Quote:
Originally Posted by GreasedLissik
Then I will just do it, is the crank case need to be lapped as well? I will go through your posts on your page. I have seen a long time ago that someone used thousand grit on a glass table but I Maghreb just use a wood table
|
At the very least lay a piece of well supported glass on the wooden table - a very flat wooden table. 400 - 600 grit should work fine. The gasket should do the final sealing. Make circular swirls over the glass - not just back and forth or up and down. Ghost's on the right track for sure.
Bill
__________________________________________________
Insanity: doing the same thing over and over again expecting different results each time.
Last futzed with by Ram Jet; February 3rd, 2018 at 04:28 PM.
Reason: spelling
|