Forum: 2008 - 2012 Ninja 250R Tech Talk
May 6th, 2014, 12:43 PM
|
Replies: 19
Views: 1,191
If ANYTHING electrical works (not including...
If ANYTHING electrical works (not including starter), the 30 AMP fuse is good. Check ALL of your fuses in your fuse box to make sure they are good.
NO START as in the starter does NOT turn over?...
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
April 27th, 2014, 04:35 PM
|
Replies: 11
Views: 4,177
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
April 27th, 2014, 01:45 PM
|
Replies: 4
Views: 1,067
I'll have to check the recommended 4k RPM next...
I'll have to check the recommended 4k RPM next time. I'll also double check to make sure my system is getting the readings correctly by crosschecking with the sensor, but it should be correct. And I...
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
April 26th, 2014, 07:53 PM
|
Replies: 4
Views: 1,067
New sensor data readings
So I finally got all of my sensors installed and some preliminary data collected. They seem to be calibrated properly, at least the temperature ones. I would have to double check the oil pressure...
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
April 16th, 2014, 09:47 PM
|
Replies: 8
Views: 2,221
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
April 16th, 2014, 09:00 AM
|
Replies: 8
Views: 2,221
Actually from what I have heard, the gray wire...
Actually from what I have heard, the gray wire from the ignition with a resistor in it (which I believe is IN the ignition switch) is a "security device". If that gray wire doesn't have a certain...
|
Forum: 2008 - 2012 Ninja 250R Farkles
April 11th, 2014, 09:30 PM
|
Replies: 4
Views: 1,405
Reflective rim tape
First time I have put on rim tape. I considered it because you can get the reflective kind, good for someone noticing you at night coming at your perpendicular.
Ended up getting yellow to match...
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
April 11th, 2014, 09:22 PM
|
Replies: 4
Views: 1,921
|
Forum: 2008 - 2012 Ninja 250R Farkles
April 10th, 2014, 11:30 PM
|
Replies: 23
Views: 3,169
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
April 8th, 2014, 05:15 PM
|
Replies: 7
Views: 754
|
Forum: 2008 - 2012 Ninja 250R Farkles
April 7th, 2014, 08:43 AM
|
Replies: 11
Views: 2,725
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
April 7th, 2014, 08:14 AM
|
Replies: 7
Views: 754
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
March 31st, 2014, 10:12 PM
|
Replies: 2
Views: 871
I have seen that one. Mine may be a little off...
I have seen that one. Mine may be a little off now that i think about it. My Meter lights and warning lights, as well as brake/tail and license plate light are LED. I know my brake light draws 6...
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
March 31st, 2014, 07:20 PM
|
Replies: 2
Views: 871
Electrical wattage savings with LEDs
Well since there hasn't been much info on the subject since the 07's, I figured I'd give my information on what I know and have observed.
The only one I cam across was this:...
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
March 29th, 2014, 11:08 PM
|
Replies: 2
Views: 839
Rear sprocket bent chain adjuster
Working on the bike the past few days and noticed that my chain adjuster was bent 35 or so degrees outward with the back plate hanging off with one nut barely on. Did not notice this happening while...
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
March 29th, 2014, 10:58 PM
|
Replies: 72
Views: 38,192
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
March 29th, 2014, 07:36 PM
|
Replies: 9
Views: 2,492
|
Forum: 2008 - 2012 Ninja 250R Farkles
March 29th, 2014, 04:20 PM
|
Replies: 8
Views: 1,777
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
March 28th, 2014, 11:29 PM
|
Replies: 9
Views: 2,492
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
March 28th, 2014, 04:46 PM
|
Replies: 9
Views: 2,492
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
March 27th, 2014, 10:25 PM
|
Replies: 4
Views: 1,594
I second this, but I have this:...
I second this, but I have this: http://www.ebay.com/itm/GA-NHWC3-Hardwire-Cable-for-Mobile-Phone-with-Micro-USB-connector-/330658929293?pt=US_Cell_Phone_PDA_Chargers&hash=item4cfcceda8d
It's nice...
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
March 27th, 2014, 09:53 PM
|
Replies: 9
Views: 2,492
Oil pressure switch and banjo bolt issue
Ok, So I want to add an oil pressure sender but also keep the stock oil pressure sensor/warning light.
I'm sure some of you know, but in pic 1, you have the crank case, then the banjo bolt that...
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
March 24th, 2014, 11:38 PM
|
Replies: 14
Views: 1,683
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
March 24th, 2014, 11:18 PM
|
Replies: 14
Views: 1,683
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
March 24th, 2014, 10:57 PM
|
Replies: 14
Views: 1,683
|