ninjette.org

Go Back   ninjette.org > Search Forums
Reload this Page Search Results
Portal Page Forums NinjetteWiki Blogs Register FAQ Today's Posts Search

Page 1 of 3 1 23
Showing results 1 to 25 of 52
Search took 0.00 seconds. Search: Posts Made By: cbzdel
Forum: 2013 - 2017 Ninja 300 Tech Talk March 22nd, 2013, 11:58 AM
Replies: 14
Views: 5,001
Posted By cbzdel
Its one of these.. ...

Its one of these..
http://www.rona.ca/images/12135012_L.jpg

According to Kawi specs the frame is:
Forum: 2013 - 2017 Ninja 300 Tech Talk March 22nd, 2013, 11:50 AM
Replies: 14
Views: 5,001
Posted By cbzdel
I have one of those small propane bottle torches...

I have one of those small propane bottle torches would that heat it up enough?
Forum: 2013 - 2017 Ninja 300 Tech Talk March 22nd, 2013, 11:22 AM
Replies: 14
Views: 5,001
Posted By cbzdel
You can move it you would like, I didnt post it...

You can move it you would like, I didnt post it there only because I figure the 250R guys would have a better idea as they have been around longer.. The mounting points are exactly the same.
Forum: 2013 - 2017 Ninja 300 Tech Talk March 22nd, 2013, 11:15 AM
Replies: 14
Views: 5,001
Posted By cbzdel
repairing bent rearset mount

I had a bit of a low speed high side on my bike last evening, actually it was on my Ninja 300, but I am sure you 250R guys have ran into the same issue.

How do I go about fixing this, the mounting...
Forum: Motorcycle-related February 24th, 2013, 10:17 AM
Replies: 18
Views: 3,170
Posted By cbzdel
The 250R aftermarket shocks will fit. I (and my...

The 250R aftermarket shocks will fit. I (and my buddy) went with the GSXR shock mod :thumbup:
Forum: 2008 - 2012 Ninja 250R Tech Talk February 22nd, 2013, 12:49 AM
Replies: 10
Views: 1,593
Posted By cbzdel
I finally dropped back in the forks tonight.. ...

I finally dropped back in the forks tonight..

Bit of an issue..
So i drilled the dampers with the 6 holes
Primed the forks with 15w oil
Dropped in the emulator, set with blue springs and 3...
Forum: 2008 - 2012 Ninja 250R Tech Talk February 17th, 2013, 11:52 PM
Replies: 10
Views: 1,593
Posted By cbzdel
Great thanks... Man i am not having good luck,...

Great thanks... Man i am not having good luck, took me 5 hours to get the fork caps off!! It took me like a half hour to remove the factory ones and install the ssr ones, so why was was it so hard to...
Forum: 2008 - 2012 Ninja 250R Tech Talk February 17th, 2013, 12:46 AM
Replies: 10
Views: 1,593
Posted By cbzdel
Hmmm. Where can i get that info on fork oil from...

Hmmm. Where can i get that info on fork oil from race tech? I read through the directions and was searching on their website, didn't find anything.. I had another guy tell me 15w and he weighed less...
Forum: 2008 - 2012 Ninja 250R Tech Talk February 16th, 2013, 12:16 PM
Replies: 10
Views: 1,593
Posted By cbzdel
Last questions I have, what fork oil weight do I...

Last questions I have, what fork oil weight do I want to use? I went to Cycle Gear and was looking at the oil. The guy asked whe how much I weighed and I told him about 200 geared up and I am...
Forum: 2008 - 2012 Ninja 250R Tech Talk February 14th, 2013, 09:58 AM
Replies: 10
Views: 1,593
Posted By cbzdel
Installing GV Emulators Tomorrow

I have read though a couple How To's on installing the GV Emulators, it seems simple enough, almost to simple haha..

I have never taken forks off any bike I have ever owned though, so this will...
Forum: Motorcycle-related February 13th, 2013, 12:26 PM
Replies: 18
Views: 3,170
Posted By cbzdel
Second One Sold :D

Second One Sold :D
Forum: Motorcycle-related February 13th, 2013, 08:51 AM
Replies: 18
Views: 3,170
Posted By cbzdel
Alright a got a second one now for sale. My...

Alright a got a second one now for sale. My buddy ended up buying a 300 not long after me and he liked my how my bike handled with the different shock, so he went the same route.

So now another...
Forum: 2013 - 2017 Ninja 300 Tech Talk January 29th, 2013, 11:51 AM
Replies: 428
Views: 104,785
Posted By cbzdel
can you buy those pre-made anywhere??

can you buy those pre-made anywhere??
Forum: 2013 - 2017 Ninja 300 Tech Talk January 28th, 2013, 11:17 AM
Replies: 428
Views: 104,785
Posted By cbzdel
I see two plugs you grounded out, was there two...

I see two plugs you grounded out, was there two hooked up to the switching valve?

In the 1st attachment on the second post, it that the air pressure sensor zip tied to the frame?

How do you...
Forum: 2013 - 2017 Ninja 300 Tech Talk January 25th, 2013, 01:06 PM
Replies: 428
Views: 104,785
Posted By cbzdel
Your second pic needs a breather filter, its the...

Your second pic needs a breather filter, its the crank case vent..

Your first pic is the clean air system, you can plug is as yours is or get a block off plate..
Forum: 2013 - 2017 Ninja 300 Tech Talk January 25th, 2013, 10:06 AM
Replies: 428
Views: 104,785
Posted By cbzdel
Last night I installed my pod filter, and then...

Last night I installed my pod filter, and then juts zip tired the IAT sensor up under the tank just to get it out of the way as I was just test fitting the filter..

Started it up and reved it a...
Forum: 2013 - 2017 Ninja 300 Tech Talk January 24th, 2013, 09:11 AM
Replies: 428
Views: 104,785
Posted By cbzdel
If you removed your air switching valve, what did...

If you removed your air switching valve, what did you mount your air pressure sensor on?

I left the switching valve in place and left it hooked up just so I didnt get my check engine light, plus...
Forum: 2013 - 2017 Ninja 300 Tech Talk January 22nd, 2013, 01:38 PM
Replies: 428
Views: 104,785
Posted By cbzdel
what made you choose 2 small filters over the...

what made you choose 2 small filters over the single one large one?
Forum: Motorcycle-related January 18th, 2013, 12:12 PM
Replies: 18
Views: 3,170
Posted By cbzdel
First one SOLD!!! to "Ron K".. (See Post #7,...

First one SOLD!!! to "Ron K"..

(See Post #7, one still available)
Forum: 2008 - 2012 Ninja 250R Tech Talk January 17th, 2013, 09:40 AM
Replies: 18
Views: 3,119
Posted By cbzdel
the side covers on the 300 are only about 1/2 the...

the side covers on the 300 are only about 1/2 the size of 250R side covers so the gap is alot larger but I guess I just like to worry :eek:

I am adding the GSXR rear shock as well so I need to...
Forum: 2008 - 2012 Ninja 250R Tech Talk January 17th, 2013, 08:37 AM
Replies: 18
Views: 3,119
Posted By cbzdel
I just dont want crap falling down in the hole.. ...

I just dont want crap falling down in the hole.. Also looking for as much water protection as possible.. I live in WA and it RAINS here, and I ride in the rain all the time..

This pod filter...
Forum: 2008 - 2012 Ninja 250R Tech Talk January 17th, 2013, 07:54 AM
Replies: 18
Views: 3,119
Posted By cbzdel
Thats what I am looking for :thumbup: I will...

Thats what I am looking for :thumbup:

I will just do something simple like that and just monitor it the first few times in the rain. This is actaully going on my Ninja 300, but no one has really...
Forum: Motorcycle-related January 16th, 2013, 04:59 PM
Replies: 18
Views: 3,170
Posted By cbzdel
where would that info be listed? owner manual?...

where would that info be listed? owner manual? service manual? on the spring itself?
Forum: 2008 - 2012 Ninja 250R Tech Talk January 16th, 2013, 03:00 PM
Replies: 18
Views: 3,119
Posted By cbzdel
My plan was to use a little K&N filter or similar...

My plan was to use a little K&N filter or similar brand.. But is if I just stick it on top of the engine should I be worried about water?
Forum: 2008 - 2012 Ninja 250R Tech Talk January 16th, 2013, 02:42 PM
Replies: 18
Views: 3,119
Posted By cbzdel
Crank Case Vent Filter

After converting to a pod filter has anyone came up with a good option for the crank case vent?

I am looking for something that will be good in all weather riding.. Thought about getting a longer...
Showing results 1 to 25 of 52
Page 1 of 3 1 23

 
Forum Jump




Motorcycle Safety Foundation

All times are GMT -7. The time now is 01:12 AM.

Contact Us - ninjette.org - Archive - Terms of Service - Top

Website uptime monitoring Host-tracker.com
Powered by vBulletin®
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
Except where otherwise noted, all site contents are © Copyright 2022 ninjette.org, All rights reserved.