BKK1200rs
August 15th, 2010, 11:12 AM
My muffler is missing an end cap, it had 4 rivets holding it. Any stock end cap should fit I hope
Help Please
Thanks
Brad
Help Please
Thanks
Brad
View Full Version : Muffler end cap BKK1200rs August 15th, 2010, 11:12 AM My muffler is missing an end cap, it had 4 rivets holding it. Any stock end cap should fit I hope Help Please Thanks Brad CZroe August 15th, 2010, 12:08 PM My muffler is missing an end cap, it had 4 rivets holding it. Any stock end cap should fit I hope Help Please Thanks Brad I don't see how it's even possible to detach by the rivets without damaging it. How do you intend to re-attach? BKK1200rs August 15th, 2010, 12:50 PM Screws? or rivets, I need something to create backpressure. There is an opening all around the center hole kkim August 16th, 2010, 12:44 AM what year 250? I don't see any 250s listed in your info. :) BKK1200rs August 17th, 2010, 03:53 AM The bike is an 2003, This end cap has one screw in it an multiple holes around the perimeter of the larger center hole. The mufflers I bought must be older as they have no perimeter holes and only the center hole,cap has four rivets holding it in place Thanks Grn99Kawi August 31st, 2010, 06:10 PM FWIW... all pre gen 88-07 exhausts are the same... one hole in teh center and 4 rivets.. no holes around the perimeter unless someone drilled them.. I have some black cans I would sell cheap if you need them... some dings and dents but perfect functionally... |
|