ninjette.org - View Single Post - DIY - Accessing and adjusting idle mixture screws

g21-30 · October 28th, 2010, 04:20 AM

When I did mine, I used the MOS and a self-tapping 1/2" screw. The force of the screw tapping the plug spun the plug out before the screw penetrated more than a 1/16"! And this was done without removing the carbs from the bike.

October 28th, 2010, 04:20 AM	#39
g21-30 ninjette.org certified postwhore Name: Sam Location: Northern Virginia Join Date: Nov 2008 Motorcycle(s): Ninja 250R 2009 and ZX-12R 2000 Posts: A lot.	When I did mine, I used the MOS and a self-tapping 1/2" screw. The force of the screw tapping the plug spun the plug out before the screw penetrated more than a 1/16"! And this was done without removing the carbs from the bike.