Forum: 1986 - 2007 Ninja 250R Tech Talk
September 27th, 2020, 11:56 AM
|
Replies: 61
Views: 4,174
Well its official, they are dialed in!
An...
Well its official, they are dialed in!
An hour and a half long ride on Saturday, and another hour today. Running ok ish for the first few km and then absolutely perfect after that.
Having just...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 24th, 2020, 09:18 PM
|
Replies: 61
Views: 4,174
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 24th, 2020, 05:01 AM
|
Replies: 61
Views: 4,174
Thank you!
Decided to take the 06 today just...
Thank you!
Decided to take the 06 today just to re check everything (and avoid having to fix it on Saturday when my wife is ready to go :rotflmao: )
It definitely needed some enrichener (choke...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 23rd, 2020, 04:34 PM
|
Replies: 61
Views: 4,174
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 23rd, 2020, 04:51 AM
|
Replies: 61
Views: 4,174
So effectively if the engine rpm after being...
So effectively if the engine rpm after being warmed up is 1300 +/-, I will
- adjust the mixture screw of the left carb rich or lean until the rpm no longer increases (lets say that value is...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 22nd, 2020, 01:29 PM
|
Replies: 61
Views: 4,174
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 22nd, 2020, 09:45 AM
|
Replies: 61
Views: 4,174
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 21st, 2020, 07:23 PM
|
Replies: 61
Views: 4,174
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 21st, 2020, 08:53 AM
|
Replies: 61
Views: 4,174
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 17th, 2020, 05:10 AM
|
Replies: 61
Views: 4,174
So;
I verify Pilot and Main jet sizing...
So;
I verify Pilot and Main jet sizing (replace as needed)
Set the fuel / float level using the clear tube method on the bench. (currently set to 17mm, but now after reading/watching the clear...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 15th, 2020, 05:04 AM
|
Replies: 61
Views: 4,174
Thanks DannoXYZ.
I will try this method on...
Thanks DannoXYZ.
I will try this method on the way home.
Since I have been adjusting the idle-speed knob excessively, I am not sure where it currently is.
Is there a base setting for that,...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 15th, 2020, 04:58 AM
|
Replies: 61
Views: 4,174
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 15th, 2020, 04:56 AM
|
Replies: 61
Views: 4,174
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 14th, 2020, 06:30 AM
|
Replies: 61
Views: 4,174
Clearly. I will order some new stock jets for...
Clearly. I will order some new stock jets for both bikes so that one they are torn down I can at least have them to compare, and likely replace. It sounds as though the main isn't an issue, but for...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 14th, 2020, 04:30 AM
|
Replies: 61
Views: 4,174
Well I ended up putting both bikes back to 2.5...
Well I ended up putting both bikes back to 2.5 turns out. There is little left in the riding season based on our schedules, and as much as they ran rich, at least they ran smooth and not all over the...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 11th, 2020, 04:51 AM
|
Replies: 61
Views: 4,174
Ok so I just left home.
Started full choke,...
Ok so I just left home.
Started full choke, got it to rev at 5k full choke, went to about half-3/4 and then it idle nicely at 3k +/-.
Rode fine no problem. My commute is quite short (5 km and...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 11th, 2020, 03:16 AM
|
Replies: 61
Views: 4,174
Stupid question but now how do I get the idle...
Stupid question but now how do I get the idle back?
Can’t remember where it was set. Let’s say I give it full choke this morning and it fires up but revs at 5k; is that normal? Then I would leave...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 10th, 2020, 03:21 PM
|
Replies: 61
Views: 4,174
So we just got back from a little ride.
...
So we just got back from a little ride.
Both bikes turned 1/4-1:8 off of seated. They will still start without the choke but would idle really low. No choke I adjusted the idle to 2000 and off we...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 10th, 2020, 03:17 PM
|
Replies: 61
Views: 4,174
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 10th, 2020, 11:02 AM
|
Replies: 61
Views: 4,174
Ok will do. If I can get it close with the...
Ok will do. If I can get it close with the mixture screws we will at least be able to ride for a bit longer. Once it gets a little more chilly I will tear them down again for a full inspection.
...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 10th, 2020, 09:22 AM
|
Replies: 61
Views: 4,174
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 10th, 2020, 07:03 AM
|
Replies: 61
Views: 4,174
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 10th, 2020, 03:10 AM
|
Replies: 61
Views: 4,174
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 10th, 2020, 03:07 AM
|
Replies: 61
Views: 4,174
Fuel mileage is poor, and also not always the...
Fuel mileage is poor, and also not always the same. The best we have gotten from a tank so far is 200km (120mi) and one time it was even less.
Two nights ago we went for a ride that had a lot more...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
September 9th, 2020, 05:44 PM
|
Replies: 61
Views: 4,174
|