ninjette.org

Go Back   ninjette.org > Search Forums

Notices

Showing results 1 to 25 of 129
Search took 0.00 seconds.
Search: Posts Made By: Ken08Ninja
Forum: 2008 - 2012 Ninja 250R Farkles September 19th, 2011, 03:23 AM
Replies: 212
Views: 19,844
Posted By Ken08Ninja
jonnyc, I have the Koso RX1-N on my bike. This...

jonnyc, I have the Koso RX1-N on my bike. This may just be a "unbranded" version. The Koso is programmable see if these instructions...
Forum: 2008 - 2012 Ninja 250R Farkles September 18th, 2011, 01:33 AM
Replies: 212
Views: 19,844
Posted By Ken08Ninja
Just drop the magnets in the rotor bolts. They...

Just drop the magnets in the rotor bolts. They stay in fine, do not use glue or it will be a pain when you have to change the rotor.

The panel gt turbo linked to is for a different gauge, the KOSO...
Forum: 2008 - 2012 Ninja 250R Tech Talk July 29th, 2011, 12:44 PM
Replies: 4
Views: 1,479
Posted By Ken08Ninja
Bars like that provide a more upright seating...

Bars like that provide a more upright seating position, they are commonly put on bigger Super Sport bikes so you don't have to lean so far forward/down.
Forum: 2008 - 2012 Ninja 250R Tech Talk July 29th, 2011, 12:42 PM
Replies: 16
Views: 1,580
Posted By Ken08Ninja
It will hang sometimes if you are trying to...

It will hang sometimes if you are trying to downshift while stopped. You need to release the clutch a little bit to get everything to mesh properly. Do not try to force it or you may bend the shift...
Forum: 2008 - 2012 Ninja 250R Tech Talk February 11th, 2011, 06:06 PM
Replies: 6
Views: 3,299
Posted By Ken08Ninja
If I remember correctly, the stock fuel gauge...

If I remember correctly, the stock fuel gauge wiring has round eyelet terminals. I just cut them off and spliced the Koso wiring to it.
Forum: 2008 - 2012 Ninja 250R Tech Talk February 11th, 2011, 12:48 PM
Replies: 6
Views: 3,299
Posted By Ken08Ninja
I bought my Koso before the Plug in kit came out....

I bought my Koso before the Plug in kit came out. All I had to do was splice the wire in and adjust the resistance setting on the gauge.
Forum: General Motorcycling Discussion January 28th, 2011, 05:21 PM
Replies: 12
Views: 1,702
Posted By Ken08Ninja
NADA guides has it $3,725 low retail and $4,900...

NADA guides has it $3,725 low retail and $4,900 high retail. I would try to talk him down more.
Forum: 2008 - 2012 Ninja 250R Tech Talk January 27th, 2011, 03:38 AM
Replies: 175
Views: 10,516
Posted By Ken08Ninja
To get a good reading on the plugs you need to...

To get a good reading on the plugs you need to install new ones, run the bike wide open for a stretch and shut the motor off. You can't read the plugs if you have any idiling or coasting.

How long...
Forum: 2008 - 2012 Ninja 250R Farkles January 24th, 2011, 03:14 PM
Replies: 147
Views: 29,985
Posted By Ken08Ninja
How are you going to align the cutoff line level....

How are you going to align the cutoff line level. When I put my kit in I had to align the projectors before sealing the lens cover back on. Can you rotate the projectors from the back?
Forum: 2008 - 2012 Ninja 250R Tech Talk January 18th, 2011, 11:22 AM
Replies: 15
Views: 3,659
Posted By Ken08Ninja
so did you use H4 Bi-xenon bulb??becoz i don't...

so did you use H4 Bi-xenon bulb??becoz i don't see H7 have Bi-xenon bulb....
Bi-xenon=HID low beam + HID high beam In one bulb, right???
I used a H7 kit from here ...
Forum: 2008 - 2012 Ninja 250R Tech Talk January 18th, 2011, 03:31 AM
Replies: 15
Views: 3,659
Posted By Ken08Ninja
Projectors are housings for HID bulbs, they...

Projectors are housings for HID bulbs, they control the light from scattering. In order to use projectors you need to disassemble your headlight housing and modify the stock reflector to fit them in....
Forum: Motorcycle-related December 1st, 2010, 03:52 PM
Replies: 17
Views: 2,396
Posted By Ken08Ninja
The knock-off's are not actually carbon fiber the...

The knock-off's are not actually carbon fiber the can has a wrap on the outside.
Forum: 2008 - 2012 Ninja 250R Tech Talk November 30th, 2010, 04:23 AM
Replies: 19
Views: 2,130
Posted By Ken08Ninja
Those are one piece tank covers they go over your...

Those are one piece tank covers they go over your original tank.
Forum member ztrack157 (Matt) @ Sportisimoto USA can get them for you. http://www.sportisimoto-usa.com/products.php
Forum: 2008 - 2012 Ninja 250R Tech Talk November 30th, 2010, 03:58 AM
Replies: 3
Views: 1,766
Posted By Ken08Ninja
Sounds like you need to lube the cables.

Sounds like you need to lube the cables.
Forum: 2008 - 2012 Ninja 250R Tech Talk November 19th, 2010, 04:17 AM
Replies: 1
Views: 678
Posted By Ken08Ninja
#1 is the temp sensor for the radiator fan ...

#1 is the temp sensor for the radiator fan

#2 is the CDI.
Forum: 2008 - 2012 Ninja 250R Tech Talk November 13th, 2010, 04:54 PM
Replies: 12
Views: 4,603
Posted By Ken08Ninja
Are you stopping while still in 2nd gear or...

Are you stopping while still in 2nd gear or higher? The bike should be moving when changing gears.
Forum: 2008 - 2012 Ninja 250R Farkles November 13th, 2010, 04:50 PM
Replies: 17
Views: 1,869
Posted By Ken08Ninja
The footpeg brackets are cast aluminum. They...

The footpeg brackets are cast aluminum. They won't rust, but will oxidize if you don't clear coat them or keep a polish on them.
Forum: 2008 - 2012 Ninja 250R Tech Talk November 6th, 2010, 05:04 PM
Replies: 5
Views: 949
Posted By Ken08Ninja
You should not need to replace the fluid. Just...

You should not need to replace the fluid. Just pour it out into a container and slowly refill the tubes.
Forum: Motorcycle-related October 15th, 2010, 03:18 AM
Replies: 21
Views: 2,408
Posted By Ken08Ninja
:whathesaid: As long as the power does not...

:whathesaid:

As long as the power does not decrease from stock an undertail exhaust will be a huge hit. No one currently makes one, whereas there is at least 5 CF side mounts already on the market.
Forum: General Motorcycling Discussion September 17th, 2010, 01:47 AM
Replies: 23
Views: 5,250
Posted By Ken08Ninja
Ron, the Rotella T6 I use is 5W40. The photo I...

Ron, the Rotella T6 I use is 5W40. The photo I posted is the actual 1 gallon jug I am using. Click on the photo to see it full sized, and you can see the last rating in the requirements meet box is...
Forum: General Motorcycling Discussion September 14th, 2010, 02:24 PM
Replies: 23
Views: 5,250
Posted By Ken08Ninja
Your info is not correct. The Rotella T6 is JASO...

Your info is not correct. The Rotella T6 is JASO MA not JASO MB. It also does not have "Energy Conserving" or "Fuel Conserving" on the bottom of the seal....
Forum: 2008 - 2012 Ninja 250R Tech Talk September 12th, 2010, 01:18 AM
Replies: 22
Views: 2,643
Posted By Ken08Ninja
I bought a 50W 4300K kit. I've never checked to...

I bought a 50W 4300K kit. I've never checked to see how hot my lights get. I've had mine now for about 4000 miles, the lense has not melted or discolored any. If yours are 35W they should be fine.
...
Forum: 2008 - 2012 Ninja 250R Tech Talk September 10th, 2010, 08:05 PM
Replies: 22
Views: 2,643
Posted By Ken08Ninja
Dave, they are almost touching the lense cover...

Dave, they are almost touching the lense cover even after sinking them in the reflector. The last photo I posted shows where I have them making contact with the reflector.

Ken
Forum: Motorcycle-related September 10th, 2010, 08:01 PM
Replies: 566
Views: 60,797
Posted By Ken08Ninja
More info needed. How many and what diameter...

More info needed.
How many and what diameter are the pistons, what diameter is the rotor? Any stopping distance comparisons?
Forum: 2008 - 2012 Ninja 250R Tech Talk September 6th, 2010, 04:35 PM
Replies: 22
Views: 2,643
Posted By Ken08Ninja
Dave, I took some photos of my setup for you. I...

Dave, I took some photos of my setup for you. I painted both the projectors and stock reflector Black.

http://i533.photobucket.com/albums/ee335/TBSS30/HID%20Projector/th_IMG_0012.jpg...
Showing results 1 to 25 of 129

 
Forum Jump




Motorcycle Safety Foundation

All times are GMT -7. The time now is 12:32 PM.


Website uptime monitoring Host-tracker.com
Powered by vBulletin®
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
Except where otherwise noted, all site contents are © Copyright 2022 ninjette.org, All rights reserved.