- Grinding the shock spanner wrench for dual purpose use?
- JRI shock install issues
- Valve Adjustment: Clean cams,buckets,shims before re -install?
- Ninja 250R Ecu / start up problem?
- 2009 250r won't run without choke
- Just how noisy should valve tap be?
- Fuel coming out the carb, and bike wont start
- Speedo Cable connector missing? Koso.
- Air filter help.
- Ninja 250 Purchase Help
- New Blinkers
- Poor idle and throttle issues
- key hole loose
- Area P full race exhaust/jetting/airbox-delete/kleen-air delete..
- Wheel bearing quality
- fi light
- Is this screw with yellow paint the one for carb syncing?
- Advice on Suspension Upgrade?
- DIY - Scottoiler vSystem (automatic chain oiler)
- vacuum point - installing scottoiler
- Musarri Exhaust Slip-on mounting, sound test and riding
- How to clean carbs with a fuel treatment/seafoam??
- I'm broke down in the middle of nowhere...
- Plasti Dipped my 2010 Ninja 250R.
- Dunlop GT501?
- Michelin pilot street radials - bought em
- I may have ruined my bike, but I am still going to try to work on it myself.
- Some after-hibernation questions. . .
- Yuasa YTX9 Price Difference?
- 12v stopped working
- Removing the Kleen Air System on a stock bike
- Rear brake squeak after pad change.
- Battery effect?
- Carb float levels...
- Never seen this before with a Carby issue
- Clip On Bar Question
- new member, new bike and 10k
- Rear brakes - pad replacement
- No change after shimming needles with two washers
- budget rear shock upgrade ?
- Damaged left footrest stay mounting holes
- What would cause a good running bike...
- Swap two stock exhausts
- Plastic Rivet
- Idle issue 2008 250
- Dogbone options?
- How long until my carbs gum up?
- Aftermarket Speedometer
- Streetfighter Headlight
- LeoVince GP Corsa Slip-On?
- Speedo cable only works when it's warm??
- Kawahara Bore up kit 250>300
- Question about oil blend
- New Front Turn Signals Won't Work
- rejet with open filter
- buying brake pads
- stock jet size???
- adjustable camshaft timing how to.
- LED Turn Signal problems
- shortening front springs
- Plastic repair?
- Sequential LED Tail Light small issue
- Not starting easily in the morning. . .
- Wheezing engine sound and horrible idle
- Easy no tool Rattling Clutch lever or short fingers fix
- My only key is damaged and is hard to turn
- Best commuting tire
- Are the downpipes on this generation stainless?
- Front Brake is sticking...Help!
- first ningsdays ride on cold mor
- S20 Performance, and Best Tire size
- Stock Exhaust modifying ?
- New Tires: Rosso II or Michelin Pilot Street
- Short but heavy
- GSXR shock swap questions
- Question for all the tire/suspension gurus out there
- Ninja 250 Mechanic
- Ninja 500 Spring swap
- Bar Shake and Valve Stem Question
- Chain / sprocket install advice
- no spark ???
- clip ons and bar ends
- 09 Ninja 250r about to purchase. Seeking thoughts.
- GSXR Shock dogbone solution!! Cheap too!
- Chain and Sprocket Question
- Open engine for distribution chain... List of parts??
- Brake Bleeding Question
- Speedometer/Odometer Cable
- OEM signals on the back. LED on the front??
- I'm short! Anyone else??
- Dashboard blinker indicator light
- Help: Journal bearing replacement
- Not running after theft :(
- Advice and thoughts about a Free Orbit Chain.
- Need help with 88-94 CDI wiring
- Battery Replacement
- Ninja 250r replacment headlight bulb
- tire install question
- Wiring LED strips up as brake lights..
- Clutch lever light activator broke? Replacements?
- Plug and play flush mount turn signals?
- More play in throttle?
- new tires
- chain. 2009 ninja 250r
- Front suspension 2009 250??
- H7 LED Headlight options vs HID
- DIY - GSX-R Rear Shock
- Gas tank rubber mount
- Think twice before installing an extra horn
- confused about brake pads
- this could be a major problem...
- Problem after front suspension change
- engine stand
- Didn't winterize my 250!
- Ton of maintenance to be done
- Gas and Vacuum line maintenance?
- What are the best tires for our Ninjettes?
- Bent frame, what do?
- possible chain for 415 conversion people
- Now a Choke Issue
- Sylvania Silverstar Ultra vs Phillips X-tremeVision +100
- Cam chain rattle noise
- Expected lifetime for chain and sprockets?
- Add Oil Temperature Sensor, location?
- Rear caliper wont fit on disk with new brake pads
- Will loss of tread In the center reduce rain traction?
- Ninja Electrical Problems/Won't Start
- Did my 250 become a 125 (dead cylinder)?
- please help!!! wont shift.
- Anything I should look for?
- Quick Gas Cap question
- Bike Running to Lean, How Long Do I Have?
- won't go above 58 to 60 mph
- Kickstand Suggestions
- I'm at 6k miles, time for maintenance?
- led dash light problem
- rear turn signals
- 2009 Ninja 250R: Need help identifying this part
- Fuel/Oil leak, only when raining?
- Help! I'm an idiot!
- "scratching" noise when driving, depending on the clutch
- Quick question
- Battery Tender Quick Disconnect Plug with USB Charger
- Bike feels a little "rough".
- Ebay clip ons installed
- Odd question, which gas cap to buy?
- Oil pressure switch and banjo bolt issue
- Please help me to identify my spark plug color
- Technical specifications/information needed
- Dirty Carburetors? Nope! What could it be
- Rear sprocket bent chain adjuster
- Front end "clunk" after drop
- Help please :)
- 2011 Ninja 250 stalls when given too much gas
- Shimming Needles Ninja 250
- help! choke problem?
- Electrical Stator Specs
- 2 hoses and chain
- Vance & Hines CS One Urban Brawler Exhaust on 250R????
- Michelin Pilot Power Tires
- Sprocket Replacement?
- Air filter question
- Speed! Help
- Oil filter question
- Turn signals problems!
- Cost for dealer service?
- New Bike - Ready to Mod
- Flashers, fuses, other electrical garbage
- Shimmed my needles, but didn't need to.
- ninja 250 won't run video included
- Bike Question
- 08+ Ninja 250 Motor Engine Stand ?
- brake issue
- Losing power at full throttle
- Avon Roadrider AM26 ?
- need gearing help!!
- Can I purchase rubber mounts that hold the fairings together?
- head lamp and pilot lamp query
- HR1 Exhaust on Aftermarket headers?
- Front suspension maintenance?
- 150/60/17 rear tire do i need to change the front
- Self chain adjustment
- Aftermarket Headlight Install HELP
- Not Sure What This Is?
- no cut frame saver no instructions
- Breather and vacuum identification and routing help
- Where do these vacuum hoses go?
- Is This OEM?
- Danmoto Jisu install problems?
- radiator hose size?
- can't figure out what is wrong!
- Well this will teach me.....F***!!!!!
- Rear wheel clicks while rotating on stand.
- Ran out of gas
- How difficult is it to take the throttle off the handlebar?
- The puzzling demise of my Oil Drain Plug Socket
- TERRIBLE THROTTLE FROM 1,500-6,300 RPM help!!!
- Modified stock exhaust
- Mirrors: how they're held in and pivot
- carb question
- K&N air filter street use
- airbox realignment problems after carb removal
- Front brake master cylinder
- Weird observation, hoping someone knows a fix
- Getting around to replacing my forks this weekend. What should I know? Tips?
- Changing cam chain
- I highly Despise my Carbs!!
- Unique problem with LED indicator/tail light
- two extra screws
- Oil filter crosses over with Honda filter
- new springs, emulators, springs sound noisy?
- Hose clamps on Nylon T?
- De-Winterizing.. Oil Change
- changing tires
- Worst Exhaust Leak Ever
- 40K mile service questions
- Is it normal for oil to increase a bit in the crankcase after an oil change?
- Sprocket sits in Cush drive, but there's wiggle room.
- Weird chain noise.
- Dented carbon muffler
- A couple silly questions
- 15 tooth Front sprocket
- 08+ Ninja 250 Flywheel Puller Questions
- Woops
- The luck of the Irish that I do not have
- replacing chain and sprockets
- advice: sprockets
- Did I mess up my clutch?
- Help me keep them from totalling my bike!
- Tire Suggestions
- The heck is wrong with my oil?
- 09 model hose pointing downward and other stuff.
- 250 won't engage to 3rd
- mmmmmmmmmmmm.....new parts
- Pilot jet O ring and washer diameters?
- Rear sprocket question
- New sensor data readings
- Oil filter - o-rings?
- Trying to figure out crappy gas mileage
- Larger rotor with Brembo 4 pot caliper
- Screws for front brake fluid reservoir
- Bent woodcraft rear sets
- Best way to repair fairings?
- Full throttle kills bike, throttle lag response.
- CA Emissions removal
- Chain sounds like it has excess slack but...
- Please Help! I'm an idiot without front brakes!
- slip on exhaust?
- Bike bogs down at 9K
- L shaped hoes?