Quote:
Originally Posted by Yamahawk
I measured 38mm in length, but I have a question - do you remove the speedometer drive coupler that is held in the wheel with the circlip, and then what is used to keep dust and dirt out of the bearing area? I know the other side has a seal, but this side uses the speedo drive as the seal... so, what did the fellow with the newgen pic in the review of your spacer use, as it looks like some kind of seal used there... Not sure how that would work.
|
Mine is just a little snug, and my spacer is 41.5mm. I did take the speedodrive coupler out, I didn't use a seal. If the bike drove in dirty conditions or for many miles I might worry about it, but with how much I drive the bike I feel fine just keeping the bearing clean, and replacing it when needed.
Edit: This is info for pregen spacers. Not newgen.