- Do I Need New Fork Bushings?
- Wobbling on high speeds.
- Decreasing RPMs at WOT After Being at or near WOT for 1 hour
- Approximate width between the 2 frame bars where the tail light sits
- Revs fluctuating when in gear and and standing still.
- Is frequent Pop starting a motorcycle bad?
- How well does the YTX9-BS OEM battery do in the cold?
- GP SHIFT
- Track Gearing
- Starter Motor Brushes Hanging By A Thread
- Suspension upgrades for Ninja 250R
- 2009 front countershaft seal
- Clip ons
- plzz help fuel hose connected to carb???
- Spark plug coil BROKEN?!?
- New Year,New noise.Meh...
- Ninja 250r 2009 Tthrottle Position Sensor
- A good replacement of spark plug and cap wires?
- Torque Spec for Front Brakes - 2010 Ninja 250
- Tank Vent Question
- New Ninja - where to get main Jets
- Squish
- Petcock Fuel Leaking, Should I Rebuild?
- Dunlop vs pirelli
- Dunlop vs pirelli
- Starter clutch
- Ninjette Fork Bushing Replacement Kit, Extra O Rings?
- 2012 Ninja 250r Indicator Problem
- Small rubber pad position
- Need help/suggestions
- Low Compression On A Cyclinder, Should I Replace Piston Rings?
- Measuring Clutch Plate Wear
- 2008 ninja 250R engine knock
- Ever seen this frame slider before?
- Kawasaki Ninja250R spark timing
- Help! Clutch Pulley on Clutch Cover Binding
- Fuel injected 08-11 ninja250r help
- Can An Intake Leak Cause Hard Starting?
- Is The Generator Cover The Same For Pre Gens as New Gens?
- 250R Engine with loud Ticking/Knocking
- Gas Cap Leak
- What maintenance to do while bike is torn down
- Sourcing 2 Gaskets inside Gas Cap?
- Leaking Carb
- DIY: 08 ZX-10r Cartridges Conversion
- Double Checking: Front Brake Caliper Pistons Same Size as Rear Brake Caliper?
- Tokico Caliper + Oem Ktm 690 Duke R Master Cylinder
- Setting valve lash with cam chain tightened removed?
- Need help troubleshooting no crank
- Messed up my carburetor and I can't figure out what this piece is. Help!
- Aftermarket Stebel Airborne Stops Working Under Hard Braking
- Vacuum line
- Carburetor issues
- Ninja 300 13+ Headers on 250
- My Air Intake Box Got Wet Inside While Riding In the Rain
- Bogging/dying on throttle
- Ninja 250r No power with ignition ON
- Replacing tires. Current sport performers?
- Brakepads
- Engine cover protection
- 2008 Ninja 250 not getting gas
- Well......Tires. Lol.
- Slight idle issue
- Stuck front sprocket
- measuring stock valve shims...
- Update on new "oem" gas cap on 2011 250R
- Odometer/Trip issue
- Issues with bike sputtering
- AliExpress Rearsets?
- Bike Died Mid-Ride
- Yet another 'bike sat, cranks but no start' thread
- V5 - Can some UK owners check?
- Right Turn Signals Staying Solid
- Welcome to my nightmare...
- Top speed of ninja 250r with full exhaust?
- Whats this part??
- My Race 250 Finally Ready
- What's a Rear Shock's Lifespan? Setting Up Rear Sag...
- Oil Pressure Hose Leaking
- Front/Rear Service Stands: Recommendations?
- Rear caliper won't go back together??
- My bike not missing bolts, is it?
- 2008 250R: Between 5th & 6th gear
- What would you replace at 8K miles?
- New brake rotors?
- Brake light issue
- Center-stand: 2008 250R ?
- Why are there 2 extra electric cables ?
- 2020 LED Light bulbs recommendation for 2008 250R
- 09 with no spark
- 5 chains in 3 months.
- Carb slide
- Supporting Engine: to install sliders
- After Air Filter Cleaning: inspect Drain Cap ?
- Tires choice: radial or bias-ply for 2008 250R ?
- Need new radiator filler neck??
- Front Brake Light Switch: 250R 2008-2011
- What is to look for in a used Ninja 250R
- Front Brake : went limp (zero resistance)
- 1988 CDI Install / Question
- Dynojet / Tuning questions
- How to secure battery in 250R?
- 300 FI retrofit...
- Missing a bolt hole?
- 2k8 ‘eating’ diodes; wont start!
- 2012 Ninja 250 Suspected Electrical Issue
- LED BULB fitment
- Sad day, dropped carbs
- 2008 ninja 250 jetting
- Japanese guy adds sub radiator
- back brake
- 08-12 Ninja 250 Petcock
- Rough running at low rpm
- gear shifting
- First Impressions - Ninja 250r
- Lost exhaust nuts??!?
- Exhaust compatibility
- Rear Brake Won't Bleed
- what maintence to do on a 65k mi. 250r
- Boiled my rear brake fluids: practicing Gymkhana moves
- NINJA 250r DEAD HELP ASAP A
- Stock Muffler Question....for a 2003
- Something emptying battery
- No neutral light and not cranking
- Not cranking - no headlights but I’ve got panel lights and brake lights
- Pics of 250 cylinders out of the block
- Trying to build a 265cc race engine
- Layed it down trying to fix damage
- Need advice on the following - Multiple mechanical issues
- Trying to pop start my bike
- 2008 Ninja issue
- candy-metallic green in S.F.
- 2009 Fan Switch
- Recommended Exhaust for 345cc.
- 345cc Cam Degree Suggestion
- Mounting 250r engine on go kart
- Gas Cap Vent Problems?
- Horrible performance below 6K RPM, especially when warm. Video attached.
- What system is this?
- oil filter bypass valve
- Muffler repack frequency
- Thinking of lowering front and rear.
- New to motorcycles, Got 08 Ninja 250, Very hard to Cold start
- Help needed on EX250
- Won't run after jet kit
- Feening for fist in the wind freedom
- Turned on key ignition switch and nothing happened!!
- Oil staying in sight glass after draining
- How to properly set the steering stem nut?
- 130/80 up front, 140/80 out back?? Anyone done it?
- Turn signal relay location in parts diagrams
- MAGURA hydraulic clutch and brake system
- Shut down on me. ( on freeway )
- Speedometer work, odometer partially
- IGNITION SWITCH BYPASS-To-3pSt
- Valve clearance question
- Will H7 LED w/ heatsink / fan module fit an 08 Ninja?
- 08 Ninja 250 Cluster Gauge clear plastic (glass?) cracking
- Choke raises revs to 2k RPM, then bike begins to stall.
- New 250 owner doing first tune up
- Remove kickstand help!
- Valve shim size question
- What's inside the stock air box?
- Woodcraft Clip ons
- Speed sensor?
- Metallic Rotational Whirring Noise - Wheel bearing?
- Oil filters that come with the correct size O ring seal?
- Reassembling Bike Fairing
- Carburetor hoses problem
- Don’t know where these hoses connect to? Please help
- Chain Master Link: Clip vs Rivet
- Light Issue
- Winter recovery
- Suspect that the sound from the exhaust is louder after 9 years / 60 kkm
- Question about alignment
- Hayabusa/gsxr front end swap
- Bike won’t stay running
- A Complete Mystery
- Amazon Frame Sliders - How to Install...
- Keep blowing headlight relays
- NINJA 400 rims on NINJA 250R?
- Battery overcharge issue.
- 09 250R possible vacuum Leak?
- Are they all the same?
- Clicking solenoid
- Z300 headlight and cluster on EX250j?
- Water in crank case.
- Symptoms of a bad Fuel screw Adjustment
- Final Drive Gearing for the Ninja 250R
- Turn signal woes...
- Wiring new speedo
- A special tool Perhaps ?
- Gauge Problems? Check for corrosion
- fairing repair ?
- Rear tire installation
- Fuel tank damper Alternatives?
- Can't get my ninja to start after carb clean
- Turn signals won’t work when I turn my front wheel to the left
- 08 Ninja 250R dies if throttle closed, will not idle
- Wiring license plate lights
- Adding a lowering Kit to my 2012 Ninja 250R
- After Lowering my 250R
- NEVER EVER clean carbs with safety wire!
- Cold Blooded Ninja ?
- Top Piston Ring which way?
- Turn signal problem
- is a Ultra sonic parts cleaner really necessary ?
- Lifting... a Ninja????
- Ninja 250r mechanical checklist
- 250 no start
- My Ninjette is a stripper now, any parenting advice?!
- Carb slide diaphrams
- Engine Keeps Dying In Wet Weather Only
- 2009 Ninja 250r NO SPARK
- 2009 Ninja 250 giving me fits lol
- Sputtering, Tach reading double after push start
- 08Ninja250R - Start up issue :mad:
- Oil filter tightness
- How hot does your bike run?
- Free spring!
- Outback Ninja Struggling a little - Similar to Detrailer's
- 2007 Ninja 250r Tire Recommendations
- 2011 ninja 250 has no spark.
- Draining carbs
- Old dairinfs on 09
- How Fast Does the Stator Charge the Battery?
- 2009 Ninja 250 theft recovery rebuild
- Fresh carbs no start
- 2008 250 voltage ?
- Which Ninja 250R Racing Cam Shaft?
- 2008 250 build
- Carb woes (hydrolocking on fuel)
- Taking throttle issue.
- Cost to rebuild carbs at dealer?
- Gas tank liner for rust prevention...
- Ninja 250r 2012 Carbs gas exhaust
- Bike hesitates around 9k RPM
- this one is plain WEIRD ! it can't do that !
- BRT- IDTIS
- Wrong carb internals? Smdh
- Turn Signal Help
- Odd LED turn signal issue
- Engine does not start
- 2011 Ninja 250 high idle
- JT Front Sprocket Installation
- pre gen ignition module suggestions
- 09 ninja 250 won't run properly please help
- Bad gas even with Sta-bul ?
- 250 cam camshafts
- safety wired master link