Ever since I did my Woodcraft Clip-On install, my throttle has been out of order.
Essentially, it will travel from one carb stop to the other, and back to idle, but it will also travel the other way.
So I can twist the grip downwards from idle, as normal, but i can also twist it upwards from idle, and quite some ways too.
I've taken the side cowl off and tried adjusting the nuts on the carb to move the cable up or down, but it didn't help, so I think i might have installed them wrong when I put everything back together.

Did you reinstall both cables, or only one?

installed both of them. I would just like to see how the cables go into the throttle housing and how they attach to the grip. The service manual i got doesn't show it.
There is one cable that has a curved end to it and one with a straight end.

do these help???

http://lh6.ggpht.com/_geC920GCq38/SWvYT3eTTgI/AAAAAAAACIA/VcY4tFKiVlE/s640/DSC04900-1.JPG

http://lh3.ggpht.com/_geC920GCq38/SWvYUkZZs5I/AAAAAAAACII/rHGJF3lPOL8/s640/DSC04901-1.JPG

http://lh3.ggpht.com/_geC920GCq38/SWvYVT8KWKI/AAAAAAAACIQ/Z5pE8YSx7zo/s640/DSC04902-1.JPG

http://lh4.ggpht.com/_geC920GCq38/SWvYiN7MHBI/AAAAAAAACKA/l8Ye-FWVkqI/s640/DSC04916-1.JPG

http://lh3.ggpht.com/_geC920GCq38/SWvYi4p4fbI/AAAAAAAACKI/TLdOAMlhb8E/s640/DSC04917-1.JPG

wow, that is exactly what i needed! thank you very much