yes im looking for some.. no cut frame sliders btw...

if anyone could post a link to a good deal on them thats apreciated too.

:thumbup:

Click here for a brief in the Wiki to help you decide on which ones are right for you (http://www.ninjette.org/wiki/Frame_sliders)

thanks thomas,
so far whoever wants to sell is competing with this

http://www.newenoughhp.com/parts/sliders__crash_kits/shogun_motorsports/kawasaki_motorcycle_crash_kit.html

hmm actually after that read i think ill go with intuitive... the instructions for shogun look insanely hard... knowing me my engine would probably fall to the floor...

i cant find any bar ends for the 2008-09 ninja 250.... do they make them or do u have to buy them in that "shogun crash kit set"... i cant even find any on ebay for the new models.

check on the kawi site for the other models, but I would think that anything that would fit one of the ninja's big brothers would also fit our babies...

If you go with the shoguns get them from Richard http://store.racebikerentals.com/merchant2/merchant.mvc?Screen=PROD&Store_Code=0001&Product_Code=SHOGUNKIT&Category_Code= I bought my wife's from him with shipping it came out to about what newenough wanted without the shipping.

i cant find any bar ends for the 2008-09 ninja 250.... do they make them or do u have to buy them in that "shogun crash kit set"... i cant even find any on ebay for the new models.

got mine from fatbikez.com

http://fatbikez.com/shogun-black-bar-end-sliders-fits-kawasaki-ninja-250r-2008-2009-zx6r-.html

fit just fine, they dont seem to be all that tough, material-wise, but considering its just bar ends, theres not a ton of weight on them and they slide more than dead on impact

got mine from fatbikez.com

http://fatbikez.com/shogun-black-bar-end-sliders-fits-kawasaki-ninja-250r-2008-2009-zx6r-.html

fit just fine, they dont seem to be all that tough, material-wise, but considering its just bar ends, theres not a ton of weight on them and they slide more than dead on impact

what's wrong w/ the stock bar ends? :confused:

wheni bought my bike, it had been dropped and had scarring on the levers as well. probably could bend them if hit at another angle. i figure if i drop mine, i dont want to ruin the levers some more, so these should keep that distance a bit further. especially when i plan to get some nice red anodized sport levers

ah, okay. when I went looking for bar ends, I couldn't find any that was weighted as much as the stocks without costing an arm and a leg, so stock works just fine for me. I can see if they need replacement, though.

I've been looking at bar ends lately on google and apparently a lot of them when put on a 250 have a 'gap' that's hard to get rid of? Ugh. What to do what to do :P

I just installed the shogun frame sliders today and i have to admit it was very easy to put on following the DIY from the shogun website. Did not even loose my patience once :thumbup:

The only challenging thing was to cut out the part in the counter shaft sprocket cover. I did not want to cut it like they suggested, i just wanted to cut enough to clear the bar. I was successful in cutting a perfect fit with 1mm of space so the bar does not touch the cover after several fittings and shaving with the dremel.

Congatulations Lil One on successfuly instaling your frame sliders.:thumbup::thumbup: