PDA

View Full Version : 2008 - 2012 Ninja 250R Tech Talk

Pages : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 [23] 24 25 26 27 28 29 30 31
  1. swing arm covers? chain cover? shift lever?
  2. 2010 ninja Motorcycle not cranking problem
  3. Blinkers not blinking Hallllp!
  4. Question about what tools to get. Total newb.
  5. Anyone try these out?
  6. Fender eliminator kit help!
  7. Do fork legs from old gen fit new gen?
  8. URGENT - need opinions and help
  9. Yoshimura TRC Full System Exhaust
  10. Counter balance shaft side clearance
  11. Engine Acting Weird - Randomly Cutting to Low Performance
  12. Rear seat / Seat cowl raised?
  13. New blinkers, did all the wiring but confused with load independent relay flasher
  14. What does this do
  15. My newest project: '08 Ninja 250
  16. Tach/RPM won't light up
  17. Finally done with maintenance/improvements! Thank you to everyone!
  18. I can't remember what I did exactly!
  19. Problem with exhaust
  20. need help changed ign.switch,no start
  21. Engine turns over, no spark
  22. Comparing the 250 and 300 motor/engine (picture intense)
  23. Comparing the 250 & 300 motor/engine (Version 2)
  24. What woodcraft clipons do i need?
  25. Dash lights flickering no starter ?!?!
  26. too short to ride =( seat shaving anyone?
  27. battery/electrical issue
  28. gas tank pet cock issue!! help!
  29. Turn Signal Fell Off !!
  30. Rear Brake Bleeding Trouble
  31. Replacement battery for J-series
  32. Raising the bike, removing lowering links! [HELP]
  33. I don't know how to explain this.
  34. Low and mid range bog.
  35. 08 ninja pinging after oil change
  36. Finally got around to removing the forks, but missing one tool..
  37. Another Pitbull pin/adapter question
  38. Should I grease forks before putting them on?
  39. Front Brake Lever Wont Activate Brake Light
  40. Compare 08 and 12 Ninja 250 Stator and Rotor.
  41. Another bike will crank but won't start thread...
  42. Two Brothers Slip on missing bolt
  43. Can you notice when the valves need adjustment, or is it probably late, then?
  44. Mismatched Tire sizes...
  45. 2008 ninja 250r carb problem
  46. 282 build w pics
  47. Chain broke while riding- sprocket help needed
  48. Mid pipe options
  49. Fairing alignment issue - HELP PLEASE (video)
  50. Shifter Linkage Screw Up
  51. Michelin Pilot Street, any experience with good pressures?
  52. Price for installing stock links
  53. aftermarket Valve springs and retainers.
  54. Parked my bike for an hour and came back to it leaking fuel
  55. Koso radiator hose adapter
  56. 2010 Ninja 250 Tach/sputtering problem
  57. Need Repair Advice
  58. my new race fairing stay
  59. Carb cleaning with a WaterPik as an alternative to spray/dip/soak?
  60. Another "sync board" DIY
  61. Steering Wobble Around 50mph
  62. Back - Sport demon, Front - diablo rossoII. What do u think?
  63. Throttle stays open and won't return to closed position.
  64. Carb warm up shortcut?
  65. You got me on this one...?
  66. Uhh...My cams do not fit?
  67. 2012 ninja 250R tire options
  68. couple of issues
  69. OEM turn signal not staying in place
  70. gas gauge issue
  71. Front and rear axle on 2010 Ninja 250
  72. need some advice- replacing the chain
  73. Gas smell and erratic idle
  74. 2009 Race Build
  75. Front Fork Noise and Wobble
  76. Radiator hose into metal tube, why?
  77. CDI replacing BRT i-DTIS with Programmable or Non-Programmable?
  78. torque
  79. need some advice - finding the right chain
  80. My shifter be getting stuck lately
  81. Need wiring help for new turn signals
  82. Tail Light and Front Turning Light Install Help
  83. Different take on a quick action throttle.
  84. Turn signals went out and the dash indicator as well
  85. My torque wrench never clicked...
  86. sticky hot clutch
  87. so who would like to setup my suspension?
  88. GPS mounts?
  89. 2010 ninja 250 wont stay on!
  90. Increased vibration
  91. "Steels"? Definition anyone?..
  92. Hooked up a wide band o2 on the 250
  93. What exhaust is this?
  94. Exhaust clamp for O2 sensor?
  95. replacing front wheel bearing question
  96. Bike won't start !HELP!
  97. Coolant drain bolt. desperately need help
  98. top of spark plug stuck in coil
  99. Rear shock too stiff
  100. replacing exhaust cam with intake cam
  101. Spark plugs, which and why?
  102. Pro's and Con's of fork swap???
  103. What is the rear bulb type?
  104. Steering stem bearings- Grease or no?
  105. I effed myself pretty good this time.
  106. opening my petrol tank with key.
  107. DIY - eBay Steering damper install.
  108. How do you guys bleed your brakes?
  109. Had to jump-start the 250 after killing the engine when putting down the side-stand.
  110. Lets talk carbs and carb mods
  111. Tire options
  112. Tank Rust Spots
  113. bolt size
  114. Coolant drain plug thread size
  115. Helmet Lock
  116. motor replacement
  117. Rear brake line specs
  118. Need help washing
  119. How do I remove this
  120. bent shifter pedal
  121. Stupidest Move Ever
  122. 15 Tooth Front Sprocket is My Bitch Please look at pics
  123. Ebony Black touch up
  124. KLEEN & CA emission removal?
  125. starting up probs
  126. Stuck ignition lock
  127. Headlight bulb replace
  128. Does anyone know the bolt size so I can put mirror block off plates on?
  129. Please help! Forgot hose connections to gas tank
  130. new rear shock swap... perhaps i went a little too far?
  131. rear brake
  132. Mismatched tires?
  133. Do I need to replace my front tire?
  134. Turn signal lens/diffuser?
  135. Weird noise when shifting to first gear
  136. CV (or other) carb guru's
  137. Coolant Cap
  138. Took tank off and disconnected many things, now bike won't stay on.
  139. Rear Brake Problem
  140. My new Ninja 250
  141. 42T rear sprocket installed
  142. 2012 ninja 250R ignition coil question
  143. New Rear Brake Setup Advice Needed
  144. Ninja 250 bogging/stalling issue
  145. Engine overheating, something to be concerned about?
  146. broken fairing nut
  147. Replacing CA gas tank help needed
  148. Shift Linkage coming unscrewed
  149. What is the biggest
  150. Removing thermostat
  151. Is there a DIY for keyless ignition?
  152. HMF Slip-On Exhaust Video - Startup, Revving, & Fly Bys on 2012 Kawasaki Ninja 250R
  153. Bottomed out my forks the other day..
  154. New here, question about temp gauge
  155. Frame slider question
  156. Suspension Upgrades - For a skinny mof**ka
  157. 600 mile service opinions please
  158. Oil Filters for 2012 Ninja 250
  159. Radiator
  160. tire alignment
  161. Chain too tight
  162. Bike won't start. Dash lights up...sometimes..
  163. Tach/RPM gauge needle wobble
  164. Chain and how to tell if it needs replaced
  165. Need new battery,
  166. Side mirror moves down at high speeds! Help!
  167. Removing the carb-without removing airbox?
  168. How to remove the carbs
  169. 335cc
  170. Torn Off Rearset
  171. Rebuilding brakes: tools?
  172. Valve Adjustment Video?
  173. 15 tooth sprocket
  174. Finally GPS'd the 250r
  175. Warning: Another Turn Signal Question
  176. Just cleaned carbs - now stuttering at low RPM, fine at high RPM
  177. Which AreaP?
  178. Motor struggles when I give it throttle
  179. how to wire LED license plate lights from stock cables?
  180. 08 Ninja won't turn over
  181. R6 Shock?
  182. front brake issue
  183. Drilled exhaust
  184. dan moto xg1
  185. Changing to 15t gear
  186. 7500 Miles Check up!
  187. Chain and sprocket question
  188. Humming sound!
  189. CARB Dropped and Busted Fuel Inlet - Suggestions?
  190. Wider tire in the back?
  191. New member in need of help! - bike won't start
  192. Stubborn nut won't come off
  193. Wheelie on little Ninja?
  194. Brake Pads -review
  195. The Oil Change fiasco
  196. Signal problems
  197. Light bulb and Gauge bulb options
  198. new 2012 250 Ninja moans??
  199. how to remove rear seat without key?
  200. Tail light works, Brake light NOT SO MUCH :(
  201. Ways you secure second helmet to bike while riding
  202. 16T front sprocket
  203. Frame slider installation, few things I'm checkin on.
  204. MGP growler vs yoshi, what do you like?
  205. Tire facing the wrong way
  206. Changing out the fairing stay. How much of a pain is it to do?
  207. DIY Keyless Ignition for 08 250
  208. Will drilling holes result in lost power?
  209. Throttle Cable Snapped while on Interstate
  210. valve clearance
  211. Inside your head: Porting
  212. Shifter over rotates (also means I can't upshift)
  213. Bike doesn't go straight? Also bike is ticking?
  214. Brake Rotor Weights
  215. Turbo250.com - My Turbo Build Blog
  216. My 250 Wont go more than 55 mph...!!!!
  217. What are these brackets for?
  218. How to know you need your valves adjusted?
  219. Headlight mount changes?
  220. 08 Ninja 250 "bucking" at Wide Open Throttle
  221. Hitting the rev limiter
  222. Mechanical questions after lowside
  223. Gas Tank Taking In Too Much Fuel
  224. Interested in cylinder head studs?
  225. CVMA Race bike build - buncha questions
  226. Good cheap brake pads if you need some!
  227. Another idle thread
  228. 2012 NINJA 250 Engine Knocking/rattling?
  229. Need some wiring help/ HID's not working.
  230. vortex rearsets
  231. How to tell if your clutch is slipping?
  232. Help me identify this small engine part!!
  233. Idle is all wonky
  234. High Rev Jerking
  235. Spark Plugs....
  236. Help Identify hose.
  237. Stalling on throttle.
  238. Name that sound
  239. Need help on model to order parts
  240. Interchangeable Transmission Parts
  241. Woo hooooo! New tires!
  242. - - -Bike Wont Start - - -
  243. dealership dropped a $900 bomb on me today
  244. Front end wobble or bounce... ?
  245. Handlebar Mount Bolt Missing??
  246. countershaft balancer question
  247. Top Speed
  248. Gas and oil tanks are still hot an hour after bike is off. (Normal?)
  249. Aftermarket levers clutch safety switch easy fix
  250. chain came off while riding