Quote:
Originally Posted by Live2ride
there is a heat shield above the pipe / below the seat. If the passenger decided to slide off the back and rest their buns on the hot can then yes, it would burn them . The rear seat sits 2-3 inches above the can as well so that minimizes the heat even more. I don't mind the look without the side fairings much but I feel like it would look cleaner if they were there for obvious reasons. The rear seat needs to be replaced with an oem one because 1 of the 2 po's decided that a cheap leather cover and unevenly cut foam would apparently look better than stock (whoever it was obviously wasn't smart). So far I plan on buying the following:
1) new rear seat (probably $30-$40 at most)
2) side fairings (roughly $150 each in good condition)
3) possibly a new right rearset (since the crack in the current one doesn't seem fixable) ($50-$70)
4) maybe some better looking rear fairings (looks like someone performed the worst rattle can job ever lol) (hopefully not much more than $30-$40)
5) fairing bolts if none come with the fairings I buy. (who cares about the cost; it's to little to worry about $10)
So hopefully I can keep the repair bill below or around $460
|
Cool. It's not very noticeable but it does look a bit "sloppy" without fairings.
Where are you going to post your modifications? Here or another thread?