ninjette.org

Go Back   ninjette.org > Search Forums

Notices

Showing results 1 to 25 of 55
Search took 0.00 seconds.
Search: Posts Made By: steven moore
Forum: General Motorcycling Discussion November 18th, 2018, 06:52 PM
Replies: 15
Views: 971
Posted By steven moore
Yes it's streetlegal, is does require some upper...

Yes it's streetlegal, is does require some upper body strength to maneuver though. Here's is the new wing I built , adds horsepower they say... LOL
Forum: General Motorcycling Discussion November 3rd, 2018, 01:18 PM
Replies: 15
Views: 971
Posted By steven moore
Correct, only the left wheel drives. Without a...

Correct, only the left wheel drives. Without a differential you cannot have two wheel drive on a street trike because the wheels will not slip enough on asphalt to turn. The only reason that...
Forum: General Motorcycling Discussion November 1st, 2018, 09:06 PM
Replies: 15
Views: 971
Posted By steven moore
I bent the first axle I had in it. The wheels...

I bent the first axle I had in it. The wheels stuck out too far, so I replace the axle with a new one and moved the wheels in as far as they would go. I've hit big potholes I've sent the trike in the...
Forum: General Motorcycling Discussion November 1st, 2018, 09:01 PM
Replies: 15
Views: 971
Posted By steven moore
Was a solid rear axle I had to cut it in half, if...

Was a solid rear axle I had to cut it in half, if I didn't the trike wouldn't turn it only go in a straight line. Axle runs on regular 1 inch bearings, 2 per side.
Forum: General Motorcycling Discussion November 1st, 2018, 07:21 PM
Replies: 15
Views: 971
Posted By steven moore
Thanks! It runs good too. It grabs attention...

Thanks! It runs good too. It grabs attention every where I go. No suspension in the rear can get annoying on rough roads but I take it on the freeway a lot it does pretty well. Top speed of 80 mph....
Forum: General Motorcycling Discussion November 1st, 2018, 06:28 PM
Replies: 15
Views: 971
Posted By steven moore
absolutely I need to, I may attempt that tomorrow...

absolutely I need to, I may attempt that tomorrow it needs to get done it's the only law I'm breaking LOL
Forum: General Motorcycling Discussion November 1st, 2018, 06:14 PM
Replies: 15
Views: 971
Posted By steven moore
Lol, :Ddon't ever let me get bored with a welder...

Lol, :Ddon't ever let me get bored with a welder and grinder. Here's a list of Parts in no particular order. Stock ninja front end, stock ninja engine, stock ninja tank, 1 inch rear go-kart axle,...
Forum: General Motorcycling Discussion November 1st, 2018, 05:51 PM
Replies: 15
Views: 971
Posted By steven moore
Here's some more pics

Here's some more pics
Forum: General Motorcycling Discussion November 1st, 2018, 05:45 PM
Replies: 15
Views: 971
Posted By steven moore
250 ninja trike

What's up guys I thought I'd share my latest project powered by 07 250 Ninja. I think I might have posted it before when it was still under construction, but now that I have a few miles on it and...
Forum: General Motorcycling Discussion June 2nd, 2018, 03:57 PM
Replies: 68
Views: 4,494
Posted By steven moore
IT LIVES!!

Well finally came off the saw horses and I was able to test it out, it runs. Had to rebuild the chain tensioner. I have to hot wire the fan to a switch. I need to finish wiring to all lights and...
Forum: General Motorcycling Discussion June 1st, 2018, 09:01 AM
Replies: 68
Views: 4,494
Posted By steven moore
Yeah I have to definitely check that out. I'm in...

Yeah I have to definitely check that out. I'm in the middle of trying to hook up the rear hydraulic break linkage system at the moment but I'll take a look at that when I get a spare chance. Thanks...
Forum: General Motorcycling Discussion May 31st, 2018, 08:35 AM
Replies: 68
Views: 4,494
Posted By steven moore
It's funny you should say that, when I first...

It's funny you should say that, when I first started this project I was trying to figure out how to stick the original rear end on it but no matter how I tried it just looked terrible and I couldn't...
Forum: General Motorcycling Discussion May 31st, 2018, 08:12 AM
Replies: 68
Views: 4,494
Posted By steven moore
I also figured out how to keep part of my Fairing...

I also figured out how to keep part of my Fairing and the windshield to keep the wind off me here's a rough cut pic of it
Forum: General Motorcycling Discussion May 31st, 2018, 08:01 AM
Replies: 68
Views: 4,494
Posted By steven moore
I got most of the wiring done I couldn't figure...

I got most of the wiring done I couldn't figure out where to place the computer and CDI box so I decided to stuff inside of ammo box to clean it up a little bit and keep them safe.
Forum: General Motorcycling Discussion May 31st, 2018, 07:59 AM
Replies: 68
Views: 4,494
Posted By steven moore
Does anybody know if the thermostat on the...

Does anybody know if the thermostat on the 250ninja has a ground? I marked all my wires and I know it has a temp sensor blade but I think there was a ground and I'm not sure.
Forum: General Motorcycling Discussion May 26th, 2018, 11:53 AM
Replies: 68
Views: 4,494
Posted By steven moore
Yeah I was poking around looking at differentials...

Yeah I was poking around looking at differentials for ATVs and side-by-sides, most of them are shaft drive and it's difficult to find a chain drive. Northern Tool had a limited slip differential I...
Forum: General Motorcycling Discussion May 26th, 2018, 11:26 AM
Replies: 68
Views: 4,494
Posted By steven moore
I would not consider a differential unless I was...

I would not consider a differential unless I was installing a regular car motor on a trike. Unless you know somebody who makes a very small differential that could be used on a vehicle this size, the...
Forum: General Motorcycling Discussion May 26th, 2018, 11:21 AM
Replies: 68
Views: 4,494
Posted By steven moore
Sorry Ducati 999 I have figured out how to PM...

Sorry Ducati 999 I have figured out how to PM anybody yet. And yes I have changed the ratio for the rear sprocket I dropped it from a 45 to 30 hopefully that'll be enough. I'm not a hundred percent...
Forum: General Motorcycling Discussion May 25th, 2018, 10:46 PM
Replies: 68
Views: 4,494
Posted By steven moore
A word to the wise, don't hook up your starter...

A word to the wise, don't hook up your starter solenoid backwards will cause you to chase down electrical Gremlins that don't exist... lol
Forum: General Motorcycling Discussion May 25th, 2018, 10:43 PM
Replies: 68
Views: 4,494
Posted By steven moore
I was able to start it up an hour ago. Installed...

I was able to start it up an hour ago. Installed the clutch cable and hooked up the throttle, it runs just fine motor wise. Still got a lot of work to do before I can put it on the ground and...
Forum: General Motorcycling Discussion May 25th, 2018, 06:32 AM
Replies: 68
Views: 4,494
Posted By steven moore
Hey I got a wiring question out there for anybody...

Hey I got a wiring question out there for anybody who knows but if you have two wires that are identical in color even if they're multicolored can they be hooked together and ran to the same line or...
Forum: General Motorcycling Discussion May 25th, 2018, 06:23 AM
Replies: 68
Views: 4,494
Posted By steven moore
Yeah I'm currently balls-deep in the middle of...

Yeah I'm currently balls-deep in the middle of the wiring not the funnest job but since I kept the original harness all I have to do is extend most of it and I think we'll probably be okay I hope
Forum: General Motorcycling Discussion May 25th, 2018, 06:20 AM
Replies: 68
Views: 4,494
Posted By steven moore
Yeah I've only ridden that regular motorcycle...

Yeah I've only ridden that regular motorcycle trike that was converted. Yeah I'm hoping the length of the trike will offset a couple of it's possible quirks. On the bright side if the rear brake...
Forum: General Motorcycling Discussion May 25th, 2018, 06:05 AM
Replies: 68
Views: 4,494
Posted By steven moore
That's probably the case I'll have to try it out...

That's probably the case I'll have to try it out and see what happens. funny thing is most of my custom motorcycles and stuff I don't even bother installing a rear brake because the front usually...
Forum: General Motorcycling Discussion May 24th, 2018, 06:43 PM
Replies: 68
Views: 4,494
Posted By steven moore
Ninja trike update

Been a while but finally got more parts and there for more work done. I mounted the original rear ninja caliper, master cylinder and overflow bottle for the radiator. Installed chain and started some...
Showing results 1 to 25 of 55

 
Forum Jump




Motorcycle Safety Foundation

All times are GMT -7. The time now is 08:55 AM.


Website uptime monitoring Host-tracker.com
Powered by vBulletin®
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
Except where otherwise noted, all site contents are © Copyright 2022 ninjette.org, All rights reserved.