My bad, title says its a ex250
Thanks Triple. That's what the schematic I'm working from shows to Jim, but there is no 4 pin connector on the right hand throttle/switches. Switches are wired into wiring harness & no continuity between the two of them anywhere open or closed.
Took out the sidestand switch years ago by unplugging it & reconnecting the harness side to itself. I'm assuming the neutral safety switch is working because I can make the light go out by shifting in to gear. I also tried temperately shorting the clutch lever switch to no effect.
If you know of a link or have a ex250 wiring schematic I'd luv to see it.
|