tjkamper
August 27th, 2010, 06:18 PM
Well since I moved to Sandpoint, the ninjette never ran quite right. She had leaned out a bit and it was just not up to par. I had to rejet, so I decided that since I was doing it I would do the works. So Now I have installed a K&N R-0990 and a Jardine RT5 Full System Exhaust. DAMN THIS THING IS LOUD!
pyLUXFRM0DI
I installed Dynojet Needles at the 4th clip, 110 Keihn Main Jets, and adjusted the mixture screws way out. In all it runs 10 times better than it did, It pulls harder through the mid range and top end, but it is still lean in the low RPMs. I finally hunted down some 40 pilot jets, which was a pain here in Sandpoint. They will get here mid next week and I hope to put them in the same day if possible. If not then I will install them next weekend.
pyLUXFRM0DI
I installed Dynojet Needles at the 4th clip, 110 Keihn Main Jets, and adjusted the mixture screws way out. In all it runs 10 times better than it did, It pulls harder through the mid range and top end, but it is still lean in the low RPMs. I finally hunted down some 40 pilot jets, which was a pain here in Sandpoint. They will get here mid next week and I hope to put them in the same day if possible. If not then I will install them next weekend.