- Right turn signal dead and buzzing
- 36 hp 250 with a dodgy tune
- Carb Shim Thickness??
- what is that plastic bit at the back for?
- Trouble getting into first gear.
- What's that plug near the clutch lever for?
- SOS: Help Removing Rear Axle Boly
- Help with brake part numbers
- White smoke from crank case breather
- 15/43 sprocket combo chain length?
- steering damper
- Brake Caliper Bracket Torque...Bit Of A Weird One
- K&N air filter R-0990 drycharger wrap?
- NGK CR8EIX spark plugs. Do they come pre-gapped?
- Odometer works, speedometer stuck at 0
- Headlight plug orientation?
- Rear brake is hard to push back
- FCR 35 Carbs
- Rear set identification HELP!!
- Power hesitation when accelerating?
- Need help putting lower cowling back on
- Fuel gauge acting really weird
- Poll: What carbs?
- Serious talk, did I mess up buying this tank?
- Bike Grasping for Life
- New chain & sprocket suggestions!
- Petcock / Fuel Tap question
- High idle but drops to normal when clutch is slightly off
- ninja 250 starting issue
- DIY: Dynojet Autotune How-To with PCV
- What exactly am I looking at? ( tires)
- Missing bolt / Someone tried to steal my bike?
- Air Filters
- tweaked bars
- Help me fix my tach!
- New to bikes, what should I check [mechanically?]
- Replacement gas tank only has one hole on the side?
- 2010 Ninja 250R
- Does Ninja 250 have dual or single throttle cable?
- From sea level to 6500ft ish
- Tweaking the carburetors
- Accessory wire? or ignition wire?
- Speedometer Gear Delete?
- When should I actually call the service-limit?
- Which of the following oil would be best? [PICS]
- LEDs replacement - which electronic flasher to use?
- Lost Oil Cap
- Just did oil change - problem
- Bleeding brake ?
- Spastic backfiring followed by complete loss of power and electronics = Ninja d-e-a-d
- The Guts of the Ninja 250 gas cap lock
- Faltered, lost power, and died at 50mph cruise.
- Possible Broken Piece
- 2 different needles for a carb set?
- my front end jiggles
- carb & stock airbox troubles
- Stinks during high rev
- Why does my gas cap sing?
- Fresh tune up!
- Need some help - starting up after down time
- How can I make my bike more powerful?
- Spark plugs?
- Yet another Carb issue
- general shim under bucket question
- Tire recommendation.
- rear brake issues
- How will 2 stroke oil affect my ninjette?
- My shift lever fell!
- DIY 24 000 km service
- suspension adjustability
- Issue with headlight
- shim kit question
- Chain Adjustment
- Rear spring length?
- Tachometer problem
- Issues after 7,500 mile valve adjustment (FI model)
- replacement parts
- Sudden increase in fuel consumption!
- 2010 Ninja 250EX
- Missing essential bolt! Need help!
- ninja 250r track toy build
- How to reset the odometer?
- Dyno'd girlfriend's 250 :D
- Frame Welding -- RearSet Bolt Mount Point (08+ Ninja 250)
- 300 motor in 250 frame
- Bike stalling on throttle?
- Crackalackin
- Need Service Advice
- Buzzing sound between 6000-7000 RPM, What's wrong?
- Ninja 250 2011 Brake light issue!
- Throttle issues - Bike wants to die
- front fork disassembly question
- weird voltage/no start issue
- turn signal issue, help plz
- Got another 250...Need a little help with jetting
- OIL! 2010 Ninja 250r
- Loud crack on cold startup
- Mixture screw turns.
- Brembo Brake kit?
- Water replacement question
- Koso fuel indicator + winter = ??
- Front Brake Issue
- Fork Seal is Stuck
- PSA - Check your engine covers.
- Speedometer Question
- Main 30a fuse keeps blowing
- help! my bike is falling apart! :(
- High Idle RPM (during/after riding)
- Passenger seat lock jammed
- Ninjette stalls
- Removing rust from chain
- Kleen Air System - Breather Filter
- Engine dies during cold starts, normal?
- Yoshi Slip on Stinks
- The where to buy this engine guard
- I broke something...
- Headlights
- Rubber on rubber?
- Ninja Clutch Plates
- mystery numbers on motor
- Main jet question
- GP1 slip on
- In need of assistance - fuel / oil issues
- ninja 250r performance cdi companies
- Chain Slack
- Hub spacer sleeve size differences
- :-( Laid my bike down this morning...
- Alternative method to removing seat?
- How I fixed my AreaP can.
- 140/70-17 rear tire wouldn't fit after new chain + sprockets..
- Do you leave any fairing bolts off?
- stalls sometimes when applying throttle
- Woodcraft Rearset Issues
- plug change 2012 ninjette
- octane booster
- Putting Engine Sprockets Back In
- K&N Air filter
- bar ends....
- cold starts
- So my gauges Act up.
- Need help with rear blinkers
- whining sound
- My video on how to fix the fuel sender for your fuel gauge
- Any problem with these brake pads?
- Erratic idle
- Blown gasket?
- Aftermarket Exhaust
- gas tank removal
- carburetor dispensing gasoline. am I supposed to send back to gas tank?
- white smoke from exhaust and stall
- Shock replacement - VTR1000?
- 2010 Ninja gas leak finally spotted - help
- Shimming vs Snorkel out
- Leaking fluid... should I taste?
- Went to tinker, found some surprises...
- Comparing RPM reference points (tuning)
- draining the carbs
- shimming question
- Hotbodies BOGO deal - Northeast
- Switching to Synthetic
- Bent Front Wheel =[
- Bike won't start suddenly.
- Mechanic telling my friend he bought the wrong sprockets
- Torque spec and sequence
- Shorty brake lever
- New-gen engine in Pre-gen frame. Oil leak under exhaust ports.
- 250cc, 282cc, 300cc Motor Build Packages
- jetting question
- right fork tube seems to be leaking..
- carb removal
- New Tyres
- wheel makes a squeak
- Weak Vacuum
- Oil overfill / color concern
- Cold Weather, difficulty cranking + more
- Couple questions about shimming needles
- First Post! - What is this called? Where can I get it?
- Help picking oil and filter?
- Is there such a thing as a street-legal slip on?
- Brake lamp
- Should I be concerned?
- Need Help with chain or sprocket problem.
- Help fixing rear turn signal please
- Shimmed, Not sure if it was necessary
- Problem installing slip-on
- 09 Ninja 250R
- Heated Gear - Where Does It Connect?
- Spool size? spool bolt length?
- HID's worth getting installed?
- need help with cam timing ninja 250
- Front brake lever stiffer after heavy braking
- my girl won't start :(
- Vesrah VD250 JL or EBC FA197HH
- mysterious fuel leak
- Engine Coolants
- Stalled
- Bike doesn't want to start.
- Replacing Chain and Sprockets
- Upper fairing stay bracket question
- Fairing bolts
- leaking oil D:
- cam question
- Finally took my bike to work. PROBLEMS HELP!!
- Don't know which slip on exhaust I should get???
- Slip-On Exhaust Removal?
- TDC vs. cam position
- inverted forks
- Slip on backfires???
- Rotating brake pads thoughts
- Getting a new chain and sprocket
- HELP! Shifter linkage bolt fell off!
- leaked some coolant after redlining.
- Should I be worried?
- Ninja 250R Decals
- valve cover removed question with pic
- 2009 Ninja 250r Race Bike Rebuild!
- Gas cap won't open
- Race Bike Build
- No power when cold?
- Slip on, or full exhaust?
- Tachometer issue? Plz HALP!
- Friction Zone in the Cold
- Tires! I need suggestions. please
- Is this a battery problem?
- Dogbones length and design
- Is E 10% ok?
- Tire spec questions
- Bright red headers when idling
- top dead center question
- 15,000 mile service
- rear cowling cover over seat?
- Weird pop from the exhaust
- 88-94 cdi swap in 08-12 new gen wiring help
- Exhaust and colour combination help.
- Oil leak....
- 2012 250ES Repair Issue
- Battery weights?
- Fuel gauge backlight issue
- Piston to valve and head clearance issue.
- Sudden brake caused engine to die?
- No headlight, no neutral indicator, no start
- Drilling off and replacing bar ends
- Bike is grounded for a few days. Need some projects.
- Oil isn't draining down into oil chamber! helpp!
- fuel line under seat keeps rupturing on my 03 250
- Trouble removing valve cover.
- Major Service Oil Flushing Question
- Below freezing tonight...
- Should I adjust my valves or are they good enough?
- Fairing stay alternatives