ninjette.org

Go Back   ninjette.org > Search Forums

Notices

Showing results 1 to 25 of 1000
Search took 0.07 seconds.
Search: Posts Made By: DannoXYZ
Forum: 1986 - 2007 Ninja 250R Tech Talk Yesterday, 08:19 PM
Replies: 26
Views: 263
Posted By DannoXYZ
I believe these are the specs for chain. 20...

I believe these are the specs for chain.

20 Link length
Standard: 127-127.4mm
Service Limit: 128.9mm

Check tensioner as it should travel in one direction only. If plunger can go back &...
Forum: 1986 - 2007 Ninja 250R Tech Talk Yesterday, 06:06 PM
Replies: 3
Views: 46
Posted By DannoXYZ
Yeah, I think you've got it. Got units mixed up...

Yeah, I think you've got it. Got units mixed up and grabbed wrong feeler gauge. I always stick with metric and rub-out or cover up the imperial measurements.

Good job on catching that! :)
Forum: 1986 - 2007 Ninja 250R Tech Talk Yesterday, 12:12 PM
Replies: 26
Views: 263
Posted By DannoXYZ
Measure chain to make sure it's not worn out.

Measure chain to make sure it's not worn out.
Forum: 1986 - 2007 Ninja 250R Tech Talk Yesterday, 09:42 AM
Replies: 3
Views: 46
Posted By DannoXYZ
Were those two valves on same cylinder? Most...

Were those two valves on same cylinder?

Most likely whoever did adjustment didn’t have cam rotated to fully closed position when they measured clearance.
Forum: 1986 - 2007 Ninja 250R Tech Talk July 22nd, 2019, 06:41 PM
Replies: 26
Views: 263
Posted By DannoXYZ
No need to check ignition-timing, it's fixed and...

No need to check ignition-timing, it's fixed and computerised. Could check coils and spark:

1. measure resistance across coils' primary terminals. What is this number?
2. pull spark-plug wire,...
Forum: 2008 - 2012 Ninja 250R Tech Talk July 22nd, 2019, 02:11 PM
Replies: 20
Views: 293
Posted By DannoXYZ
Another benefit of hanging bike is it leaves...

Another benefit of hanging bike is it leaves suspension completely free. So you can remove triple-Ts, forks, wheels, shock, swingarm, etc. Since itís super stable, you can do stupid things like... I...
Forum: 2008 - 2012 Ninja 250R Tech Talk July 22nd, 2019, 02:00 PM
Replies: 20
Views: 293
Posted By DannoXYZ
MichaelS214 any updates on this? Did cleaning...

MichaelS214 any updates on this? Did cleaning seals stop leaking?
Forum: 2008 - 2012 Ninja 250R Farkles July 22nd, 2019, 12:59 PM
Replies: 10
Views: 312
Posted By DannoXYZ
I wonder what this object is on right side of...

I wonder what this object is on right side of bike mid-way up engine?
Some kind of air-intake funnel? Are you using an airbox?
Also what exhaust is that? Thx
...
Forum: 1986 - 2007 Ninja 250R Tech Talk July 21st, 2019, 07:14 PM
Replies: 9
Views: 159
Posted By DannoXYZ
Hey good job! Sometimes, I just drop engine to do...

Hey good job! Sometimes, I just drop engine to do valve adjustment. Quicker than trying to move bazillion hoses, wires and stuff out of way!
Forum: 1986 - 2007 Ninja 250R Tech Talk July 21st, 2019, 12:39 AM
Replies: 26
Views: 263
Posted By DannoXYZ
If battery power is OK, then next up is: -...

If battery power is OK, then next up is:

- verify petcock is operational, only flows when vacuum applied, then thorough carb-cleaning
- clear out all jets and bleed holes with guitar wire of...
Forum: 1986 - 2007 Ninja 250R Tech Talk July 20th, 2019, 10:01 PM
Replies: 26
Views: 263
Posted By DannoXYZ
That's OK, starter is causing battery to drop...

That's OK, starter is causing battery to drop voltage due to drain. Do these tests.

1. measure battery voltage with everything off

2. measure battery voltage while pushing START button
Forum: Pictures July 20th, 2019, 03:03 AM
Replies: 36
Views: 615
Posted By DannoXYZ
OOohh, AAaahhh.... very nice!

OOohh, AAaahhh.... very nice!
Forum: 1986 - 2007 Ninja 250R Tech Talk July 19th, 2019, 09:31 PM
Replies: 8
Views: 188
Posted By DannoXYZ
Note that twisted forks isn't same as bent fork...

Note that twisted forks isn't same as bent fork tubes. With bent tubes, you can only fix by getting straight ones. Unless you have this special tool and know how to use it.
...
Forum: 1986 - 2007 Ninja 250R Tech Talk July 19th, 2019, 07:59 PM
Replies: 22
Views: 357
Posted By DannoXYZ
Thumbs up Another awesome job by ducatiman!!!...

Another awesome job by ducatiman!!! :clapping::smile-beerglass::bounce:
Forum: 2008 - 2012 Ninja 250R Tech Talk July 19th, 2019, 02:17 PM
Replies: 5
Views: 101
Posted By DannoXYZ
Yup, I've done as Jay's suggested. Take piece of...

Yup, I've done as Jay's suggested. Take piece of wood and cut out holes for oil-filter and oil-drain bolts. Then shape wood to extend and touch across swing-arm pivot. Then use scissor-jack with...
Forum: 2008 - 2012 Ninja 250R Tech Talk July 19th, 2019, 10:08 AM
Replies: 5
Views: 101
Posted By DannoXYZ
Yikes! Those scare me!!! Too easy for bike to...

Yikes! Those scare me!!! Too easy for bike to topple off. I’d much prefer to hang a bike, then it can’t fall because it’s at lowest point already.
Forum: General Motorcycling Discussion July 19th, 2019, 10:01 AM
Replies: 15
Views: 225
Posted By DannoXYZ
Yeah it can get confusing: Tightening...

Yeah it can get confusing:

Tightening adjuster = looser cable
Loosening adjuster = tighter cable

If you have lots of lever free-play that doesn’t move lever down by engine, you want to loosen...
Forum: 1986 - 2007 Ninja 250R Tech Talk July 18th, 2019, 12:16 PM
Replies: 8
Views: 188
Posted By DannoXYZ
Your mileage is about average. A little time...

Your mileage is about average. A little time spent on cleaning up will fetch you more $.

I bought two pregens (2002 & 2003) couple years ago from storage sale for $300. They came in boxes!
...
Forum: !%@*#$%!)@#&!%@ I crashed! July 18th, 2019, 12:04 PM
Replies: 4
Views: 81
Posted By DannoXYZ
Look and see if it's touching bottom of muffler. ...

Look and see if it's touching bottom of muffler.
Take photo and post it here.
Forum: Motorcycle-related July 18th, 2019, 11:54 AM
Replies: 4
Views: 104
Posted By DannoXYZ
I'd say about 7.5-8.0 for street use. If track...

I'd say about 7.5-8.0 for street use. If track racing, 8.0-8.5. I use 9.0 spring for track and I'm 180-lbs.

I'm looking into some ways to fit bottom without hacking up shock. I think sleeving...
Forum: General Motorcycling Discussion July 17th, 2019, 07:00 PM
Replies: 14
Views: 154
Posted By DannoXYZ
Personally i find 400 simpler. Much fewer hoses...

Personally i find 400 simpler. Much fewer hoses and clamps to get in way. So if newgen is 3, 400 is a 2. Spin-on oil filter makes oil-change easy! Swingarm bolts to engine and there’s less stuff...
Forum: 1986 - 2007 Ninja 250R Tech Talk July 17th, 2019, 01:21 AM
Replies: 22
Views: 357
Posted By DannoXYZ
Haaahahahhaahhhhh!!!! ...

Haaahahahhaahhhhh!!!!

https://www.truevalue.com/garage-driveway-cleaner-gal

Most likely bike’s that’s been sitting around long enough to have petcock and float-valve issues is gonna have...
Forum: 2008 - 2012 Ninja 250R Farkles July 17th, 2019, 01:08 AM
Replies: 10
Views: 312
Posted By DannoXYZ
Ahh, very nice... very nice...

Ahh, very nice... very nice...
Forum: General Motorcycling Discussion July 16th, 2019, 11:26 PM
Replies: 14
Views: 154
Posted By DannoXYZ
I've ridden 250, 300 and 400 many times at exact...

I've ridden 250, 300 and 400 many times at exact same track, so here's my impressions over 250.

300 - slight increase in power, but weighs more than 250 so it's almost a wash. Handling definitely...
Forum: General Motorcycling Discussion July 16th, 2019, 07:41 PM
Replies: 14
Views: 154
Posted By DannoXYZ
I vote for 400!!! Will keep you entertained...

I vote for 400!!!

Will keep you entertained for more years before you’re bored. It’s lighter and handles better than both 250 and 300! It’s so much fun!!
Showing results 1 to 25 of 1000

 
Forum Jump




Motorcycle Safety Foundation

All times are GMT -7. The time now is 02:22 AM.


remote server monitor
Powered by vBulletin®
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Except where otherwise noted, all site contents are © Copyright 2019 ninjette.org, All rights reserved.