The great grab handle mystery
Being new to the 88~07 model and finding these two threaded holes in the bottom side of the grab handle, what possibility could Kawasaki put there?
After doing some research I of course found the answer in an old post: http://forums.ninja250.org/viewtopic...135c2bec2737cd
So that's what there for, very cool so all I need is a pair of bank sensor bolts. But after looking at the ones on my pegs they really did look good enough, wrong color, and just didn't seem like it would hold the hook due to its just straight.
So then I began to look at other Kawasaki bank bots, and I found the ones that not only have a ball end on it, and they are the proper color, as long as it black, and they even have red loctite already on them. So here's the pictures so all can see, the bolts are cheap enough, and it gives you two more solid points to hook or tie too.
So there you have it, mystery solved Scooby.
After doing some research I of course found the answer in an old post: http://forums.ninja250.org/viewtopic...135c2bec2737cd
So that's what there for, very cool so all I need is a pair of bank sensor bolts. But after looking at the ones on my pegs they really did look good enough, wrong color, and just didn't seem like it would hold the hook due to its just straight.
So then I began to look at other Kawasaki bank bots, and I found the ones that not only have a ball end on it, and they are the proper color, as long as it black, and they even have red loctite already on them. So here's the pictures so all can see, the bolts are cheap enough, and it gives you two more solid points to hook or tie too.
So there you have it, mystery solved Scooby.
Total Comments 0