- opinions on setup?
- 2008 Kawasaki Ninja 250r (multiple issues)
- Bike Hesitates to Start Without Throttle Input
- New engine installed... no signs of life. I'm stuck.
- Lowest Shim Acceptable?
- Brake Rotor Diameters
- Ninja 250r Stock Exhaust Mod
- Bike died ?????
- What octane gas do big bore high compression guys run?
- Low Compression? (Bike runs rough)
- Too much gas, float needles failed, petcock failed
- Loose cable in trunk?
- Way too many RPMs on choke (FI)
- carb question
- HD clutch springs?
- Loud knocking coming from lower in the engine
- Cracked Speedometer Lens
- Shooting for 48HP
- Bike starts and grumbles to a stop
- Fuel Cell Swap
- 2nd gen 500 triple clamp question
- Kick stand
- Are the ignition coils grounded?
- Engine revs issues
- Help please. No headlight or turn signals
- Hello world!
- throttle cable adjustment
- neutral delete?
- HORRIFIC WHINING FROM ENGINE AREA (Not Tank)
- Scary incident, what happened?!?!
- No brake light but tail light works
- Fork seal driver: what size?
- Front end bump / jittering.
- affordable exhaust
- Needles Shimmed, Snorkel NOT Removed
- Question On Cleaning The Carbs
- aftermarket LED turn signal does not blink
- Bent frame holes for footpeg
- Center stand?
- video recorder any idea?
- How am I doing with this rejetting?
- carb removal/cleaning
- Need a new rearset (rear brake peg bracket). Where to find?
- Need help. Handle bar bent
- Having trouble removing rear brake caliper...
- Recommendations for new tires
- Confirming rear wheel size & width
- Really need help with carb sync and pilot screws!
- 2010 250R Smell from front end
- Engine wants to die when I give some throttle
- Engine oil from walmart?
- 2012 Ninja 250 Carb issue?
- Miles per gallon ?
- Shift Lever
- Horn not working, not fuse.
- Front and Rear Stand Question
- LED turn signals?? Help.
- How to add chain links?
- Lag in throttle, cleaning carb, some weirdisms
- Bike not starting after carb clean
- need help plz my bike I'd sucking right now
- Bike dies with throttle after carb clean..what to do?
- Adjusting clutch.
- Low power and slipping into neutral.
- Bike only starts in neutral??
- Best way to paint the 250?
- Can I get a stock bike or two to check something for me?
- I lost a screw...
- Is this possible?
- Circe 2.0
- Correct shims?
- Got the carbs back on..need help diagnosing if im rich or lean
- Backoff XP?
- tire size question....
- Is This Normal?
- Help on deciding which jet kit to acquire
- Feedback on slip on exhausts
- Question about idle mixture screw and low idle flux
- clutch switch AGAIN!!!!
- Dashboard electrical problem...
- sprocket changes on the 250 ninja
- Got a jet kit...need some helo
- Need help identifying oil leak
- Changing levers - any traps in that ?
- Help noobie question.
- What's the deal with the adjustable levers?
- Idle problem
- Rear tire?
- aggressive riding position?
- Chain Adjustment/Rear Wheel Alignment?
- Pulling bike, jumped into gear - damage?
- first ride since new levers (I have an issue)
- Engine Ice Top Off?
- Can anyone tell me for sure the interior diameter of the 08-12 fuel line?
- Carb Trouble
- Air box removed
- Slipping Clutch ?
- bleeding brakes?
- 08-12 Water pump
- I have some doubts about Valve Clearance measurement on my bike
- TYGA EXHAUST ~Question
- Removing Dash Mount
- Brake Pad Pins, OEM/aftermarket replacements?
- Is my rear suspension broken? [Photos]
- Where do I get a gas cap gasket
- Rear seat cowl issue
- Parts Help
- Fuel Injected bike - weak engine after storage
- I Done Messed Up
- AfterMarket Exhaust?
- Won't start, even with new batteries.
- New exhaust..have some questions about bogging
- Upgrading suspension
- How to properly check oil level. Best fuel octane for stock bike
- considerable amount of noise and pressure in my gas tank
- looking to upgrade my clutch springs, experience wanted!
- My bike shuts off if i throttle in neautral.
- Rear Cush drive play and bearing noise?
- My ninja losing power
- Royal Purple Oil In Your Machine?
- post jet kit issues
- Can I use my stock needles and just replace my main jets?
- Which brand of battery should I go for?
- 2012 Ninja 250R Speedometer
- How do I read where my rear shock preload is set at ?
- Carburator Work
- weird oil leak issue..fixed last problem
- Need help measuring for bent frame
- Need help measuring for bent frame
- Brake lights work but not tail light. Messing with wires makes it come back shortly.
- New guy with question!!
- Modding for power: The basics of how and why things work
- Bedding in new brake pads
- Strange tach and throttle issue
- At a loss, plea for help. Dies with load
- Looking for tool
- Suspension Setting
- can anyone tell me why this is happening with my idle?
- 140 80 17 tires
- Ninja 250 noob question
- Lowering Bike / Handlebars
- Question about jetting/altitude
- What is This? Unidentified Wire
- New owner need help! - ignition switch destroyed
- Repairing my speedometer
- Having a Problem with my turn signals
- odd feedback
- Bolts stuck on front brake caliper
- Chain Adjustment Issue
- Front End. Sonic Fork Springs
- Broke the shift rod on a lowside help?
- air box mod
- Clutch question
- Aftermarket speedometer that works with cluster (2008)
- What piece went missing?
- Left Turn Signal Issue
- Hard to Start, Rough Idle, Backfires...
- Ninja 250R tachometer problem. Please help
- New battery, changed oil....
- Stuck in neutral and sometimes pops into first, nothing seems to work
- What is this electrical connector called?
- Service Manual and Carburetor Question
- Will this bike be okay?
- so, about those carb diy photos
- Budget HP
- Gas in Air Filter
- 2008 Ninja 250r chain snapped
- Won't accelerate
- Bike stalls out instead of starting
- Where do you buy your Valve Shims?
- Removing cluster mount
- Freaking out 09 ninja 250
- RX-2NR help
- 2009 Ninja 250R Serious Suspension Damage
- CHOKING THROTTLE AT 120km?
- Won't go past 4000 RPM - Help for a non-mechanic?
- Wheel weight reduction - Help
- Where do these rubber washers go?
- Help with carb tuning issues
- Clutch cable LUCK!
- spluttering at 9000RPM
- Oil and Temp Light Stay On
- Chain jumping and causing loud grinding
- Headlight bulb sitting in loose
- New lazy owner....
- Hers vs his. V-Twin vs V-Four sound
- Rebuilding the cluster
- Need Help Getting Part# for Fastener Please
- They said "stuff a rag in where the chain disappears into the engine"
- Ninja bogging down when I give it throttle
- 08 Ninja doesn't start/crank/no lights/horn/any electricals
- 2008 ex250 engine replacing
- Sprockets
- Can not re-install carbs on ninja 250r
- carb hose assembly: where's this hose go?
- No spark, after much work, many attempts and tests
- 4k Idle after carb cleaning
- A note on Arashi 310mm rotors (Chinese ebay rotors)
- 08 ex250 - close to running, lets do this.
- Corroded Carburetor Jets
- Base gasket leak
- Higher RPMs after oil change w/ Valvoline 10w-40?
- Weird Dying Cat Noise
- Fuel starvation
- Pilot jets
- almost downed,lost consistant power, smells funky.
- 51 hp 300 went boom, graphic pics inside
- Handlebar bent/ Throttle stuck/ help a newbie
- Hi guys. A noob question
- Headlight Parklight
- Oil leak,in a need of advice
- Missing cylinder?
- New Daily Rider. Advice on all weather tires please!!
- One Way Clutch Gear / Starter Drive Problem
- Flying's Rebuild
- Needed: Side photo of 2nd gen without plastics
- 140/70 Tires
- Help !! 2008 ninja 250
- The sound of engine?
- Noisey Ninja!
- 2011 Drive Chain Replacement
- Older CDI on 09' 250r -- only sparking on one cylinder
- Help please!!!
- Hey guys! Just wanted to say I'll be joining you here instead of the pregen threads.
- No signal to coils, no spark. Replaced a bunch of parts and still not working.
- Any input on diagnostics?
- RPM Spazzing out!
- Bike died on me while riding, need help
- Manuals and K vs J!
- Want 2009 ninja 250 Parts
- Seized ignition with steering locked
- Meter light replacement
- freeze plug size
- Building into a track bike.
- Oil diagnosis
- New-Old Tach
- Rear Wheel Lateral Play
- New Bike, Understanding RaceTech Calculator
- Exhaust cracked at weld
- Repainting my bike!
- Chain and Sprocket Recommendation
- Can I still use this master link?
- Electrical Gremlins
- Wobble at high speed, and carb question...
- Check my Diaphragm!
- 2011 Ninja 250 throttle hesitation
- Missed shifts and false neutrals... or how do i work this thing??
- Removing 90 Degree Water Pipe
- Service Manual Clarification
- Cheating with Tight Valve Clearances