SixSigma Jet Kit
Posted June 1st, 2012 at 10:07 AM by Countersteer
The purpose of this entry is to recommend the SixSigma jet kit. I followed their directions exactly and had outstanding initial results. Without any adjustments from the initial installation I only have a slight "lean" situation in the upper RPM range. I believe the fuel mixture screws will fix this.
Here is what I did:
1. 117.5 Main Jets
2. 40 Pilot Jets
3. 2 Needle Shims
4. Drilled additional hole in Vacuum Slide w/ #59 drill bit
5. Cut off one loop from vacuum slide spring
6. Readjusted Mixture Screws out 2.5 turns
I highly recommend SixSigma based upon my initial results. I will update this after I tune the lean out.
Here is what I did:
1. 117.5 Main Jets
2. 40 Pilot Jets
3. 2 Needle Shims
4. Drilled additional hole in Vacuum Slide w/ #59 drill bit
5. Cut off one loop from vacuum slide spring
6. Readjusted Mixture Screws out 2.5 turns
I highly recommend SixSigma based upon my initial results. I will update this after I tune the lean out.
Total Comments 0