- Pod or replacement filter
- Chain problem??
- Bike starts better cold than on a hot day?
- Engine bogging at speed. Sometimes wants to die at idle
- rubber isolator on rear shock
- Front end crashed. (pictures inside)
- Rear shock Preload for 2up?
- Low end adjustment help
- Bike shut down at 82 mph??
- China handle bar replacements
- Zero Gravity Double Bubble or Corsa windscreens?
- Hong Kong Rotors... Got Em'
- Tire Upgrades
- Bike tops out at 60 mph
- Color Code of my bike?
- size of jets with full leo vince
- Lowering Links (Cheapest alternative)
- Yoshimura fender eliminator install question
- fork oil question
- about self install clutch cable
- HELP... NEED a very important measurement
- Rear Shock Leaking
- 2012 Oil Filter Cover
- Flasher issue
- Help!!!!!!!! - bike won't start
- This is embarassing
- Oil light and fast stopping
- Suzuki GSXR 600/750 Shock Install
- chain and sprockets replacement
- Can you crank a bike without carbs in it?
- Blowing tail fuse after changing brake light.
- Vibration Around 8k RPM
- Slight Gap After Reinstalling Fairing
- Corbin seat, just bought
- Carb to Intake rubber boot clap leaking
- What would you do with this frame (sliced in two)?
- Ninja 300 rim
- Did I screw up my carbs?
- Tires make a squishing sound
- Turn signal won't blink
- is this normal?
- Dunlop Roadsmart 2 (Or other SPORT TOURING tires)
- Full exhaust and intake suggestions
- 7" touch screen for guages
- 250R Buyer's Checklist
- High Speed Miss Under Load
- AVT Integrated Tail Light/Fender Eliminator?
- Throttle sticking, need help
- blinkers work sometimes
- Sea Foam, back fire?
- questions about sh*tty starting
- Need new brakes!
- Hand grips?
- Help! Bike won't go anywhere!!
- Front brake bleeding problem
- Electrosport Stator
- What is this thing called?
- Oil Level Rising and can not diagnose
- 13.5:1 compression ratio kits
- Installing a 49-state tank on a ca model 08 ninja 250
- Has anyone used the Uni Air Filter Service Kit or something similar?
- Bike stand necessary during storage?
- wobble at different speeds
- Handling problems
- Got some work done
- Airbox to Carb Connection
- Went to change my brake pads, but had some issues installing the news ones.
- Fork alignment
- Problem starting bike
- Aluminium Triple clamp
- high rpm issue
- 08 has low power and will not rev past 10k
- Oil in my airbox
- 2009 ninja 250 blinker probs
- Radial caliper and Master Cylinder Installed
- Pilot Street Radial from Michelin - Review
- Rear shock question
- Need part numbers for 250r spring/intiminators!
- Parts
- Oil Recommendations
- I want to rip someone's throat out with my teeth! !
- Right turn signal doesn't blink when clutch in
- Gas coming out of overflow tube. Engine not starting.
- Looking to Buy a 2008 250r. "Not running"
- Bike idles higher when leaned over on kickstand
- Some terms that I don't quite understand
- The amazing Hulk and Batman begins
- Copper shavings in my oil screen
- Ninja 250 Exhaust System Question
- Carb issues?
- Thermostat on 2010 Ninja 250R
- Dying at idle with choke off
- Replacing Dash Lights
- Pirelli DR2s are great, but...
- Idle RPM higher than stable when first started, then goes back down?
- Idle Strangeness
- Leaking oil where there shouldn't be any
- Stator died on my '11 two fiddy
- Need Help Diagnosing Bike That Wont Run
- 2009 Ninja 250 won't run
- Going back to stock
- Help!! My engine runs great but no power output!
- Problem synchronising throttle body vacuum
- Changing brake pads - can't get enough space to reinstall
- Swingarm Maintenance!
- Oil Pressure Light Staying on at Start Up
- Directional bulbs
- Emulators worth the money or are springs good enough?
- Gixxer rear shock question - rear stiffness too high
- service manual
- Gas Leaking - 2008 Ninja 250
- Noob question- turn signals
- valve adjustment shim
- 2009 Ninja 250r starting problem (with videos)
- cool looking pre load adjusters
- Advice while bike is torn apart
- LCD Display Question
- Loose vacuum line. Major backfire.
- winterize 250r
- Needles and Clips
- DynoJet or Factory Pro?
- 250 engine with a leo vince 300 gp full exhaust???
- OEM Tail Light Wire Gauge
- Is it necessary to fill up with oil for winter?
- Any ideas?
- Stock exhaust with jetkit
- Camshaft Chain Tensioner
- I desperately need hellppppp
- valve inspection
- 2009 Clutch Cable
- Some Wiring Help Needed Please
- 2008 Coolant in Oil? | First bike! Need some suggestions
- High Revs on Start-up - FI Model
- No power ... in the rain
- '10 Ninja 250 Not Firing on One Cylinder...
- Sputters When Warmed Up
- popping noise
- Getting adhesives off your finish safely
- 09 Diaphram issue, pics inside. HELP
- 2008 Ninja 250 rear suspension lowering
- Getting more gutless by the month wtf?!
- Crash Pads for ninja 250r 2008
- spark plugs
- Uninstalling A Lowering Kit
- Oil Change and Other Winter Prep
- Do it myself or take it to the dealer? 7500 Mile Service
- Tire Change Time
- ticking noise
- fan noise when the bike is on
- Transmission clunkyness and slipping
- Clutch return issue
- Has anyone measured the ACTUAL compression ratio?
- Ninja 250 Service Question
- Carb sticking
- No acceleration
- so these wouldn't work?
- Fuel line came loose from somewhere?
- Looking to buy an exhaust system
- Engine swap 2010 Ninja into a 1997
- Fork / Wheel Crash Quesiton
- Anyone try these radiator hose kits?
- Handlebars Wobble when no hands :confused:
- Radiator Leaking
- HR1 Exhaust on Aftermarket headers?
- Oil and coolant leak
- "RACE" rear brake reservoir delete?
- New to forums and motorcycles, but need help with tach issue :(
- Winterizing Question
- Race-prepped 250 GSXR shock swap question
- Hot Restart
- Vortex to possibly make a 420 kit for 08+ 250r
- Another tire thread - rain version
- Amazon Danmoto "sale" if you can wait
- Need your help mixture screw base on this spark plug
- Brakes and rims / wheelsets
- Ninja 250 Streetfighter Build
- brake lines help!
- How do I disconnect this electrical connector
- Are these rear tires okay???
- Why are the newgen headers so far from the engine?
- Mah baby has a cold
- 08 250r issues
- Lighting, clutch adjustment and more
- Attempting to change oil, huge accident happened with coolant. Kinda important.
- My ninja won't turn on.
- Replace Fuel Gauge with Fuel Light?
- Any DIY's on fitting a PC5 to my ninja 250 ?
- AreaP Exhaust on the way, Port Gaskets?
- 08 stumbling and not moving hard
- 7500 mile inspection
- Indicator Problem - Turn Signals Not Working
- Troubleshooting my Ninja
- Dead batteries - your experiences...
- Indicators Solid after replacing with OEM...Relay?
- Possibly shot battery
- Tire sizes/tire brand???
- Engine Block off plates
- Can I used a M1-104 oil filter?
- carb prob on 08 , wont start
- Can't get front sprocket cover off
- Clutch cable length and bead size?
- New bike won't start. PLEASE HELP!!
- Removing Snorkel+Areap+Dyno (Fuel Injection)
- Thoughts on 13/47 , 14/47 Sprockets ?
- MMG Stainless and painless
- Is my brake lever too soft? Help!
- Ninja 250r jetting question
- Fairing Painting Question
- 2009 Ninja 250 Fairing Rivets Size??!!
- Has anyone done a starter motor change?
- Rear shock linkage spacing.
- Chain for Sprocket Configurations
- It happened after 40,000 miles....
- Stubborn Bolt
- Oil filter o-ring different sizes??
- Difference between these two PC5's ?
- Torque values for areap 12' ?
- ConRod Babit bearing failure
- Possible Shifting Issue
- She sounds great !
- Bike starts, but starter clicks anyway?
- Help me! (Carbs)
- front left shift lever bracket ?
- Please help!
- 250R wont start
- Bike shuts off immediately after starting.
- Boring the 250r
- Ecotrons map
- 2011 Ninja 250r Gauges Not Working
- Need help and advice please?
- After jetting bike idles low?
- Got map for bike.. still need dyno?
- bike idle and throttle issue
- Exhaust systems, slip-on or full?
- New stones
- No power after cleaning jets
- 2012 dashboard glass and face
- A Few Questions About Replacing Brake Rotors
- do i have the stock piping?
- Track Bike build questions
- 2010 Ninja 250 Leaking Gas
- Clutch cable
- Coolant Problem
- no turn signals working
- 18,000 miles on my bike... valve and other stuff
- Diagnosing possible electrical issues
- Shifter spring to tighten pedal/lever?
- How much fuel Stabiliser?
- What are these airbox hoses for?
- Stock Needle Size?