Last night I stay up way later than I should have but I had to fix my belly pan mounting issues before my track day tomorrow. The bottom two bolt holes of the belly pan did not line up with the mounting points on the bike so I had to make my own mounting brackets and drill new holes in the belly pan. I bent mending plates into the shape that would allow me to mount the belly pan to the bike. The last thing I need to do is cut a slot in the belly pan so I can use my kickstand.
Here are the mending plates I used. I purchased them from Home Depot. They come in various sizes.
![](http://i.imgur.com/3JhGB0A.jpg)
Rear Brake Side
![](http://i.imgur.com/4KnhDBv.jpg)
![](http://i.imgur.com/LqoAVSQ.jpg)
Clutch Side
![](http://i.imgur.com/cyJ1uuW.jpg)