|
Ok checked the front disc for drag. I rode 10 miles and I could easily touch it and keep my hand on it, so it's not dragging right? I thought I was going crazy but I know for sure that it is revving and it is not pulling the way it's suppose to. I idle the bike and removed one of the connections for the coil and the bike dies so I thought it was running on one cylinder but just to be sure I plugged it back it and I did the same to the opposite side and the same thing happened, the bike dies. I remember I did this test before and the bike was still run.
So basically the engine spins and the bike slowly gets up to speed. I notice that when I am in fourth gear or higher and I slowly turn the throttle then it will pull normal. 1st through 3rd gear the bike somewhat pulls but once I get to mid rpm then it just revs and no pull until I shift. And again the bike right perfect until I swapped the fork oil. Pretty sure it irrelevant and just a coincidence but who knows??
94 ninja 250 naked
Air pod filter
Yosh 2:1 full exhaust (yes the rare one)
Just did oil change
Valve adjustment to the loose setting
|