ninjette.org

Go Back   ninjette.org > Search Forums

Showing results 1 to 25 of 1000
Search took 0.04 seconds.
Search: Posts Made By: DannoXYZ
Forum: 2018+ Ninja 400 Tech Talk September 18th, 2020, 07:47 AM
Replies: 5
Views: 118
Posted By DannoXYZ
Azn400 Any more news on this smoking? Forgot...

Azn400
Any more news on this smoking?
Forgot to mention to check if O2-sensor is fully tightened. Might want to remove, replace crush-washer and re-install.
Forum: 2008 - 2012 Ninja 250R Farkles September 18th, 2020, 07:41 AM
Replies: 20
Views: 4,033
Posted By DannoXYZ
Ah, good point about night vision.

Ah, good point about night vision.
Forum: 2008 - 2012 Ninja 250R Farkles September 17th, 2020, 06:14 PM
Replies: 20
Views: 4,033
Posted By DannoXYZ
Also note that human eyes responds differently to...

Also note that human eyes responds differently to different wavelengths. It's most sensitive to range that sun puts out, around yellow-green band of spectrum. LED lights tend to put out light in blue...
Forum: 1986 - 2007 Ninja 250R Tech Talk September 16th, 2020, 05:02 PM
Replies: 39
Views: 637
Posted By DannoXYZ
No base-setting for idle. Just whatever position...

No base-setting for idle. Just whatever position is needed for proper idle-speed of 1300 +/- 100rpms. Follow JKV's procedure:



So order is:

- mixture-screws for highest idle-speed + 1/8...
Forum: 1986 - 2007 Ninja 250R Tech Talk September 14th, 2020, 09:29 PM
Replies: 39
Views: 637
Posted By DannoXYZ
Looks like stock setting is 1.5-turns out on...

Looks like stock setting is 1.5-turns out on mixture screws.

All over the place because you keep on adjusting idle-screw. Leave that alone and learn to use choke lever.

1. Cold start - 3/4 to...
Forum: New Members September 14th, 2020, 08:27 PM
Replies: 4
Views: 85
Posted By DannoXYZ
Greetings & Salutations Casey !! :wave:

Greetings & Salutations Casey !! :wave:
Forum: 1986 - 2007 Ninja 250R Tech Talk September 14th, 2020, 01:43 AM
Replies: 5
Views: 126
Posted By DannoXYZ
Unless you’ve disassembled carbs down to each and...

Unless you’ve disassembled carbs down to each and every individual component and scrubbed, poked and flossed them, along with replacing all rubber O-rings and seals, your carbs are not factory-fresh...
Forum: 1986 - 2007 Ninja 250R Tech Talk September 13th, 2020, 07:05 PM
Replies: 5
Views: 126
Posted By DannoXYZ
When it dies like this, is typically caused by...

When it dies like this, is typically caused by dried chunks of petrol varnish being dislodged and clogging bleed-holes in pilot-jet, and/or emulsion-tubes and/or carb-venturi. Note that spray carb...
Forum: 2018+ Ninja 400 Tech Talk September 13th, 2020, 06:54 PM
Replies: 5
Views: 118
Posted By DannoXYZ
Hi Duc & welcome to Ninjette! :wave: White...

Hi Duc & welcome to Ninjette! :wave:

White smoke is usually coolant. Typically from cracked head or blown headgasket.

Does it come out of body of O2-sensor? Or the threads? Or out end where...
Forum: Motorcycle-related September 13th, 2020, 02:31 PM
Replies: 3
Views: 116
Posted By DannoXYZ
Question on how mufflers are aligned. Are they...

Question on how mufflers are aligned. Are they parallel to each other on each side? Or are they splayed outwards slightly like stock system?
Forum: New Members September 13th, 2020, 02:29 PM
Replies: 8
Views: 151
Posted By DannoXYZ
Greetings & Salutations! :wave: That’s...

Greetings & Salutations! :wave:
That’s awfully sweet looking bike!
Forum: 1986 - 2007 Ninja 250R Tech Talk September 12th, 2020, 02:38 AM
Replies: 13
Views: 228
Posted By DannoXYZ
Here’s how to test and measure petcock. Engineers...

Here’s how to test and measure petcock. Engineers didn’t come with this just for fun. The numbers make a difference and pinpoints what’s wrong. And tells you exactly how to fix it.
...
Forum: 2008 - 2012 Ninja 250R Farkles September 11th, 2020, 09:52 PM
Replies: 12
Views: 160
Posted By DannoXYZ
True, could that one be defective?

True, could that one be defective?
Forum: 2008 - 2012 Ninja 250R Farkles September 11th, 2020, 03:51 PM
Replies: 12
Views: 160
Posted By DannoXYZ
Easiest way to tell is to disconnect one of...

Easiest way to tell is to disconnect one of blinkers. Easy enough to unplug rear one with seats removed. Then turn on turn-signal for that side and see if it blinks at double-rate. If so, it's not...
Forum: 2008 - 2012 Ninja 250R Farkles September 11th, 2020, 03:50 PM
Replies: 12
Views: 160
Posted By DannoXYZ
Not necessarily. Third leg typically is just...

Not necessarily. Third leg typically is just inverse of 2nd one. Here's electronic flasher relay that'll work.

https://www.amazon.com/dp/B0711LR54B

Remember you also need 2 isolation diodes to...
Forum: New Members September 10th, 2020, 10:41 PM
Replies: 16
Views: 315
Posted By DannoXYZ
Heh, heh... this was back when Hancock Towers had...

Heh, heh... this was back when Hancock Towers had their disastrous dominos windows! And then next year, Charles froze over and I got to ice-skate on it!
Forum: 1986 - 2007 Ninja 250R Tech Talk September 10th, 2020, 10:33 PM
Replies: 14
Views: 188
Posted By DannoXYZ
Hi Alan and welcome to Ninjette! :wave: ...

Hi Alan and welcome to Ninjette! :wave:

Could be many things causing you out-of-petrol symptoms. Could be pinched or leaking vacuum line going to petcock. Could be clogged fuel-line between...
Forum: 1986 - 2007 Ninja 250R Tech Talk September 10th, 2020, 09:54 PM
Replies: 39
Views: 637
Posted By DannoXYZ
Ok, this is close to stock behavior. Don't adjust...

Ok, this is close to stock behavior. Don't adjust idle-speed, use choke instead when it's cold start. That's why there's choke-lever on left handlebar. Then by next stop-sign when it's starting to...
Forum: 2018+ Ninja 400 Tech Talk September 10th, 2020, 09:44 PM
Replies: 2
Views: 158
Posted By DannoXYZ
Awesome guide, thanks!!! :thumbup::bounce::bow:

Awesome guide, thanks!!! :thumbup::bounce::bow:
Forum: 1986 - 2007 Ninja 250R Tech Talk September 10th, 2020, 10:53 AM
Replies: 39
Views: 637
Posted By DannoXYZ
Yes, getting 1/2 of typical mileage is sure sign...

Yes, getting 1/2 of typical mileage is sure sign you're dumping too much petrol into engine. If you're already at less than stock adjustment on mixture-screws and it still appears to be too rich, it...
Forum: Cargo Space September 10th, 2020, 08:37 AM
Replies: 6
Views: 295
Posted By DannoXYZ
I think I need to get saddlebags! Just lost...

I think I need to get saddlebags!

Just lost a rain jacket I carry in backpack. I zipped up backpack so ends meet in middle. However, wind spread them apart and opened up backpack!! Going to try...
Forum: General Motorcycling Discussion September 10th, 2020, 08:25 AM
Replies: 5
Views: 250
Posted By DannoXYZ
RIP. That’s the way I wanna go!

RIP.
That’s the way I wanna go!
Forum: 2008 - 2012 Ninja 250R Farkles September 10th, 2020, 08:22 AM
Replies: 4
Views: 163
Posted By DannoXYZ
There’s also this one:...

There’s also this one: https://www.ninjette.org/forums/showthread.php?t=312482
Forum: 1986 - 2007 Ninja 250R Tech Talk September 10th, 2020, 07:54 AM
Replies: 39
Views: 637
Posted By DannoXYZ
As reference point, my commute to SF is roughly...

As reference point, my commute to SF is roughly 35-miles. I get 230-260 miles between fill-ups on tank from my ‘02.

I start on full choke, then turn it off completely when I’m on hwy about...
Forum: 1986 - 2007 Ninja 250R Tech Talk September 9th, 2020, 09:11 PM
Replies: 39
Views: 637
Posted By DannoXYZ
During carb-cleaning, did you make note of pilot...

During carb-cleaning, did you make note of pilot jet sizes? Are they stock?

Without disassembly, perhaps experiment with leaning out mixture. Reduce mixture-screws by 1/2 turn and do test rides...
Showing results 1 to 25 of 1000

 
Forum Jump




Motorcycle Safety Foundation

All times are GMT -7. The time now is 04:39 AM.


remote server monitor
Powered by vBulletin®
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Except where otherwise noted, all site contents are Copyright 2019 ninjette.org, All rights reserved.