- Mirrors
- 14.5 ft-lb... really?!?
- Area-P 18" Quiet Core SS Full Exhaust Video
- Bye Bye Rect-O-fier
- DanMoto Carbon Questions!
- Engine-to-Header gaskets (NewGen)
- Full exhaust for around 400 or less
- Front Brake Pads, change
- Front Signals.
- service advice
- How much for a "loose" fork oil job? Springs?
- Muffler for around 200 to 300
- Exhaust/Shimming/FI question..
- Individual Jets?
- The Carb Shim
- Whistling Noise from front wheel?
- Stripped fuel bowl screw now what?
- Coolant in my Oil.. what the flip??
- Replacement fasteners (bolts and rivets)?
- Gear Shift issue
- sidewall crack
- Hotbodies Racing mgp growler exhaust
- Metal screen in airbox?
- Rear Set Bolt
- Taillight issues
- Turn Signals Stopped Working!
- 08+ Ninja 250 fork length over triple.
- HELP! idle adjustment screw came out!
- Gas cap bolts
- Gear Shifter Bent?
- Clutch slipping... how to fix?
- Koso Gauge config settings
- Frame Sliders.. yes or no.
- Turn Signal and Rear Fairing repair
- Thoughts???
- Neutral Light
- 2009 Ninja 250r with a wider tire
- Clip ons or Rear Sets?
- Rear turn signals don't blink, front turn signals don't turn on
- Fork Replacement
- How to get a 2009 250r into 6th
- AU model has different gearing? Why?
- Some Upgrades
- Front sprocket change help!
- Tyga full exhaust leak issue
- Big Gun Evo: S-Series Exhaust...Anyone heard of it?
- Head Gasket torn
- Front Fork Repair ?
- Starter Problems
- Bike Cranks but Won't Start?
- Help Getting Chain/Sprocket back on
- Another brake pads question.
- Did valves, bike won't start
- Removing ignition
- Carb Cleaning/Rebuilding Question....
- front/rear sprocket installation info
- Click/Pop response from handlebars upon unloading front wheel
- steering lock won't unlock
- Rough and Low Idle
- Exhaust and Power
- Quiet Exhaust
- Gas Leaking into oil
- best jetkit?
- Ninjette suddenly won't idle/run properly...
- Motorcycle dealership got flooded while my bike was getting serviced.
- Acceleration issues from a stop
- 2009 ninja turn signal issues
- Rear sets and clip ons
- Never using choke
- Gas Tank Petcock Problem?
- Valve Cover Block off Plates / Crankcase Breather ?
- milky/yellow oil after a valve job
- Danmoto Jisu vs gp
- Popping sound after installing akrapovic and a k&n filter
- 2008 Ninja 250r Turn Signal Connector locations
- Mismatching Tires
- choke lever
- Trying to remove the airbox....
- Problems starting engine
- Purchased used ninja... what now?
- help! need to understand about rpm
- Problems with ignition lock
- Dyno Jet Kit
- Quick question regarding fork seal job
- Removing Carb, Need Help ASAP!
- Thanks dealer!
- Shifting Questions
- Does tire need replacing?
- motor engaged in neutral
- Installing rearset, need some help
- help me map gauge wires into harness wires
- Motorcycle Stands
- I'm 0 for 2 :(
- 08+ Ninja 250 CA model Gas tank port questions (Evap System Removal)
- any DIYs forba clutch change on 08+250s?
- Reducing noise on Two bros Slip on?
- Rear Brake Caliper Help
- Non-CA Fuel Tank
- Exhaust Options
- What Shims Do I Buy?
- Stripped Allen Head
- Measuring sag by yourself?
- Need help on carb tune
- Got a gift in the mail
- Carb problem... dies when on the gas
- bigger jet
- Custom Rearsets
- TOTAL make over
- Help choosing new tires
- Factory Pro Jetkit and AFR's
- Today's The Day...
- DIY: How To Change/Replace Your Coolant w/ Pictures
- What air filter are you using?
- Seat Gap?
- Fork oil level: with or without springs?
- Noise when braking?
- Full Exhaust on EFI model
- PSI? - Pirelli Diablo II
- Muffler Replacement Interval
- Hit 10,000 miles, Painted a few things, and Modified Stock Exhaust!
- Not sure if I should be alarmed...bolt on upper triple
- Major Service
- Gas for the ninja in Toronto, Ontario
- Anything else I should do?
- Aftermarket abs...
- HELP PLEASE!!! Proton's now flashing on both sides
- Bad day at the dyno
- After Winter Problems.
- can i ride the bike with burst fork seals
- new chain
- Help, yet again 2009 ninja 250r carb or FI
- oil type, qty and automotive filter option
- Slip on exhaust?
- Power in 5th very jumpy
- K&N KA-2508 Kawasaki High Performance Replacement Air Filter - Anyone use this?
- Quick, Decent Chain Oil Option... Thoughts?
- I think my 2fiddy is in love with Mobile 1
- Shimming ?
- DIY - Motorcycle Tools
- Stalling Problem
- Help with KOSO Digital Cluster!!
- Q: How would u install Preload adjuster without front stand?
- 15/44 vs 15/45
- Running Lean?
- Finally feels like MY bike
- "Downgrade" from Yoshi can to Stock..AND I FRICKIN LOVE IT!
- 16t front/Stock rear.....
- Shimmed the carb needles earlier..
- Exhaust question??
- It IS possible to shorten the stock exhaust, while keeping the same sound.
- Rain Drenched Bike Won't Start
- Sprocket question from a newbie
- sprockets and chains
- BT-16 tire wear
- new tires
- Exhaust gasket question
- Bike Reving on its own :/
- K&n 0990 filter on fi ninja
- front brake pad problem
- rear
- HR1 Exhaust
- Tachometer not working or going crazy
- 2008+ Ninja 250 Carb Sync - Pics
- oil change question
- Mid-top end bogging down
- Seat..........wf???
- Front Brake Light Don't Work
- Bazzaz Z-Fi
- Am I too Rich?
- Friend Dumped My Bike.. Help!
- Fuel Mixture Question - Shim or Jet for this set-up?
- So I think I'm getting screwed....
- is this the right parts#?
- FI version tuning
- Looking for a mechanic or physical help working on my bike
- Hey all. Q's about front end...
- 2011/ 2012 Ninja + HMF exhaust question
- Oil pump question
- Turn Signals Only Work 75mph+
- Is it time to change the sprockets and chain?
- pre gen 15t sprocket on 08+ ninja?
- New sprockets and chain for the Ninjette
- Cheating on jetting
- what carb needle to use?
- blown transmission?
- buying new tires
- 636 fork swap
- Any advice on mods appreciated
- 15t Kawasaki OEM front sprocket
- HID issues
- Leo Vince LV One EvoII Full-System - review
- Online Parts Sources
- Popping during deceleration
- my 2010 ninja is running sluggish (HELP)
- RPM "Bouncing"
- Front Left Blinker Stays On
- Exhaust leak
- dual headlight question
- Time for new tire?
- Gearshift Lever Sticking on Upshifts
- Where can I get these lights!?!?
- Oil Leak (several big pics in here)
- wewt wewt!
- Bike not starting....
- 7500 mile service - worth it or not?
- Highway riding?
- Front caliper behavior when turning right
- Dead spot in rpm's
- missing screws
- Inaccurate Tachometer
- All Jets Feel the Same
- dyno run today
- LED Signals and resistors help
- Electrics problems (indicators)
- What is this??
- Crack in Front Tire
- fitment issue with front cowling
- Front Air Valve Stem
- what could this problem be? - indicators
- Vance and Hines CS One Slip On vs Yoshimura TRC vs Two Brothers
- Kawasaki Green Paint Color Code.
- testing pulse coil
- Benefits to jetting?
- Just got my 6k service done
- Still not running right. Quick question.
- DIY: less than $100 Clip-ons
- GP Style shifting
- How to remove the ignition (2008)
- What is the best way to straighten a bent shifter?
- Danmoto Jisu rubbing on brake line.
- 2008 Valve Adjustment
- Which of these two exhausts should I get?
- Review :: RPM G-Plus 2-way shock ...
- whats a good stand for the 250?
- Motorcycle Maintenance Book?
- Smog Block Off Plate - $10 !!!
- Mysterious electrical issue
- Speedometer cable
- Mystery Noise at 4800 RPM?
- Making a custom pipe.
- Yoshi full vs Jardine GP1 vs Area P
- Small incident yesterday: Bike died suddenly after almost redlining, started right up
- BT003RS front question
- My new Blinkers have 3 wires
- Am I done for good?
- hiding key scratches
- A part fell off while removing a body panel
- ninja keep shutting off
- Dropped Bike..Now Shifting Problems *NEED HELP*
- Aftermarket Clutch Cable