ninjette.org

Go Back   ninjette.org > Search Forums
Reload this Page Search Results
Portal Page Forums NinjetteWiki Blogs Register FAQ Today's Posts Search

Showing results 1 to 15 of 15
Search took 0.00 seconds. Search: Posts Made By: PEN25
Forum: 1986 - 2007 Ninja 250R Tech Talk August 7th, 2013, 12:26 AM
Replies: 22
Views: 18,515
Posted By PEN25
you have two lines that go between the carbs. one...

you have two lines that go between the carbs. one is larger then the other and one that bridges the two carbs. i had both the smaller and larger lines flopped that goes between the carbs but also...
Forum: 1986 - 2007 Ninja 250R Tech Talk July 31st, 2013, 12:31 AM
Replies: 22
Views: 18,515
Posted By PEN25
i had this problem just last month. pulled the...

i had this problem just last month. pulled the carbs since the vac leak check didnt find anything. found i had routed the vac lines wrong between the small and bigger lines. as soon as i swapped them...
Forum: 1986 - 2007 Ninja 250R Tech Talk July 8th, 2013, 10:33 AM
Replies: 17
Views: 3,276
Posted By PEN25
are you trying it with the clutch pulled in or...

are you trying it with the clutch pulled in or not? try it with the clutch pulled in. if it starts it might be the kickstand sensor.
Forum: 1986 - 2007 Ninja 250R Tech Talk July 8th, 2013, 10:29 AM
Replies: 1
Views: 698
Posted By PEN25
normal bullet connectors. wire it into a...

normal bullet connectors. wire it into a cigarette lighter plug to be able to use the gps's cable. make sure you get one that isnt lighted as it is power on all times.
Forum: 1986 - 2007 Ninja 250R Tech Talk July 8th, 2013, 09:11 AM
Replies: 59
Views: 7,728
Posted By PEN25
sometimes those relays get a weak voltage which...

sometimes those relays get a weak voltage which doesnt cause it to trip. we have the same issue on the suzuki samurai and sidekicks do to a high resistance in the clutch switch or wire that has high...
Forum: 1986 - 2007 Ninja 250R Tech Talk July 2nd, 2013, 08:25 PM
Replies: 59
Views: 7,728
Posted By PEN25
wiring. when you try to jump it does it even make...

wiring. when you try to jump it does it even make the clicking sound? if not its possible your starter solenoid is bad. if you hit it with the jumper cables and it does nothing its you starter
Forum: 1986 - 2007 Ninja 250R Tech Talk July 2nd, 2013, 07:54 PM
Replies: 59
Views: 7,728
Posted By PEN25
did you check the fuses...

did you check the fuses http://faq.ninja250.org/wiki/How_to_check_the_fuses
Forum: 1986 - 2007 Ninja 250R Tech Talk July 2nd, 2013, 06:22 PM
Replies: 59
Views: 7,728
Posted By PEN25
sorry dont know what i was thinking except i was...

sorry dont know what i was thinking except i was thinking of a car battery. 2.1volt per cell on a motorcycle compared to 2.3 for car battery.
Forum: 1986 - 2007 Ninja 250R Tech Talk July 2nd, 2013, 05:59 PM
Replies: 59
Views: 7,728
Posted By PEN25
12.6 is a sign of a low battery. but could also...

12.6 is a sign of a low battery. but could also be symptomatic of a dead cell. it you cant get that battery up to above 13volts time for a new battery. its possible the fuse blew when you attempted...
Forum: 1986 - 2007 Ninja 250R Tech Talk June 30th, 2013, 07:28 PM
Replies: 59
Views: 7,728
Posted By PEN25
after letting it charge it should read around...

after letting it charge it should read around 13.8v if it doesnt come up to 13.8 and you have good fluid levels then the battery needs replaced. i have a battery minder and it can revive some batt's...
Forum: 1986 - 2007 Ninja 250R Tech Talk June 30th, 2013, 02:09 PM
Replies: 59
Views: 7,728
Posted By PEN25
your battery maybe fine, but when was the last...

your battery maybe fine, but when was the last time you replaced it? btw put in an external fuel filter that is clear so you can visually see the fuel.
Forum: 1986 - 2007 Ninja 250R Tech Talk June 30th, 2013, 02:04 PM
Replies: 10
Views: 1,731
Posted By PEN25
fixed it. tried the carb cleaner trick and...

fixed it. tried the carb cleaner trick and nothing changed. no loose rubbers. wasnt sure about vacuum lines on the carbs since the pictures i took some how didnt take. anyway dropped the carbs off...
Forum: 1986 - 2007 Ninja 250R Tech Talk June 24th, 2013, 07:13 PM
Replies: 10
Views: 1,731
Posted By PEN25
interesting. ill have to rip my tank off and look...

interesting. ill have to rip my tank off and look again. i thought for sure i had the boots on correctly. could it be i got one of the vacuum lines on wrong?
Forum: 1986 - 2007 Ninja 250R Tech Talk June 24th, 2013, 02:25 PM
Replies: 10
Views: 1,731
Posted By PEN25
idle issue

having issues with my 01. starts fine and idles fine until i ride. the rpm's dont seem, to want to come down from 5k as i have the clutch engaged or in neutral until i adjust the idle screw. then i...
Forum: 1986 - 2007 Ninja 250R Tech Talk June 19th, 2013, 10:30 PM
Replies: 29
Views: 4,614
Posted By PEN25
it is recommended to slip to reserve while riding...

it is recommended to slip to reserve while riding and fresh fuel to remove the water from the bottom as it will not damage the engine with the little amount in the bottom. I always like to switch to...
Showing results 1 to 15 of 15

 
Forum Jump




Motorcycle Safety Foundation

All times are GMT -7. The time now is 06:14 AM.

Contact Us - ninjette.org - Archive - Terms of Service - Top

Website uptime monitoring Host-tracker.com
Powered by vBulletin®
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
Except where otherwise noted, all site contents are © Copyright 2022 ninjette.org, All rights reserved.