ninjette.org

Go Back   ninjette.org > Search Forums

Showing results 1 to 25 of 1000
Search took 0.02 seconds.
Search: Posts Made By: Bob KellyIII
Forum: Cargo Space Yesterday, 01:07 AM
Replies: 3
Views: 4,785
Posted By Bob KellyIII
hay Philip ! I think you may need more support...

hay Philip ! I think you may need more support under that box buddy !
bumps are the enemy of baggage carriers they have a tendancy to rip out bolt holes and
do strange twists at the same time... I...
Forum: Cargo Space Yesterday, 12:39 AM
Replies: 57
Views: 23,767
Posted By Bob KellyIII
here's a pic of My cheap answer to the baggage...

here's a pic of My cheap answer to the baggage delima....
it's a plastic box from harbor freight tools bolted to a rack that I bought off Amazon
although I haven't really loaded it up and gone for...
Forum: New Members Yesterday, 12:31 AM
Replies: 7
Views: 534
Posted By Bob KellyIII
Welcome Danny ! glad to have you here ! there...

Welcome Danny !
glad to have you here ! there is much knowledge burred in this site ! I would be lost without it.... so far I have found everything I needed to know about my 2012 250R here !
and...
Forum: General Motorcycling Discussion November 28th, 2022, 01:43 AM
Replies: 3
Views: 99
Posted By Bob KellyIII
well I got the dirty little things out of...

well I got the dirty little things out of there..... I only hurd one pop while getting them out so I should only have one fairing to repair.... I didn't bother to look at it by then I was disgusted !...
Forum: General Motorcycling Discussion November 27th, 2022, 05:25 PM
Replies: 3
Views: 99
Posted By Bob KellyIII
never thought about drilling them out as they are...

never thought about drilling them out as they are right next to the front forks... and there is little room but I can take a pocket knife and cut them off...
it's difficult but it can be done
I...
Forum: General Motorcycling Discussion November 26th, 2022, 10:20 PM
Replies: 3
Views: 99
Posted By Bob KellyIII
Plastic button screw things GRRRRrr.

does ANYONE have a solution to this problem PLEASE ?!?!?
under the front wheel on my 2012 250R ninja is 4 plastic push in buttons that have a plastic screw that goes into them to lock them in...
Forum: General Motorcycling Discussion November 25th, 2022, 11:32 PM
Replies: 0
Views: 108
Posted By Bob KellyIII
Easy to read Wiring Diagram for the CSC RX4

I doubt many of you guys have an RX4 but On the china riders forum many do
but their Administrator is so "UN ABLE" or un willing to increase the file size
there that I cannot post it there....so it...
Forum: General Motorcycling Discussion November 25th, 2022, 05:49 PM
Replies: 7
Views: 376
Posted By Bob KellyIII
that's a real good bike for a gal learning I...

that's a real good bike for a gal learning I think ! I think you might be able to lower the seat on those I know you can on another one "Monkey" I think it is.... they just position it high at the...
Forum: Riding Skills November 24th, 2022, 07:29 PM
Replies: 43
Views: 21,290
Posted By Bob KellyIII
In addition to my previous post here .... you...

In addition to my previous post here .... you NEED to keep your arms fairly loose or relaxed but totally in control if you hit a patch of sand in a corner and the wheel suddenly turns to the left you...
Forum: Riding Skills November 24th, 2022, 06:47 PM
Replies: 43
Views: 21,290
Posted By Bob KellyIII
:doh: Well there are 2 sides to this argument...

:doh: Well there are 2 sides to this argument being relaxed while in an emergency situation means you will have a slower response time than if your all keyed up and tense like getting your hands up...
Forum: General Motorcycling Discussion November 24th, 2022, 05:06 AM
Replies: 5
Views: 393
Posted By Bob KellyIII
LOL I hear that alot.... it's no big deal I can...

LOL I hear that alot.... it's no big deal I can touch with the balls of my feet etc.etc.
push your bike backwords in uneven ground while sitting astride it if you can...
it is more important than...
Forum: General Motorcycling Discussion November 23rd, 2022, 05:59 PM
Replies: 25
Views: 559
Posted By Bob KellyIII
ok I put the TT250 all back together and gave her...

ok I put the TT250 all back together and gave her a run.... it ran great no flat spots anywhere and she pulls much harder than she did stock ! I came back home and pulled the spark plug to check the...
Forum: General Motorcycling Discussion November 22nd, 2022, 07:20 PM
Replies: 25
Views: 559
Posted By Bob KellyIII
well I went out to the shop and put the charger...

well I went out to the shop and put the charger on the almost dead battery again...
turned on the gas and choke and it cranked a long time and only fired every once in a while. (not like it had been...
Forum: General Motorcycling Discussion November 22nd, 2022, 05:38 PM
Replies: 25
Views: 559
Posted By Bob KellyIII
Thanks Danno...... but that link didn't work ! ...

Thanks Danno...... but that link didn't work !
yah I've never really liked J.B.Weld as it stays too runny for too long
it's fine for repairing aluminum side plates though.... never had that fail...
Forum: General Motorcycling Discussion November 21st, 2022, 10:12 PM
Replies: 25
Views: 559
Posted By Bob KellyIII
well, I took the bike back into the shop and took...

well, I took the bike back into the shop and took the seat off it and lifted the rear of the gas tank and heard a snap/pop and I thought ooooh darn it ! I keep forgetting that fairing connection...
Forum: General Motorcycling Discussion November 20th, 2022, 05:19 PM
Replies: 25
Views: 559
Posted By Bob KellyIII
Well, I put the TT250 all back together and ran...

Well, I put the TT250 all back together and ran it up to the end of the road and back ( a whole 2 ~3 blocks) after idling it a very long time.
it definitely has alot more bottom end but there is a...
Forum: General Motorcycling Discussion November 19th, 2022, 12:21 PM
Replies: 25
Views: 559
Posted By Bob KellyIII
Hay Danno what is this wide band O2 sensor you...

Hay Danno what is this wide band O2 sensor you are on about ?
Never owned one before, but it sounds like it would be a good thing to have !
gott'a link ???
Bob......
Forum: General Motorcycling Discussion November 19th, 2022, 12:18 PM
Replies: 25
Views: 559
Posted By Bob KellyIII
Ok that's a good point Jim ! dually noted ! ...

Ok that's a good point Jim ! dually noted !
although throttle position USUALLY corresponds with RPM.... but that is not always the case....:doh:

in this case throttle position is above idle...
Forum: General Motorcycling Discussion November 18th, 2022, 09:48 PM
Replies: 25
Views: 559
Posted By Bob KellyIII
LOL I figured out how I'm gunna do it ! .... I...

LOL I figured out how I'm gunna do it ! ....
I found a piece of 2" PVC pipe in the back... I cut off about 18" of it and took that piece into the shop.... I then cut wedges out of it in 3 places so...
Forum: General Motorcycling Discussion November 18th, 2022, 03:09 PM
Replies: 25
Views: 559
Posted By Bob KellyIII
well the new intake pipe arrived a bit ago......

well the new intake pipe arrived a bit ago... took it out there and out the rubber connector onto the back of the carb.... it fit nice and tight. then I took the pipe that came with the kit.... and...
Forum: General Motorcycling Discussion November 17th, 2022, 09:52 PM
Replies: 25
Views: 559
Posted By Bob KellyIII
And No that float needle has not re-appeared yet...

And No that float needle has not re-appeared yet ..... maybe it has something to do with the phases of the moon eh?
....
Bob........
Forum: General Motorcycling Discussion November 17th, 2022, 09:45 PM
Replies: 25
Views: 559
Posted By Bob KellyIII
LOL Man that is PROOF !!!! that has happened to...

LOL Man that is PROOF !!!! that has happened to me more times than I can recount ! especially while working on engines.... I remember one while I was working on my Honda 90 transmition .... I...
Forum: General Motorcycling Discussion November 17th, 2022, 11:50 AM
Replies: 25
Views: 559
Posted By Bob KellyIII
Welp.... now I'm waiting on a intake tube to go...

Welp.... now I'm waiting on a intake tube to go from the carb to the air box....
the stock one just won't fit the new carb , although I could probably jerry rig it, by slitting the side of the...
Forum: Forum Information November 15th, 2022, 06:53 PM
Replies: 2,575
Views: 465,776
Posted By Bob KellyIII
must be going incognito!!!

must be going incognito!!!
Forum: General Motorcycling Discussion November 15th, 2022, 05:50 PM
Replies: 8
Views: 359
Posted By Bob KellyIII
LOL... Back in the 70's and 80's a bike battery...

LOL... Back in the 70's and 80's a bike battery was good for one year Max !
you couldn't buy a battery that would last longer so I just started buying K-Mart batteries. but through the years I have...
Showing results 1 to 25 of 1000

 
Forum Jump




Motorcycle Safety Foundation

All times are GMT -7. The time now is 11:07 AM.


Website uptime monitoring Host-tracker.com
Powered by vBulletin®
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2022 DragonByte Technologies Ltd.
Except where otherwise noted, all site contents are Copyright 2022 ninjette.org, All rights reserved.