- Is my clevis shot?
- fork seal 2012 Ninja 250r
- Bike lost power this morning
- 2008 250 - Front sprocket retaining washer
- Another Carb clean quesiton.
- Effects of leaking fork seal
- Lots of water in gas tank
- Leaking oil?
- Another chain question..
- Speedo needle going crazy
- Koso Oil temp. sensor
- Sudden engine bog / throttle non-response
- DAS BOOT!!!!!
- Tachometer on 2011 stopped working
- What's the deal with this air box?
- Stacking valve shims
- 2008 Kawasaki Ninja 250r H7 Adapter/Socket
- Carb'ed 250R idles but stalls on rev
- 2008+ OEM dog bone/links length
- turn signal woes
- Chain life?
- Looking at Suspension upgrades New Gen
- Stock exhaust. Shifting time questions.
- Barnett Clutch Kit
- How much should the front end move when sitting still?
- Takes a lot of effort to push the bike
- Dog Bones
- Loss of power on hills/rev and it stalls
- need some help with bike
- Pirelli Demon
- Do I need tires?
- Front and rear sprocket offset?
- Running rich - will removing snorkel help?
- universal speedo problem
- Crankshaft rotational direction
- Bogs from 2000 to 2500 rpm
- shift lever travel
- Main Fuse (30a) blows when attaching rectifier
- Rad Cap - Same as Honda Civic?
- Hole in the bottom next to oil filter
- How long does the exhaust end can usually last?
- Gettin' some work done!
- Seafoam in the carb float bowls?
- up jetting ninja 250 09
- Aftermarket tach
- various help: radiator cowl panel, rear seat cowl
- Any way to adjust throttle cable?
- won't start - no green light (2012 250r)
- ninja 250r anybody have race pegs fitted?
- Black paint coming off muffler!
- Pipes/Exhaust
- why did my bike stall?
- Will it fit? Throttle Cables Edition
- Mix and Match Kuryakyn grip internals?
- 250/300 engine tips/advice?
- Fork Springs and Emulators
- Ticking noise... at lean angle?
- Time to Tinker
- sounds like a squeaky fan belt at start up
- Help! Slipping clutch??
- Stand
- What PSI for Pirelli DR2 R and Supercorsa SP F
- Damsel in Distress!
- Ninja 250r won't go past 75 mph max
- wheel bearings
- speedometer sticking
- Any tips or video install tutorials for a full exhaust?
- A Couple of questions
- Start Issue
- Alignment after lowside
- Help please!!! Clutch cable
- DIY Removing and replacing spark plugs
- My Dyno Baseline
- Itty-bitty tires
- Wiring schematic question
- 2009 250 ninja foggy oil indicator window.
- Tyga header/midpipe with other muffler......
- HELP! Bike coughs sputters almost shut off but then ran
- need help
- Need suggestion FP needles 2 times hotter
- Important part, I guess :)
- Can not remove the front sprocket guard
- Bike chain broke while riding. Can't shift.
- Brake pad change
- Bike feels like it rolls with friction in first with clutch in
- Bush mechanic attacks! Help needed with prev owner dodgy fix.
- 2011 Ninja 250r RPMs... Im a newb.
- So I need tools. Is there a tool kit I should start with?
- CNC High Lift Clip ons, Good or bad?
- Chain wobble left to right
- Coolant Issue - White Crystals
- Ninja 250 stalls when giving throttle
- Ninja with a different wheel
- Need New Rear Shock
- Bike won't start...
- How short a commute is too short?
- Clear tubing compatible with brake fluid
- Propylene Glycol
- Front brake lever doesn't return to original position
- Riding with choke
- Can someone explain tire choices to me?
- Ignition coil cylinder 1 calcined ... Reason ?
- (Re-)Pack Jardine RT-5 Slip On?
- Anyone make a new valve adjustment video?
- Throttle Stopped Working
- Help, Bike won't shift in to 3rd or beyond
- 2010 Ninja 250R - Idle / throttle question
- Shimmed needles and died on me while riding
- Will it fit?
- 2010 Ninja 250R RPM question.
- 2012 Ninja 250R (EX250JB) Engine Harmonic
- Extra hose? (Reconnecting the gas tank)
- oil leak at output shaft
- 2012 Ninja 250R Sprocket Change
- returning to stock ride height
- air filter with 12k miles on it, look see
- Custom-made Mirror Extenders
- Headlight Connector
- Fuses for Headlight, Tail light and Gauge lights.
- my 08 ninja 250r wont run after it was tipped over
- radiator hoses and o-rings
- Throttle butterfly? Throttle doesn't snap back
- new tires
- Stripped HEX bolt on rear caliper bracket
- RPM idle ranges and results after changing (help)
- 12 ninja 250r dan Moto k&n filter stock airbox
- 10 250r replacement forks
- transmission
- engine idles ok but sometimes won't rev
- Replacement cdi/ecu ideas
- Owner manual ( yes i checked the sticky)
- Handlebars slightly to the right when wheel is straight
- 8k mile oil change?
- Cheap but quality sprockets, chains, tires, etc
- Tyga full exhaust system?
- China rearsets any good?
- Ninja 250 Mobil 1 Racing 4T 10W40 Oil analysis
- coolant filter?
- Distance between forks and header?
- Chain & Sprocket?
- I think my frame is bent.....
- Bike won't start again
- Splicing wires
- Clutch Change Help
- Bent forks or something else after crash
- does my chain seem too tight?
- swingarm, tie-rods, rocker arm maintenance
- Front Radial Master Brake Line Setup
- 5mm overbore
- Start in Gear
- Winterizing Bike
- price for dat good neck?
- Rough acceleration
- Akrapovic silencer bolt
- Fixing bent Clip ons?
- extended swing arm and fat tire
- Coolant drain bolt sizes?
- 2009 ninja 250 starting issues
- Intermittent gauges
- Track Clip On Configuration ?
- torque specs
- DIY: New Gen Automatic Cam Chain Tensioner Rebuild
- Shortening Upshift throw
- Rosso II Cold Tearing
- steering head bearing race driver
- slight movement in calipers after removing
- Back light above number plate
- Rearsets - any one experience with these types ?
- Raising the gas tank
- Headlift Stand
- Turn signal wires?
- 250r feels slower than my buddy's 250r
- Need help installing all balls streering bearing...
- How do I put my 2008 Ninja 250r on front and rear stands?
- Will the 300 front end fit on the 2008-2012 250?
- jetting air filter and exhaust question
- First time winterizing my '08 250r. A couple questions...
- Battery polarity crossed during a jump start.....bike dead :(
- MPG nuances
- Frando Brake Calipers?
- Need some tire advice
- Tank Lining
- Cam Chain Question and CCT
- How have the 2008-2012 models turned out for dependability?
- 250r Completely dies on Freeway
- Rpm real slow to come back down after giving it some throttle
- How long do you leave your battery tender on?
- Four way led signals
- Fuel line issues w/pics!
- Bike won't crank, lights come one, replaced battery and solenoid starter.
- Race Prepping - Slow Build Thread
- Tanks for your help!
- Blackstone Oil Analysis
- Spark plugs Questions
- I don't know where to locate, it's N250 vs. N300
- TOO Loud DanMoto GP Carbon
- radiator issues
- front fork caps
- New bike, shotty electrical work
- How will the 250r do in a shed for the winter?
- Needed ignition, I'm new already been vandalized,take down,now attempted theft
- koso rx2 09 ninja 250
- Muting Slip-on affects performance/carburation?
- Backfire during accel -- too lean?
- Airfilter box bolt issue.. Please help.
- 41078 Replacement (i.e. the speedo gear assembly)
- 95-07 CDI on Ninja 250R 2010
- Lighting Issues. Flashers/Turn Signals Help.
- "Lil Miss" got cranky and stumbly
- 2011 Ninja 250 oil question
- Having some issues
- exhaust issue
- Stupid grip question
- $25 DIY Oilchange
- Wheel lift jack help
- Tires.... again.
- Rear brake lever hitting M4 exhaust
- 40 -45 mpg?
- New and CCT issues ?
- Gas tank removal
- I need Detail 2008 gas tank routing..
- Coolant reservoir hose routing?
- Chinese fairings?
- 2 more q's. Carb removal and clutch switch
- Re-doin Valve Seats
- Project Ninja 282cc
- Potential 250 purchase!
- Front fork not moving freely after cleaning
- is it only me ???
- Knock-off exhaust?
- Mothracing rearset bracket from club512
- 250 track bike project
- At wits end trying to bleed front brake after new line install
- Stock Wiring Harness Weight??
- Fiberglass repair tips?
- What's an average '08 Ninjette worth?
- Hard to downshift any ideas why?
- aftermarket turn signals
- 09' Ninja 250 Running On One Cylinder
- Will a 2 brothers slip on for a 300
- At my wits end.....bike will not start
- Rear brake dragging
- Question about adjust idle mixture screws
- Can I use different brands of the same weight fork oil in each fork?
- Clutch switch delete.
- Odd turn signal issue
- FI Light of Doom
- Ninja 250 running poorly
- New low-mileage engine from auto/MC recycler
- 2012 Ninja 250r running problem and white smoke from tail pipe.