ninjette.org - Search Results

		ninjette.org > Search Forums
Search Results

Showing results 1 to 13 of 13
Search took 0.00 seconds. Search: Posts Made By: skrymir69

Forum: 1986 - 2007 Ninja 250R Tech Talk

June 21st, 2014, 09:38 PM

Replies: 27

EX250 shuts off at highway speeds.

Views: 4,710

Posted By skrymir69

I just had this same problem. I ended up...

I just had this same problem. I ended up rebuilding the carbs 2 times and replacing the petcock. It was dying due to flooding. There was a huge piece of crap under one one the float needles, and...

Forum: 1986 - 2007 Ninja 250R Tech Talk

May 1st, 2014, 06:36 PM

Replies: 31

Won't stay running after warming up

Views: 9,465

Posted By skrymir69

I went out and checked a couple of things that I...

I went out and checked a couple of things that I found on searching the forums here.

The clutch cage doesnt seem to be the problem, I did the check and the noise stayed.

Next I pulled the cam...

Forum: 1986 - 2007 Ninja 250R Tech Talk

May 1st, 2014, 04:08 PM

Replies: 31

Won't stay running after warming up

Views: 9,465

Posted By skrymir69

Ok, Update. I followed the instructions on the...

Ok, Update. I followed the instructions on the wiki for tuning the carb.
1. adjust valves. (I figures what the heck since i am in there).
So, i put the bike back together with...

Forum: 1986 - 2007 Ninja 250R Tech Talk

April 27th, 2014, 07:51 PM

Replies: 31

Won't stay running after warming up

Views: 9,465

Posted By skrymir69

I had the bike all apart so I adjusted the...

I had the bike all apart so I adjusted the valves. I went ahead and rebuilt the carbs. One of the float valves had a big piece of junk in it. Also the PO had the mixture screws about 5 turns out...

Forum: 1986 - 2007 Ninja 250R Tech Talk

April 21st, 2014, 12:10 PM

Replies: 31

Won't stay running after warming up

Views: 9,465

Posted By skrymir69

I went ahead and ordered 2 carb rebuild kits and...

I went ahead and ordered 2 carb rebuild kits and a petcock. Should be here by Friday. So in the mean time I am going to change the oil and pull/soak the carbs.

Forum: 1986 - 2007 Ninja 250R Tech Talk

April 20th, 2014, 09:31 PM

Replies: 31

Won't stay running after warming up

Views: 9,465

Posted By skrymir69

Ok. Just had a little while to mess with it. I...

Ok. Just had a little while to mess with it. I ran it until it died. It seemed to take a little while longer this time, so I am thinking its carbs. I pulled the plugs after it died and they are...

Forum: 1986 - 2007 Ninja 250R Tech Talk

April 20th, 2014, 04:48 PM

Replies: 31

Won't stay running after warming up

Views: 9,465

Posted By skrymir69

The petcock seems fine. I put an inline filter...

The petcock seems fine. I put an inline filter on the fuel line so i could see if fuel was getting to the carbs and it is always full. Plus I pulled the drain plug on the right carb and got a ton...

Forum: 1986 - 2007 Ninja 250R Tech Talk

April 20th, 2014, 12:37 PM

Replies: 31

Won't stay running after warming up

Views: 9,465

Posted By skrymir69

The motor does spin fine when turning it over...

The motor does spin fine when turning it over after it dies. I dont think the oils is really a problem. If it was to thick, the problem would be when it was cold, not hot.

I will run it 1 last...

Forum: 1986 - 2007 Ninja 250R Tech Talk

April 20th, 2014, 11:59 AM

Replies: 31

Won't stay running after warming up

Views: 9,465

Posted By skrymir69

I will recheck the voltage. It was 13.5 while...

I will recheck the voltage. It was 13.5 while running. I did not check if it went up while revving. I assumed the battery was good because the voltage was the same after the bike died when I first...

Forum: 1986 - 2007 Ninja 250R Tech Talk

April 20th, 2014, 11:34 AM

Replies: 31

Won't stay running after warming up

Views: 9,465

Posted By skrymir69

Not sure on the oil. I was going to change it...

Not sure on the oil. I was going to change it after it was running correctly.

I will check the spark after I get it warmed up. But i am thinking of tearing into the carbs anyway

I cleaned...

Forum: 1986 - 2007 Ninja 250R Tech Talk

April 20th, 2014, 11:04 AM

Replies: 31

Won't stay running after warming up

Views: 9,465

Posted By skrymir69

I could see one bad coil, but both? I...

I could see one bad coil, but both?

I will check the plugs again. They were the correct nice even tan when I replaced the old ones. The bike is bone stock. But i am thinking of pulling the...

Forum: 1986 - 2007 Ninja 250R Tech Talk

April 20th, 2014, 09:02 AM

Replies: 31

Won't stay running after warming up

Views: 9,465

Posted By skrymir69

Thanks yep, I have adjusted it down and up. The...

Thanks yep, I have adjusted it down and up. The adjustment works fine. Its just a problem after it warms up.

Ok. I will pull them again. I dont believe I checked the inlet finger...

Forum: 1986 - 2007 Ninja 250R Tech Talk

April 19th, 2014, 08:08 PM

Replies: 31

Won't stay running after warming up

Views: 9,465

Posted By skrymir69

Won't stay running after warming up

Hi, sorry to have to use my first post to ask for help, but it seems like if i can get help anywhere on the net, it is here.

Ok. So I have a 2003 EX 250R that I picked up for cheap because the...

Showing results 1 to 13 of 13

Forum Jump

All times are GMT -7. The time now is 12:36 PM.