Forum: The Ex-Ninjetters Lair
November 4th, 2016, 08:21 AM
|
Replies: 8
Views: 3,131
|
Forum: Ninjettes At Speed
December 30th, 2015, 06:43 AM
|
Replies: 16
Views: 3,688
The switch is on the clutch lever perch with a...
The switch is on the clutch lever perch with a little plunger that makes contact with the clutch lever. The switch will just have two wires and if you remove the left switch cluster and all wiring...
|
Forum: Ninjettes At Speed
December 28th, 2015, 09:33 AM
|
Replies: 16
Views: 3,688
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
November 9th, 2015, 01:55 PM
|
Replies: 32
Views: 3,389
When I first got my 09 ninja 250 it acted just...
When I first got my 09 ninja 250 it acted just like you describe, struggling to reach 60mph. I went through the carbs twice, replaced plugs and air filter with little to no improvement. Then I...
|
Forum: Items Wanted
October 8th, 2015, 12:10 PM
|
Replies: 4
Views: 808
|
Forum: The Ex-Ninjetters Lair
September 23rd, 2015, 11:25 AM
|
Replies: 57
Views: 6,442
|
Forum: Ninjettes At Speed
September 22nd, 2015, 05:33 AM
|
Replies: 17
Views: 1,799
|
Forum: Motorcycle Gear
September 22nd, 2015, 05:23 AM
|
Replies: 8
Views: 1,423
I live a few miles away from the US distributor...
I live a few miles away from the US distributor of RS Taichi, Motoliberty in Dallas so I get to see all their products first hand and they are great. Many of the racers in our club including me wear...
|
Forum: Ninjettes At Speed
August 26th, 2015, 07:03 AM
|
Replies: 1,183
Views: 221,074
|
Forum: Ninjettes At Speed
August 26th, 2015, 06:04 AM
|
Replies: 1,183
Views: 221,074
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
July 1st, 2015, 12:06 PM
|
Replies: 8
Views: 2,506
Buy more individual shims. Also check the shims...
Buy more individual shims. Also check the shims you removed from the engine. The marks are probably worn off but you could measure them with calipers. One of those from the other cylinder might be...
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
July 1st, 2015, 06:08 AM
|
Replies: 12
Views: 1,749
With the battery and battery box removed you...
With the battery and battery box removed you should be able to slide the airbox back about an inch. Might also have to loosen some hardware for the under tail. Still difficult but much easier to...
|
Forum: The Ex-Ninjetters Lair
June 29th, 2015, 07:25 AM
|
Replies: 11
Views: 1,890
Got out to MSR Cresson 1.7ccw again yesterday...
Got out to MSR Cresson 1.7ccw again yesterday 6/28/2015. This time got my usual 2 hours of track time and had a beautiful sunny day with temps reaching 95 and low humidity. With a refreshing breeze...
|
Forum: The Ex-Ninjetters Lair
June 22nd, 2015, 02:54 PM
|
Replies: 11
Views: 1,890
|
Forum: The Ex-Ninjetters Lair
June 22nd, 2015, 11:09 AM
|
Replies: 11
Views: 1,890
We were on the 1.7 ccw member day. The R3 did...
We were on the 1.7 ccw member day. The R3 did very well against the rc390 (street not cup bike) but is was completely stock and could have used much stiffer suspension for the rider. The 390 was for...
|
Forum: The Ex-Ninjetters Lair
June 22nd, 2015, 07:37 AM
|
Replies: 11
Views: 1,890
First track day on Yamaha R3
I was going to post this on the R3 forum but I like this forum much better :D,
Took the R3 out to MSR Cresson yesterday, and had a blast! Been looking forward to going all week and the weather...
|
Forum: General Motorcycling Discussion
June 17th, 2015, 09:13 AM
|
Replies: 4
Views: 738
I've spent many afternoon's going up and down...
I've spent many afternoon's going up and down that road. Originally from San Pedro so I know exactly how fun those turns are.
I would always cruise through at legal speeds first to look for...
|
Forum: General Motorcycling Discussion
May 6th, 2015, 11:09 AM
|
Replies: 358
Views: 42,642
The plan is first get the suspension dialed in...
The plan is first get the suspension dialed in for me then I can start doing track days with it at MSR Cresson and can start comparing lap times with the N250. I Already have some sticky Pirelli...
|
Forum: General Motorcycling Discussion
May 6th, 2015, 05:50 AM
|
Replies: 358
Views: 42,642
|
Forum: Ninjettes At Speed
March 13th, 2015, 07:17 AM
|
Replies: 444
Views: 94,873
|
Forum: Ninjettes At Speed
March 12th, 2015, 02:12 PM
|
Replies: 444
Views: 94,873
|
Forum: 2013 - 2017 Ninja 300 General Discussion
March 11th, 2015, 12:23 PM
|
Replies: 30
Views: 5,564
I guess I have too much money then. That's the...
I guess I have too much money then. That's the remote reservoir Ohlins I've been running for the last 2.5 seasons. Just had it rebuilt and resprung during the winter too.
Works well, and easy to...
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
February 20th, 2015, 01:06 PM
|
Replies: 25
Views: 4,993
|
Forum: Free stuff!
January 27th, 2015, 12:32 PM
|
Replies: 14
Views: 4,463
|
Forum: New Members
October 26th, 2014, 10:12 PM
|
Replies: 13
Views: 562
|