean my carbs..
- Lack of ZZR 250s
- Bike wouldn't rev past 6k, then died
- EX500 Clutch Lever
- '07 250 won't start
- Coolant Reservoir hoses
- She is done!! WOOT!!!
- What other gas tanks will fit the bike?
- Replacing Engine in 2007 Ninja 250
- Rubber mounts for Side fairings
- 1993 250 f7
- Compression testing out of frame?
- RK 520XSO Chain Clip vs Rivet Master Link
- what gaskets to change during engine tear down?
- oil consumptions
- Just installed a Muzzy and...
- what am i missing, 95 250R exhaust header bolt up questions (stock)
- did i get the right chain lube?
- Pod filters worth it?
- Battery cable bolts and rectangle nut what size and where to find them?
- I'm curious about what brand oil to use
- 2007 tank fit
- Jetting with Yoshimura 2-1, K&N 0990, at sea level, ~70*
- Slow crawl to idle.
- Help with wiring
- 93 250 exhaust
- Losing my Mind!
- Cam Chain Issues, need advice
- Do tires need to match?
- Old tires.... never installed
- No jet needles and aftermarket pipe. Buy a jetting kit?
- please help!!! '95 with idle problems (pics) (vid)
- Fuel Evaporative System
- Retrofitting an 04 with a 13 engine.
- Drive Lash and the Cush drive
- Gas question.
- Something I noticed about my bike.
- Clicking, and Squeaking noise.
- massive carbon build up on 2006 250
- Idle issues and battery problems
- Full systems
- Fork oil level
- Hole in the engine?
- Precautions to take when starting an engine that has been sitting for years?
- Gears not shifting
- Oops
- Large battery and radiator fan
- Swingarm Bearings?
- Oil Leak and Sticky Throttle
- Front brake pads/rotor scraping
- Carb hose sizes?
- No start, click from fuse box, batt is good
- 2001/1999 track/street build
- MPH are off!
- shift levers
- different style connecting rod bolts?
- Muzzy Exhaust Mounting Bracket?
- Intake valve clearance 04 Ninja 250
- Gas tank issues
- How hard can you flog these bikes?
- Questions on compatibility with 1992 model
- Ninja 250 in storage, should I light it on fire?
- Bad idea? Smaller sprockets for shorter chain
- Rearset Compatibility
- petcock doesn't turn off
- Feeling a bit cramped
- 3 Rear Wheel Bearings. Where Does The 3rd Go?
- inside id size for rear seat frame section
- Lowered Riser G Code or Specs?
- issue adjusting the valves
- Gpx 250 clutch issue (i think)
- Mods
- Bike Won't Start
- Bike dies when revved!
- EX250 shuts off at highway speeds.
- Brake rotor options???
- Cannot Get Pads Aligned with Rotor
- Weird stall problem
- New venhill SS hose is leaking at the banjo
- Handle bar hits gas tank on left side after dropped
- Front brakes getting weak over time.
- SOS ('03 ninja 250)
- New Rotors- Warped or Bed-In?
- Clip-ons levers R6 tubes 15w fork oil .75 springs review
- My replacement airfilter cover/ battery box Strap
- What tires are these?
- What do I need to bring to see if this engine works?
- Ignition Problem - Multimeter and New Battery
- Pregen Ricor Intiminator install
- Hesitation/Stumbling 6K to 8K - Looking for Source - Ideas?
- Won't run over 1k rpm
- did valve adjustment on 2006 ninja
- Rear Axle Assembly.
- 07 EX250 Flame Removal
- just adjusted Valves. ...
- stupid clutch cable question
- 01 250 problems
- 1200 miles later...
- 290cc kit any good?
- Wooden front brake feel
- Exhaust question
- Allen bolt by oil filter
- Clip ons
- Can I wait to replace my tires?
- Blinker issues.
- Valve adjust and carb sync...
- Reconnecting fuel tank, installing new levers, help?
- Check if odometer is original+plastics
- Space between spark plug boot?
- Should float height stay stock after rejetting?
- Rear Brake Question
- Engine has trouble revving sounds bogged
- 05 Ninja 250 won't start on its own - help!
- Shifting Woes....
- Front Brake, Rotor bolts rubbing, '07 250
- 2012 Fuel Gauge Install on an 07 Ninja
- Clutch Won't Disengage
- 89 ex250 crazy idle issues.
- 2000 EX250 Clutch/Gear issues after sitting
- Question about the service manual
- Recall on 05 Ninja 250R - fuel tank leak
- Ninja feels hot