Good to see some of the old basic methods of removing frozen screws are being used...
these new guys would have tried to weld a nut to it ! HAHAHHAH
done right the easy out is by far the easiest method but it does require a straight hole...
and being a pilot jet the hole was already there you just had to enlarge it a bit...so the easy out would fit and start....
.... I've broken all of my small easyouts over the last 50 years so I would have to buy a complete set if I ran into that problem..... or just send it to you LOL
...
Bob.....
__________________________________________________
Its too late when you've gone too far !
|