Quote:
Originally Posted by jkv45
I would say no.
It pulls cleanly, revs fine at high RPMs, and the plugs look good - so I wouldn't change the jetting.
Did it do the same before changing the plugs? There are lots of counterfeit plugs out there that may be total junk.
|
That what I though too it look darn good
I already try swap for brand new set of Autolite 9194 non-resistor but that was still give the same results
If have time tomorrow I'm going recheck the timing mark and lash just make sure it not off 1 teeth.
Really wish I had protable 2ch signal oscilloscopes that would see if there any electrical weirdness going on you know intermittent signal or voltage but that out my wheelhouse for funds right now.