- Kawasaki Website links: Parts Diagrams, Details, Service Specs, Owners Manual
- Reviews of the 2013+ Ninjette
- Side stand switch
- SERVICE manual
- Gas mileage poll for the new 300
- So I did a walk around of the 300 yesterday....
- DIY Listing for "300" specific items
- DIY: Adjusting rear pre-load on 2013+ Ninja 300
- DIY: Adding GPS and Heated Gear / Battery Tender cable
- Info on Area P Exhaust Systems for the 2013 Ninja 300
- Aftermarket Controls
- Oil Filter Wrench
- Track Tires for 300
- Clutch Adjustment
- Not a DIY OIL Change just a view and some info
- odometer too fast to rack up miles?
- Will certain parts from my old 250r that will fit the new 300?
- How to Adjust Idle Speed
- Installed Pirelli Diablo Rosso II's on my Ninja 300
- K&N Pod Filter
- Who wants to be Bazzazed?
- Can Ninja 300 ABS system from EX300B be ordered/installed on non-ABS EX300A? EX250J?
- sounds/feels different after oil change
- Ninja 300 Left part of the frame popping out.
- Fairing Alignment
- Woodcraft Clipons from 250R to 300R
- Assembly fee? Here's what you're paying for
- Ninja 300 Flat Rate Time Table
- Healtech Gear Position Install - Freakin AWESOME!
- HID Install vid - I see the light!
- Is this a legit website to purchase a service manual?
- PSI
- First Oil Change
- Ninja 300 Periodic Maintenance Chart
- Don't break the tabs! Fairing Removal 101
- EX300 Lighting System Diagram and Part Numbers
- 07 GSXR600 shock installed.
- Removing Chain Guard/Hugger
- Gearing, who picked that final drive???
- Tires and upsizing
- Tapered roller bearing conversion
- Check front brake caliper bolts
- Economy light to Shift light???
- Clutch question for the pros..
- Cat converter in the header pics?
- Stainless brake lines and MP Throttle?
- 300 weight reduction
- Bazzaz for 300
- Stalled
- Area-P tuner installed
- questions on engine management
- area p tuner question
- alternative oil filter?
- FMF ninja 300 exhaust.
- impressions on cat delete
- Room for Ninja 300 clip-ons - lots of pics
- area p tune
- 2002 GSXR caliper mounted
- Wheel Bearings: Similar to 250?
- bike dies with clutch pulled in slowing down
- Blinker Problem
- Wheel Alignment
- Buying Ninja 300
- Gearing
- SPORTISI's NINJA 250/300EFI TURBOCHARGER KIT
- "Bouncing Jitter" going to first
- Yosh rearset brackets
- Springs, who sales them and what fits?
- Front Race Tech Emulator installed
- FI on the 300 same as 250?
- First gear click
- New Ninja 300 and max cs sprocket enquiry
- does the 300 have a oil screen?
- Fork alignment
- Anyone planning to try Pirelli Angels?
- repairing bent rearset mount
- Ninja 300 Break-In Procedure
- Dan moto exhaust
- Exact length of front brake line?
- Rear Brake Bleedout?
- Fuse removal and buzzing
- 300 air switching valve and purge valve (CAL) removal
- I need a Power Commander MAP, R-77 full system
- never used 0 miles 300 engine
- Raising the rear?
- Suspension Tuning SoCal
- How do I remove the Cat from my California model?
- Oil Level
- Forks from 08-12 250 fit a 300?
- 300 Wiring Diagram
- Ninja 300 oil change
- experiment with sprockets
- Are clutchless shifts harsh on the bike?
- Gauge Mount -- Aftermarket?
- Are front and rear brake pads the same?
- Those with pod filters
- Slip on exhaust for cali model 300
- Dropped Bolt in Gas Tank? Major or Minor Issue?
- Kawasaki Faces N.H.T.S.A. Inquiry Over Possible Stalling Issue - ECU Recall
- Adjusting headlights?
- DID 520VX2-106 X-Ring Chain with Connecting Link
- Bike won't shift
- Ninja 300 Fender Eliminator Recommendations
- Maybe interesting to know?
- Important to know about the 300
- Area-P pod tune
- 300 Slipping out of 2nd and into neutral
- Synthetic oil at 300 mile oil change?
- Please tell me this isn't a brake fluid leak
- rear suspension spring rate
- 250 Pistons fit in 300?
- new tires, unstable?
- LED stop, Brake and Running lights
- LED fender elim kit gone wrong!
- De-coring a 300 Ninja stock exhaust.
- More power??
- temporary spools...almost
- Wiring Kill switch after MP throttle, anyone?
- stock end cap rusting?!!
- Using a 250R radiator in a 300
- Changed oil filter & missing washer
- 300 Autotune
- Water damage in display consol
- Ninja 300 Shorty Levers
- Front brake dragging
- To bleed or not to bleed...
- Engine dies on downshifting (after recall work done)
- Weird road feedback
- Factory Pro Detent Arm Shift Kit
- Odd sound after chain tightened
- Minor Leak: Lower radiator hose
- My bike has too many gears:/
- Would this part fit the 13' 300
- Default Whats this part called?
- Tracking the Ninja 300
- Questions for those with SS brake lines on their ABS Ninja 300
- Wiring diagram and Repair Manual
- Targa signal burnt out
- Rear seat cowl for 2014 ninja
- sidestand wiggling?
- Shop installed K&N filter backwards
- brake caliper interference recall
- Ninja 300 Service Manual?
- Frozen Kickstand Kill Switch?
- ABS on Ninja SE, suprised that is not so strong braking, is it normal ?
- What petrol for Ninja 300cc SE new
- Inverted fork conversion
- Adding schrader valves to the forks? to add pressure to the air spring?
- Conventional vs synthetic for first oil change?
- List of mods so far
- Will not start without throttle
- Diablo Rosso ll tires
- Chains?
- Fuel pump not getting power
- DIY chain and sprockets
- Windshield shimming
- 250 Inner Fork Legs?
- Choppy throttle in 1st and 2nd gear
- Clip-ons question
- Can you adjust preload without the kawi tool?
- VERTICALLY IMPAIRED ? adjustable kickstand ? Lowered raised ?
- Installed Nassert Beet 320mm Front Rotor today
- Ninja 300 Lime Green L/R Seat Panel?
- My speedo is way out!
- 18k Service
- New Ohlins rear shock available
- Short shift lever tie-rod?
- Will a 2nd gen 250 shock fit in a 300?
- air filter + slipon
- Scorpion Full Exhaust System?
- Galfer Brake Components Now Available for 2013-14 Ninja 300 Models
- 250 ninja front wheel and 300 ninja front wheel
- Took a Piece of Glass out of My Rear Tire. Do I Need a New One? (With Picture)
- Converted my 300R to handlebars
- Hindle Exhaust
- Stripping bike for race glass... noob question.
- How To Change the Oil and Filter on Kawasaki Ninja 300 Motorcycle Video Tutorial
- AFR for most power
- Better brakes??
- Chain Issues
- Ninja 300 motor/engine failure
- Cat delete + slip-on = close to full system?
- front wheel bearings
- 300 two brothers dyno
- too many wires on the battery
- Video of how to set the clock on a Ninja 300
- Are the exhaust screws torqued?
- Is the EX300 capable of a long distance highway ride?
- Area P Install
- air filter contaminated with gas
- Front Rotor Issues
- Clutch grabbing really far out!
- Oil?
- No cut frame sliders for ABS?
- Injectors' capacity? And aftermarket primary pipe diameter
- SS swing arm for the ninja 300?
- Gauge mount?
- Ninja 300 K&N Air Filter How To Install Tutorial & Quick Review Video
- chain and tire questions
- New tires (Metzler M5 Sportec)
- How to install Rear Spools on your Kawasaki Ninja 300 Motorcycle & eBay parts review!
- Service Manual
- Fast help needed! Oil leak
- First maintenance overdue???
- Fairing above headlight problem?
- 300 Exhaust Combo - FMF Header with Akrapovic slip-on
- Oil Cap Leak
- ECU Flashing
- Rotor bolt hole spacing and pattern.
- Interested in cylinder head studs?
- washer preload forks
- Dan moto exhaust
- AreaP Exhaust Fitment Issues
- Stock Ninja 300 Dyno
- Looking for stock wheel weights
- Clipons for lowering front forks instead of risers
- Inexpensive performance gain?
- How to remove stock exhaust and install aftermarket Slip-On Exhaust System Ninja 300
- All about chains
- Now I know why old3 has no balls
- Taking the fairings apart tutorial
- Passenger Peg Delete & Muffler Brackets?
- Should I change the oil?
- Anyone mounted Carburetor's to a 300?
- Ninja 300 Brake Pads and SS Line
- Squeaky Front Axle and No Front Stand
- Vent looking fairing under passenger seat
- Slip-on: Exhaust Popping?
- Ninja San
- Ninja left out in the rain, bad?
- Two brothers exhaust/OEM muffler
- Power commander 5
- Alignment off?
- Ninja 300 Smog Delete
- Rear brake reservoir bent?
- No voltage at fuse box for two fuses
- Ninja 300 Pod Install
- Integrated tail light
- Swapped chain, now have rear brake issue
- USB install on 300?
- Upgrading my tires.... soon.
- Interchangability of front/rear master cylinders?
- Torque spec cheat sheet?
- Headlight Issues
- Ninja 300 Turbo
- Helpful tools and electronics
- Signals, running and plate lights not functioning
- HELP HELP HELP!!!! I need someone to do me a favor
- quick question
- So.... I've officially ****ed up my 250...