- Tire Pressures? BT003
- Engine Won't Rev Past 12k
- Quick rear shock question
- Power question, powerlet 12v to mini-usb power.
- vance & Hines
- Foamy Oil in Sight Glass???
- Oil Change
- Broken Tail light Lens
- Trunk won't open!!
- DIY R&G Tail Tidy / Fender Eliminator
- aftermarket exhaust?
- Replace a Headlight Bulb w/out Fairing Removal?
- New Brake Problems (Excessive Lever Travel)
- exhaust backfired?
- Front brake issue.
- tightening the brake light
- What is this?
- Should we change oil early during break-in? The answer is YES!!!
- Rough Idle
- Breaking in on the highway?
- That AirBox Sure Does Take Up a Great Deal of Room...
- Runs better in the cold? Doesn't pull, lower top speed!
- using a motorcycle lift on the 250
- '08+ CDI, anyone opened it up before?
- Thoughts on pipes for other bikes...
- Seafoam in carb?
- Mystery rpm
- Problems...maybe ya'll can help
- Where is the Oil Screen?
- Front & Rear Sprockets Q!
- Chain too tight?
- What are your shift points?
- Jetting success... kkim FTW!!!!
- Shimmed my needles and lost top end...
- License plate bulb
- Any shifting issues please tell your story
- Starter Switch
- Quick Question About Snorkel Removal
- Exhaust on a budget???
- Turn Signal Headaches
- Top Speed?
- hidden kill switch?
- Clutch Engagement Issues HELP!
- The Ram air question
- Spilled GAS on my Tank!!!
- Tail Light Bulb Change
- exhaust help
- exhaust help?
- Low oil pressure during braking
- Bike won't start
- Removing tire stem - how?
- Break in speeds!
- Disconnected my idle control cable... how to fix.
- Help with Paddock Stands??
- Installing Koso Gauges
- Iridium spark plugs?
- change oil filter, without draining oil?
- Question about the washers to use when shimming the needles
- Radial vs. Bias Ply Tires
- 10mm spool sliders not fitting
- Kevlar brake pads- any good??
- Carb screws question
- My oil change to synthetic ester experience
- Clutch adjustment bolts
- Kerosene to clean Chain?
- rear axle lube?
- Spiegler, Hel, or Galfer?
- front: 110/70/17 rear: 130/70/17 - is that our stock tire sizes?
- Right footpeg vibration at speed
- Quiet whining sound with bike off
- hayabusa lowering links for 09 ninja 250
- LOR or Hotbodies - Exhausts
- Break-in and Highways?
- Little paint marks all over the bike?
- First Oil Change Ninja 250r 2008
- Oil overfill... bad?
- Service - 250 09
- Pessimistic fuel gauge
- bike acting weird!
- What rear fender is this?
- How long will it live?
- Another tire thread.
- External, fork preload adjusters.
- Larger tyres and pressure
- Jetting Question
- dyna beads - anyone use them?
- Gear Lever Adjustment On My Ninja 250R - BIG FEET NOT HELPING!!!
- Evap line full of fuel
- Yoshimura header alignment
- Yet another cold "hard to start" thread
- Quick question on stock spark plugs
- Engine Oil Gauge
- Passenger seat
- HMF Exhaust...shimmed needles...and more
- Too much oil?
- Removing a Lowering Kit
- Importing a Canadian '09 to the US: info/experience needed!
- Pilot Screws
- Repainting the bike
- Hex Replacement Screws for Carb bowls and tops
- Motorcycle tire mounting places in Bay Area
- !HELP! Adjusting Valves issues
- Simple question about lever postition
- For the big rear tire fans
- Kleen Air Question
- Need an adjustable kickstand.
- Gas tank
- Thank you to everyone who suggested me to go with 140/70/17 Tires
- Won't start after valve adjustment
- Exhaust
- my headlights wont turn on?
- 09 replacement battery...
- cam chain tensioner question
- Bike has problems running..
- fairing assembly help
- Shogun frame slider frame bolt question
- Serious delay in gauge cluster
- Dynojet Stage 2 with Airbox Removed?
- Rubber nuts on Fairings?
- My tire question.... (Yes, again)
- Will these fix that annoying fuel cap whine???
- 150/60/17 Rear tire
- LED/DIODE question.
- Help Replacing Front Turn Signals
- AP Exhaust - stealth version
- HB MGP Growler vs. 2 Bros... yes i need ur opinion
- Swapping rear shock w/ SV650?
- DIY - Slingshot Racing Preload Adjusters
- Replacement bolts?
- emission compliant performance mods
- Coolant problem
- rear brake problem after 600 miles maintenance
- exhaust gasket?
- Attempt at disassembling CDI
- Leo Vince exhaust slip on powercommander maps
- Minor Accident with 2010 250R
- Engine braking...good or bad?
- Issue with Roaring Toyz's lower links, Needs opinion quickly.
- Something seems unbalanced... Tach needle bouncing
- My speedo is off???
- Clutch cable ever broken on a ride?
- Cylinders full of gas...is my motor junked???
- READ this before Shimming Needles - Might save a lot of pain
- Power loss at high rpm
- HB MGP Growler
- Clutch - any way to make it softer?
- What is this?
- Bulge in Tire
- Bike veering to the left... twisted forks?
- My handle bars feel like they are snagging
- Weird problem occured today at high speed.
- Mysterious problem, please help me!. Extremely POOR mileage.
- rear brake banjo bolt
- Dead-end reference in maintenance manual
- oil level always goes up ....
- Question re valve check
- Adjusting fork alignment
- Safe jacking points?
- Fuel Starvation?
- PLM exhaust system
- Sidewall Cracks
- new bike
- Rear shock squeaks
- PowerCommander V (PCV)
- slip on pipe
- BRT TIS troubles
- Stupid question after some drinking
- Tire again??
- 1000km service - valves
- using rear pegs when crouching
- Condensation in exhaust.
- 08 or later ninja 250 oil drain bolt
- Finally changed the brake pads, after 15,000 miles
- oil change
- Ticking noise on front wheel?
- Installing low volume insert (Yoshimura)
- Noob Jetting Question
- Front brake upgrade suggestions?
- Help me fix my recovered stolen bike
- LED Light Issue
- brake light issue
- Fuel Tank never get full?
- Still bogging down, what should I try next?
- Kick stand spring came off...
- Different Brake Reservoir
- Shimmed the needles, running slower
- Terrible gas mileage?
- Integrated tail light problem!
- service manual
- Ignition switch questions
- wrong oil filter for 2008 250r?
- Throttlemeister and aftermarket clipon
- Valves check price?
- Noisy Gas Tank
- Front fascia
- Another valve check thread
- To de-snorkel or not to de-snorkle that is the question.
- Lowered back, Loose steering
- Choke lever replacement
- BRT ?'s
- Handlebar risers
- fuel for temp guage swap
- Race X clipon
- How do you stop?
- High Idle RPM...
- Used purchase, tune up
- ColorRite - Kawasaki 602 Ebony, CLEAR COAT QUESTION
- Routing for 'side hose' on fuel tank
- Cam Chain Tensioner Replacement
- Shimming Needles @ NYC
- Kick Stand Solution using the BRT TIS???
- What adjustable OEM adjustable levers fit?
- Headlight alignment
- rubber garment that supports body panel screws?
- Kickstand killswitch.
- Sweeeeeet!
- shifter linkage adjustment questions (after frame slider install)
- Dunlop 501 Tyres
- Wire going nowhere!
- Suspension help
- Choke Idle Speed has Changed
- Faulty Headlight Relay?
- hard time removing the sprocket cover
- Lowering Kits and Rearsets
- Changing Spark plugs w/o removing gas tank?
- Need rearset torque values
- Wish list - Passenger Grab handles for 09' 250R
- question about integrated taillight
- Quick tip for carrying odd bits
- Buzzing noise at lower rpms?
- Motorcycle Harmony
- Custom swing arm
- advice on aftermarket front blinkers (turn signal lights)
- Oil Change gone bad?
- Late first service
- How much does a stock exhaust weigh?
- How much for tire mounting?
- Oil level, suddenly too high; coolant too low
- Help with windscreen bolt
- Spark plug reading - Large pictures inside
- Loose Tube under bike
- Tips on how to record strange ninja noise
- Help! Need a solution while on a road trip
- stock tire replacements
- Burning smell anyone?
- Loss of oil and Air filter soaked in Oil
- Kleen air system removal on CA model ninja
- LeoVince Full Exhaust, Shimming?
- Repainting brake and clutch levers?
- 7500 Maintenance Part 1 (image intensive)