April 15th, 2015, 01:11 PM
|
#14
|
ninjette.org newbie
Name: Jesse
Location: Upstate NY
Join Date: Apr 2015
Motorcycle(s): 07 ninja 250, '72 cb500, '03 750monster, '69 cb350
Posts: 1
|
riser source
Quote:
Originally Posted by Chicagobob
I used the aftermarket risers, available on Amazon. They're good because you can insert an internal-drive hex head bolt from the top, which is good because space for a bolt is tight underneath. You can then tighten the risers with a hex driver from the top, and a wrench held on the bolt below.
Here's ours:
I like the idea of bolting a plate to the existing handlebar attachment area (don't know why I didn't do that). It would add a little weight, but would allow easier use of a variety of handlebar mounts, and lower ones, too - just drill four holes in the right place, and any $20 riser set will work.
|
do you have a source (brand) on the risers you used? thanks!
|
|
|