Almost done with the actual unit that is going on the bike!
Finished the prototype PCB and schematic. Also inserted the chips into the prototype PCB and adjusted the program to suit the new schematic!
This thing isn't very far away from being installed on the bike!
I need to run 5 wires out of the unit. I believe I am going to power the unit from the bike instead of from a battery! Which means I need to go get a voltage regulator and a fuse holder..
I have to finish closing it up in the case and adding protective padding around the PCB, then velcro it onto the dash board and wire it to the bike with those switches I talked about earlier.
sloppy schematic (one or two things might change very slightly)
Quick video of the gauge still working after adjusting the program, number of LED's and squishing the whole thing onto the PCB..
Link to original page on YouTube.