ninjette.org - View Single Post - DIY- Removing the Snorkel

headshrink · October 11th, 2009, 11:58 PM

I FINALLY tried this mod this weekend, and while I am still in the "testing phase," it does seem to suddenly suck in the mid range. I'm not sure if there is an improvement high or low yet, as I am still adjusting to the new sound, which may affect the perception of power (like smell does to taste). I do have 2 washers under each needle, so I wonder if I should add a 3rd.... does that sound reasonable?

Since I have tomorrow off, I was planning on drilling the slides too. I know there is no relation between these two mods, but I have noticed that when I try to turn on the power, it spools up like a jet engine.... that is after several commitee meetings and a majority vote. I'm lookin to rectify this too.

October 11th, 2009, 11:58 PM	#75
headshrink ninjette.org certified postwhore Name: Bob Location: CA Join Date: Dec 2008 Motorcycle(s): '08 Ninja 250r, '14 CBR500r Posts: A lot.	I FINALLY tried this mod this weekend, and while I am still in the "testing phase," it does seem to suddenly suck in the mid range. I'm not sure if there is an improvement high or low yet, as I am still adjusting to the new sound, which may affect the perception of power (like smell does to taste). I do have 2 washers under each needle, so I wonder if I should add a 3rd.... does that sound reasonable? Since I have tomorrow off, I was planning on drilling the slides too. I know there is no relation between these two mods, but I have noticed that when I try to turn on the power, it spools up like a jet engine.... that is after several commitee meetings and a majority vote. I'm lookin to rectify this too.