HKr1
December 26th, 2008, 03:49 PM
Turn your 3rd Gen Camaro (firebird) into a 6 Speed :)
1000 OBO :D
You get:
Corvette ZF6 Speed & Bell Housing (39,000 mile + or -)
ZF6 Trans Yoke < Fits stock Aluminum 82-92 drive shaft.
LT4 Clutch/Pressure Plate & Fly Wheel - new
ZF6 Fly Wheel - used
TTA Trans Cross member
Two set's of Brake/Clutch Pedals
Camaro Master Cylinder
Corvette & Camaro Slave Cylinders
Pilot Bearing & Throw Out Bearing - new
Camaro center console plate - new
ZF6 shift knob - new
All you need to complete the install is:
Hydralic line - (to hook up to either kind of slave cylinder vette or camaro)
Modify your stock tourque arm < or get the Jeg's one.
Would like for you to pick this stuff up! Could deliver within 300 miles or so....
Or you arrange shipping/pick up after funds have cleared ;)
1000 OBO :D
You get:
Corvette ZF6 Speed & Bell Housing (39,000 mile + or -)
ZF6 Trans Yoke < Fits stock Aluminum 82-92 drive shaft.
LT4 Clutch/Pressure Plate & Fly Wheel - new
ZF6 Fly Wheel - used
TTA Trans Cross member
Two set's of Brake/Clutch Pedals
Camaro Master Cylinder
Corvette & Camaro Slave Cylinders
Pilot Bearing & Throw Out Bearing - new
Camaro center console plate - new
ZF6 shift knob - new
All you need to complete the install is:
Hydralic line - (to hook up to either kind of slave cylinder vette or camaro)
Modify your stock tourque arm < or get the Jeg's one.
Would like for you to pick this stuff up! Could deliver within 300 miles or so....
Or you arrange shipping/pick up after funds have cleared ;)