- Maxima Air Filter Cleaner
- Shifts "hard" in 1st - 3rd
- Oil change frequency?
- question....sliders...spools and stands
- Metzeler Z6 Interacts
- Probably the most asked exhaust question
- Question about main jets
- 49.4 mpg?
- Front fender bolt question
- Factory chain question?
- Hindle Exhaust
- Finding 1st gear?
- Backfire when letting go of throttle
- Any thoughts on the FMF Apex Carbon Ti exhaust?
- Optimal RPM
- Level in sight glass is rising!
- Checking oil level on stand
- Soupy's Performance
- DIY - Comagination Headlight Modulator Install
- bulbs
- HELP! Turn signal wouldn't blink
- What do you use to clean your air filter.
- New DIY - Getting NAKED
- keihin racing catbs
- gauge lights on a 2009 Ninja
- anyone have LOR - Level One Racing Exhaust?
- Kickstand issues?
- HR 1 Exhaust question
- bleeding brake fluid... still usable?
- Bolt size on the carb?
- center kick stand
- Problems with my bike
- Seat cowl
- New Temp. gauge needs a temp gauge!
- Which sportisi exhaust
- Frame question
- 2nd mileage check
- Ninja 250R Performance Chip available on eBay
- Kickstand safety kill switch removal?
- Puig Racing Windscreen or Double Bubble by Zero Gravity?
- transmision clunking on wheel locking ?
- Wiring a DIODE for 4 L.E.D turn signals
- lights flicker & tach bounces
- Only 2 weeks left...
- big bore
- Where are the jacking points
- Cost of rejetting?
- Air filter now or later?
- Anyone have trouble finding EBC HH Sintered Brake Pads?
- Good Times Protection Plan...
- Install fan for CDI cooling
- brake/ tire opinions
- New Kfactory front preload adjuster
- KFactory Parts for 250R - '08+
- Can I just cut the brake hose shorter to fit Woodcraft rearsets?
- Need 3mm washers for some shimming? Come get'm
- Performance Questions....
- $135 to inspect front end?
- Clean chain & lube interval
- Radiator Fan Problems
- Front fork Valve Emulators?
- How to tell if a rejet kit has been installed??
- Basic Headlight Bulb Change Help
- charging the battery
- :eek: n00b alert!!!! Battery is dead
- Market for 250s shot?
- fork tube size for clip on
- Vortex Sprocket!
- A cheap fix for broken plastics
- is a jet kit needed for
- inconsistent throttle/rpm after shimming and snorkel removal
- 5000 mile service pricing?
- What am I?
- How can I make my exhaust quieter?
- Speedometer Problems
- decel+clutch+up shift at same time?
- Choke question
- Carb Diaphragm Melted
- crooked swingarm?
- higher than normal idle speed?
- little noise when braking
- PSA: check your shifter bolt once in a while
- I think I screwed something up
- Right handlebar switches/throttle
- trouble starting...
- clutchless shifting?
- Coolant level check
- Reversed gear shift lever!?
- Keihin Needle Jet size
- Help this tard out
- Foot peg goes up.
- Shogun Sliders and Vibration
- Air Filters?
- Intuitive Frame Sliders SUCK
- warm seat cover
- tach stopped working -.-
- DIY Exhaust ???s
- New 09 questions/break in period
- Odd question
- Loose clutch lever?
- Another day, another problem (or question)
- Hard to start after sitting in 100 deg heat all day
- Modified VS stock: comparisons: gas mileage/performance
- embarrassed, help me ):
- Cant start with choke or stalls
- Shogun Crash Kit
- Sharp Rattling(sorta) Noise Problem
- A good review of the Avon Roadriders on a 2009
- Front Brake Line Length
- My bike is going to get me killed unless...
- license plate not flush stock fender
- Dark Oil?
- Rust?
- factory pro jet kit
- The fun tricked-out Ninja 250R
- Run Both Headlights?
- 70 mph
- Slip on exhaust runs hot?
- area p vs. yoshi
- Won't start
- Semi-Synthetic Oil
- Headlight Adjustment Question
- Clipon Vortex or Woodcraft?
- DIY: Installing Halos
- Need help changing back to stock exhaust.
- Mysterious Brown Hose
- Best chain
- Where to mount generic frame sliders?
- Ninja 250 Highway Driving/Top Speed?
- Tried shimming, got stuck
- Screw in the tire: need advice
- Having trouble with OEM parts diagram
- Knocking from front end
- Can any damage occur to the engine in a lowside?
- Rubber Well nuts
- cheapest place to buy Hotbodies MGP Growler exhaust?
- Would it be possible to use a different subframe
- Modded Stock Exhaust
- M80 Exhaust
- hard break in
- shogun slider inquiries
- RPM Gauge gone dead
- DIY: Relocating the rear turn signals
- DIY: Installing Mirror-Mounted Turn Signals
- HID Flicker
- Security systems that work and are easy?
- Body Panels
- Replacing the 08+ CDI with an 88-94 unit
- Clutch question
- BEET 265cc kit
- Full throttle without regripping, technique seems to work...
- Rotella T Change
- 2009 ninja. Reserve?
- high rpms?
- 1st oil change 600 miles, 2qts too much?
- Tire de-lamination?
- DIY - Replace the '08+ CDI (Ignitor) with the '88-94 CDI
- Loud noise at startup?
- Motorbikes for shorter people
- 2 Brothers Aluminum Slip
- Looking for a front fairing, where to buy?
- Sonic Springs Thumbs Up!
- Clutch cable adjustment
- 08 dies on idle now, is the carb cleaning covered in warranty?
- Bridgestone 003RS Feedback
- high pitch whine, even while riding
- Do I need a new frame?
- DIY: Exhaust Hanger (no welding)
- power loss while accelerating hard
- still debating on which sprocket swap to do...
- Ground down rear brake
- Humm/Hiss/Vibration at 9K AND Chain tightness
- Giving your lady a bath....
- Fastener Torque Specs
- What kind of Torque wrench?
- a tad bit too much oil?
- Tire options
- Installing pitbull rear spools
- fixing broken fairing???
- Air to Fuel ratio problems?
- Okay, so what's that OTHER drain plug for?
- Cover-Comp,Chain #14041
- Improperly disengage clutch ~ revs high, lower speed.
- New-gen brake pads and where to buy them?
- Installed 2 Bros Exhaust with P1 Tip
- Another Tires Question
- Helmet loop / lock
- looseness of switches on handlebar...
- So I think I am going to rebuild my bike...
- Idle weird
- ahhhh
- Neutral indicator stuck on
- Need Help - Jetting Questions
- headlight bulbs
- Spark Plug Replacement Question
- Mods, how did they help?
- 8-9k, annoying clutch lever rattle
- 15T Front sprocket is greeaaatt!
- Keyless ignition
- Need someone in St. Louis area to shimming
- Bergmen Engineering Spin-On Oil Filter Adaptor Kit
- Whats the difference ?
- Shifting without shifter!?
- yoshimura owners... i have a question for ya
- Rear Tail-Light issues!
- Need help for a jetkit!!!
- Overall thoughts on 08-09 250R
- Problem shifting up
- for the ones with clipons????
- HD Dealer for service?
- So just wanted to know who has the bigger 150mm tire installed on their 3.5 rear whee
- no horn
- Newbie with tuning questions
- Sportisi USA Rearsets - Installed and reviewed
- k&n drop in vs pods
- Overheating issues, need of help.
- Shinko 006 Motorcycle Tire
- help with jetting!!!
- DIY- Front Fork Preload Spacers
- Winterizing your 250R?
- For the electrically inclined help!
- An oil filter observation, K&N vs. Fram
- Weekend Mods
- Bike stalled at light close to home... wouldn't start for ~6-8mins.
- Steering Lock doesn't lock???
- Ft. sprocket interchangeable?
- New Clip ons
- 09 Ninja 250 Choke and Throttle ?
- Unexpected "hidden" storage space in the tail
- Noise under braking
- Rivet Replacements
- Troubleshooting Help (External Link)
- burnt chrome exhaust
- Finally!
- Principles of Modern Motorcycle Carburetor Function
- Shogun Crash Kit or Just Sliders
- How do you get your bike onto the rear stand?
- Taping up the Radiator?
- Quick way to mount tire (inflate)!
- Driveline screeching noise
- Arrrgghhh! It ain't starting right! (3,800 mi)
- Oil change
- Interesting new dyno results
- Permatex Copper Gasket Maker High Temp
- Why it's always good to check your tires before any ride...
- Left front turn signal replacement and RAGE?
- Sportisi USA clipons - Installed
- Elka 1-way Shock Review
- Chain Guide Wear
- 2008 ninja 250r turn signals rear - front